参数资料
型号: AD73311
厂商: Analog Devices, Inc.
英文描述: Low Cost, Low Power CMOS General Purpose Analog Front End Processor(低成本、低功耗、CMOS通用模拟前端处理器)
中文描述: 低成本,低功耗CMOS通用模拟前端处理器(低成本,低功耗,的CMOS通用模拟前端处理器)
文件页数: 28/36页
文件大小: 290K
代理商: AD73311
AD73311
–28–
REV. A
APPENDIX A
Programming a Single AD73311 for Data Mode Operation
This section describes a typical sequence in programming a
single codec to operate in normal DATA mode. It details the
control (program) words that are sent to the device to configure
its internal registers and shows the typical output data received
during both program and data modes. The device is connected
in Frame Sync Loop-Back Mode (see Figure 13), which forces
an input word from the DSP’s Tx Reg each time the codec
outputs a word via the SDO/SDOFS lines. In Step 1, the part
has just been reset and on the first output event the codec pre-
sents an invalid output word
1
. The DSP’s Tx Reg contains a
DSP TX REG
CONTROL WORD 1
1 0 000 001 00000011
ADC WORD 1 *
0000 0000 0000 0000
DON'T CARE
XXXX XXXX XXXX XXXX
DSP RX REG
STEP 1
DSP TX REG
CONTROL WORD 1
1 0 000 010 00000001
DEVICE 1
CONTROL WORD 1
1 0 000 001 00000011
ADC WORD 1 *
0000 0000 0000 0000
DSP RX REG
STEP 2
DSP TX REG
CONTROL WORD 1
1 0 000 010 00000001
DEVICE 1
ADC WORD 1 *
1011 1001 0000 0011
DON'T CARE
XXXX XXXX XXXX XXXX
DSP RX REG
STEP 3
DSP TX REG
DEVICE 1
CONTROL WORD 1
1 0 000 010 00000001
CONTROL WORD 1
1 0 000 000 00000001
ADC WORD 1 *
1011 1001 0000 0011
DSP RX REG
STEP 4
DSP TX REG
CONTROL WORD 1
1 0 000 000 00000001
DEVICE 1
ADC WORD 1 *
1011 1010 0000 0001
DON'T CARE
XXXX XXXX XXXX XXXX
DSP RX REG
STEP 5
DSP TX REG
DEVICE 1
CONTROL WORD 1
1 0 000 000 00000001
DAC WORD 1
0111 1111 1111 1111
ADC WORD 1 *
1011 1010 0000 0001
DSP RX REG
STEP 6
DSP TX REG
DAC WORD 1
0111 1111 1111 1111
ADC WORD 1
1000 0000 0000 0000
DON'T CARE
XXXX XXXX XXXX XXXX
DSP RX REG
STEP 7
DSP TX REG
DEVICE 1
DAC WORD 1
0111 1111 1111 1111
DAC WORD 1
0111 1111 1111 1111
ADC WORD 1
1000 0000 0000 0000
DSP RX REG
STEP 8
*ADC SAMPLES DURING PROGRAM MODE ARE INVALID.
DEVICE 1
DEVICE 1
Figure 33. Programming a Single AD73311 for Normal
control word that programs CRB with the data word 0x03. In
Step 2, the control word from the DSP’s Tx Reg has been sent
to the codec’s SPORT and the output word has been received
by the DSP’s Rx Reg. In Steps 3 and 4, register CRC is pro-
grammed with 0x01, which powers up the analog section. In
Steps 5 and 6, the codec is put into programming mode by
setting the
PGM
/DATA bit of CRA. In Step 7, the output word
from the device is now a valid ADC word as the device has been
programmed into data mode. Note also that the codec now
expects DAC data to be sent to it and will interpret any data
from the DSP to be 16-bit DAC data.
NOTE
1
Data output by the codec in program mode is invalid and should not be inter-
preted as ADC data. The only exception to this is output caused by register
reads or CEE being enabled on control word writes.
相关PDF资料
PDF描述
AD73322LARU Low Cost, Low Power CMOS General-Purpose Dual Analog Front End
AD73322AR Low Cost, Low Power CMOS General-Purpose Dual Analog Front End
AD73322AST Low Cost, Low Power CMOS General-Purpose Dual Analog Front End
AD73322LAR Low Cost, Low Power CMOS General-Purpose Dual Analog Front End
AD73322LAST Low Cost, Low Power CMOS General-Purpose Dual Analog Front End
相关代理商/技术参数
参数描述
AD73311AR 制造商:Analog Devices 功能描述:Audio Codec 1ADC / 1DAC 16-Bit 20-Pin SOIC W 制造商:Rochester Electronics LLC 功能描述:SPEECH & TELEPHONY CODEC I.C. - Bulk 制造商:Analog Devices 功能描述:SPEECH/TELEPHONY CODEC SMD 73311
AD73311AR-REEL 制造商:Analog Devices 功能描述:Audio Codec 1ADC / 1DAC 16-Bit 20-Pin SOIC W T/R
AD73311ARS 制造商:Analog Devices 功能描述:Audio Codec 1ADC / 1DAC 16-Bit 20-Pin SSOP
AD73311ARS-REEL 制造商:Analog Devices 功能描述:Audio Codec 1ADC / 1DAC 16-Bit 20-Pin SSOP T/R 制造商:Rochester Electronics LLC 功能描述:SPEECH & TELEPHONY CODEC I.C. - Tape and Reel
AD73311ARSZ 功能描述:IC ANALOG FRONT END 20-SSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模拟前端 (AFE) 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- 位数:- 通道数:2 功率(瓦特):- 电压 - 电源,模拟:3 V ~ 3.6 V 电压 - 电源,数字:3 V ~ 3.6 V 封装/外壳:32-VFQFN 裸露焊盘 供应商设备封装:32-QFN(5x5) 包装:带卷 (TR)