- 您现在的位置：买卖IC网 > PDF目录21938 > A09-HASM-675 (Digi International/Maxstream)ANT 900MHZ 6" R/A JOINT W/RPSMA PDF资料下载
参数资料
| 型号： | A09-HASM-675 |
| 厂商： | Digi International/Maxstream |
| 文件页数： | 50/71页 |
| 文件大小： | 0K |
| 描述： | ANT 900MHZ 6" R/A JOINT W/RPSMA |
| 标准包装： | 25 |
| 系列： | A09-HASM |
| 天线类型： | 鞭状：1/2 波，直角 |
| 频带数目： | 1 |
| 频率： | 915MHz（902MHz ~ 928MHz） |
| 增益： | 2.1dBi |
| 端子： | RP-SMA |
| 安装类型： | 连接器 |
| 包装： | 散装 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页当前第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页
9XTend? ? OEM ? RF ? Module ?‐? Product ? Manual ? v2.x4x ? [2007.01.04]
Chapter ? 4 ?‐? RF ? Communication ? Modes
4.2.4. Polling Mode (Basic)
NOTE: Polling Mode (Basic) and Polling Mode (Acknowledged) [p53] operate in the same way. The
only difference between the two modes is in their means of achieving reliable delivery of data. In
Polling Mode (Basic), reliable delivery is achieved using multiple transmissions.
Attributes:
Utilizes high percentage of available network bandwidth
Eliminates collisions
Works with reliable delivery (RR or MT parameters)
Supports binary data transfers
Base module requests packets from remote module by polling a sequential
range of addresses
Base module is configured to specify the range of addresses being polled
Uses inter-character delay to create RF packet lengths aligned with protocol
packet lengths up to 2048 bytes long.
Required Parameter Values (Base): MD (RF Mode) = 3, PB (Polling Begin Address), PE (Polling
End Address)
Required Parameter Value (Remote): MD (RF Mode) = 4
Related Commands: Networking (MT, PD, DT, MY, AM)
Constraints: The minimum time interval between polling cycles is configurable. However, if the
remote modules cannot all be processed within that time interval, the polling cycle is ineffective
(i.e. it will impose no additional delay). In order to ensure a pause between polling cycles, PD
must be set to a value which is large enough to accommodate the pause.
Recommended Use: Use for point-to-multipoint applications that require Reliable Delivery of
data. Use this mode when it is critical that a base module be able to discern data coming from
multiple modules.
Theory of Operation
A ‘Polling Base’ module will cycle through a sequential range of addresses. The ‘Polling Base’ will
poll each ‘Polling Remote’ module, wait for a response, then poll the next remote address in the
sequence. Each ‘Polling Remote’ will respond by sending the data from its DI (Data In) buffer fol-
lowing the RB (Packetization Threshold) & RO (Packetization Timeout) parameters. When there is
no eligible data to send, the ‘Polling Remote’ will not respond. The ‘Polling Base’ will poll the next
address in the polling sequence after a short delay.
Polling Base Configuration:
Set the MD (RF Mode) parameter (MD = 3).
Set MY (Source Address) parameter (MY = 0).
Set the sequential range of Polling Addresses using the PB (Polling Begin Address) and PE
(Polling End Address) parameters.
(Optional) Enable Basic Reliable Delivery (MT >= 0). Note: Acknowledged Reliable Delivery is
also supported. Refer to the ‘Polling Mode - Acknowledged’ section for more information.
(Optional) Use the PD (Minimum Polling Delay) command to configure a delay between polls to
slow down system (if needed).
(Optional) Enable API Mode to address remotes within polling range on a packet-by-packet
basis.
Polling Remote Configuration:
Set the MD (RF Mode) parameter (MD = 4).
Configure sequential source addresses for all remote modules using the MY (Source Address)
command.
Set the DT (Destination Address) parameter to point to ‘Polling Base’ (DT = 0x0000).
(Optional) Enable Basic Reliable Delivery (MT >= 0). Note: Acknowledged Reliable Delivery is
also supported. Refer to the ‘Polling Mode - Acknowledged’ section for more information.
? ? 2007 ? MaxStream, ? Inc.
????? 50
相关PDF资料 |
PDF描述 |
|---|---|
| A09-HSM-7 | ANT 900MHZ 7" STRAIGHT W/RPSMA |
| US5881LUA-AAA-000-BU | IC HALL EFFECT SW MP TO-92UA |
| F1827SD600 | MODULE SCR/DIODE 25A 240VAC |
| US2881EUA-AAA-000-BU | IC LATCH CMOS H-SEN TO-92UA |
| US4881LUA-AAA-000-BU | IC LATCH CMOS H-S TO-92UA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| A09-HASM-7 | 功能描述:ANT HALF WAVE 900MHZ 6" RPSMA M RoHS:是 类别:RF/IF 和 RFID >> RF 天线 系列:- 标准包装:1 系列:* |
| A09-HBMM-P5I | 功能描述:天线 900Mhz 天线 MMCX w/5" pigtail cable RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W |
| A09-HBSM-P5I | 功能描述:天线 915MHz 915MHz7" half unt RPSMA connector RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W |
| A09-HSM-7 | 功能描述:天线 915MHz 915MHz6" half Bi non-articulating RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W |
| A09-HTM-675 | 功能描述:天线 915MHz 915MHz6" half Bi straight antenna RoHS:否 制造商:Molex 技术类型:Cellular Antenna 频率: 带宽: 尺寸:106.7 mm L x 13 mm W |
发布紧急采购，3分钟左右您将得到回复。