参数资料
型号: A09-HASM-675
厂商: Digi International/Maxstream
文件页数: 49/71页
文件大小: 0K
描述: ANT 900MHZ 6" R/A JOINT W/RPSMA
标准包装: 25
系列: A09-HASM
天线类型: 鞭状:1/2 波,直角
频带数目: 1
频率: 915MHz(902MHz ~ 928MHz)
增益: 2.1dBi
端子: RP-SMA
安装类型: 连接器
包装: 散装
9XTend? ? OEM ? RF ? Module ?‐? Product ? Manual ? v2.x4x ? [2007.01.04]
Chapter ? 4 ?‐? RF ? Communication ? Modes
Response Packet Delay
As a packet propagates through the repeater network, if any node receives the data and generates
a quick response, the response needs to be delayed so as not to collide with subsequent retrans-
missions of the original packet. To reduce collisions, both repeater and end node radios in a
repeater network will delay transmission of data shifted in the serial port to allow any repeaters
within range to complete their retransmissions.
The time for this delay is computed by the formula:
Maximum Delay (ms) = L * DS
DS = ((-41-(-100))/10)*RN)+RN+1
Where L is the length of the transmitted packet in milliseconds, DS is the number of delay slots to
wait, RSSI is the received signal strength in dBm, and RN is the value of the RN register.
Use Case - Broadcast Repeater Network
Consider modules R1 through R10 each communicating to a PLC using the ModBus protocol and
spaced evenly in a line. All ten modules are configured as 'destinations & repeaters' within the
scope of Basic Broadcast Communications (MD=5, AM, DT=0xFFFF, PK=0x100, RO=0x03,
RB=0x100, RN=1). The Base Host (BH) shifts payload that is destined for R10 to R1. R1 initializes
RF communication and transmits payload to nodes R2 through R5 which are all within range of R1.
The modules R2 through R5 receive the RF packet and retransmit the packet simultaneously. They
also send the data out the serial ports, to the PLCs.
Table ? 4 ‐ 03.
Commands ? used ? to ? configure ? repeater ? functions
AT
Command
AM
DT
MD
MY
RN
WR
Binary
Command
0x3A (58d)
0x00 (0d)
0x3C (60d)
0x2A (42d)
0x19 (25d)
0x08 (8d)
AT Command
Name
Auto-set MY
Destination Address
RF Mode
Source Address
Delay Slots
Write
Range
-
0 - 0xFFFF
0-6
0 - 0xFFFF
0 - 0xFF [slots]
-
# Bytes
Returned
-
2
1
2
1
-
Factory
Default
-
0
0
0xFFFF
0
-
Bandwidth Considerations
Using broadcast repeaters in a network reduces the overall network data throughput as each
repeater must buffer an entire packet before retransmitting it. For example: if the destination is
within range of the transmitter and the packet is 32-bytes long, the transmission will take 12ms on
an XTend module operating at 115,200 baud. If the same packet must propagate through two
repeaters, it will take 12ms to arrive at the first repeater, 12ms to get to the second and a final
12ms to reach the destination for a total of 36ms. Taking into account UART transfer times (~1ms/
byte at 9600 baud), a server to send a 32-byte query and receive a 32-byte response is about
200ms, allowing for 5 polls per second. With the two repeaters in the path, the same query/
response sequence would take about 500ms for 2 polls per second.
Generally, network throughput will decrease by a factor of 1/(R+1), with R representing the num-
ber of repeaters between the source and destination.
? ? 2007 ? MaxStream, ? Inc.
????? 49
相关PDF资料
PDF描述
A09-HSM-7 ANT 900MHZ 7" STRAIGHT W/RPSMA
US5881LUA-AAA-000-BU IC HALL EFFECT SW MP TO-92UA
F1827SD600 MODULE SCR/DIODE 25A 240VAC
US2881EUA-AAA-000-BU IC LATCH CMOS H-SEN TO-92UA
US4881LUA-AAA-000-BU IC LATCH CMOS H-S TO-92UA
相关代理商/技术参数
参数描述
A09-HASM-7 功能描述:ANT HALF WAVE 900MHZ 6" RPSMA M RoHS:是 类别:RF/IF 和 RFID >> RF 天线 系列:- 标准包装:1 系列:*
A09-HBMM-P5I 功能描述:天线 900Mhz 天线 MMCX w/5" pigtail cable RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W
A09-HBSM-P5I 功能描述:天线 915MHz 915MHz7" half unt RPSMA connector RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W
A09-HSM-7 功能描述:天线 915MHz 915MHz6" half Bi non-articulating RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W
A09-HTM-675 功能描述:天线 915MHz 915MHz6" half Bi straight antenna RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W