- 您现在的位置：买卖IC网 > PDF目录10300 > AD7707BRZ-REEL (Analog Devices Inc)IC ADC 16BIT 3CHAN 20SOIC PDF资料下载
参数资料
| 型号： | AD7707BRZ-REEL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 50/52页 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT 3CHAN 20SOIC |
| 标准包装： | 1,000 |
| 位数： | 16 |
| 采样率（每秒）： | 500 |
| 数据接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 1mW |
| 电压电源： | 模拟和数字 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 20-SOIC W |
| 包装： | 带卷 (TR) |
| 输入数目和类型： | 1 个单端，单极；1 个单端，双极；2 个伪差分，单极；2 个伪差分，双极 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页当前第50页第51页第52页
AD7707
Rev. B | Page 7 of 52
Parameter
B Version1
Unit
Conditions/Comments
Normal Mode Power Dissipation17
AVDD = DVDD = 3 V; digital inputs = 0 V or DVDD; external
MCLK IN excluding dissipation in the AIN3 attenuator
1.05
mW max
Typically 0.84 mW; BUF = 0; fCLKIN = 1 MHz, all gains
2.04
mW max
Typically 1.53 mW; BUF = 1; fCLK IN = 1 MHz; all gains
1.35
mW max
Typically 1.11 mW; BUF = 0; fCLK IN = 2.4576 MHz,
gain = 1 to 4
2.34
mW max
Typically 1.9 mW; BUF = 1; fCLK IN = 2.457 6 MHz;
gain = 1 to 4
Normal Mode Power Dissipation17
AVDD = DVDD = 5 V; digital inputs = 0 V or DVDD;
external MCLKIN
2.1
mW max
Typically 1.75 mW; BUF = 0; fCLKIN = 1 MHz; all gains
3.75
mW max
Typically 2.9 mW; BUF = 1; fCLKIN = 1 MHz; all gains
3.1
mW max
Typically 2.6 mW; BUF = 0; fCLK IN = 2.4576 MHz
4.75
mW max
Typically 3.75 mW; BUF = 1; fCLK IN = 2.4576 MHz
18
μA max
External MCLK IN = 0 V or DVDD; typically 9 μA;
AVDD = 5 V
8
μA max
External MCLK IN = 0 V or DVDD; typically 4 μA;
AVDD = 3 V
1 Temperature range as follows: B Version, 40°C to +85°C.
2 These numbers are established from characterization or design at initial product release.
3 A calibration is effectively a conversion so these errors are of the order of the conversion noise shown in Table 7 and Table 9 for the low level input channels AIN1 and
AIN2. This applies after calibration at the temperature of interest.
4 Recalibration at any temperature removes these drift errors.
5 Positive full-scale error includes zero-scale errors (unipolar offset error or bipolar zero error) and applies to both unipolar and bipolar input ranges.
6 Full-scale drift includes zero-scale drift (unipolar offset drift or bipolar zero drift) and applies to both unipolar and bipolar input ranges.
7 Gain error does not include zero-scale errors. It is calculated as full-scale error—unipolar offset error for unipolar ranges and full-scale error—bipolar zero error for
bipolar ranges.
8 Gain error drift does not include unipolar offset drift/bipolar zero drift. It is effectively the drift of the part if
zero-scale calibrations were performed.
9 Error is removed following a system calibration.
10 This common-mode voltage range is allowed provided that the input voltage on analog inputs does not go more positive than AVDD + 30 mV or go more negative
than AGND 100 mV. Parts are functional with voltages down to AGND 200 mV, but with increased leakage at high temperature.
11 The analog input voltage range on AIN(+) is given here with respect to the voltage on LCOM on the low level input channels (AIN1 and AIN2) and is given with
respect to the HCOM input on the high level input channel, AIN3. The absolute voltage on the low level analog inputs should not go more positive than AVDD +
100 mV, or go more negative than GND 100 mV for specified performance. Input voltages of AGND 200 mV can be accommodated, but with increased leakage at
high temperature.
12 VREF = REF IN(+) REF IN().
13 These logic output levels apply to the MCLK OUT only when it is loaded with one CMOS load.
14 Sample tested at +25°C to ensure compliance.
15 After calibration, if the analog input exceeds positive full scale, the converter outputs all 1s. If the analog input is less than negative full scale, the device outputs all 0s.
16 These calibration and span limits apply provided that the absolute voltage on the analog inputs does not exceed AVDD + 30 mV or go more negative than AGND
mV. The offset calibration limit applies to both the unipolar zero point and the bipolar zero point.
17 When using a crystal or ceramic resonator across the MCLK pins as the clock source for the device, the DVDD current and power dissipation varies depending on the
crystal or resonator type (see the Clocking and Oscillator Circuit section).
18 Measured at dc and applies in the selected pass band. PSRR at 50 Hz exceeds 120 dB with filter notches of 25 Hz or 50 Hz. PSRR at 60 Hz exceeds 120 dB with filter
notches of 20 Hz or 60 Hz.
20 If the external master clock continues to run in standby mode, the standby current increases to 150 μA typical at 5 V and 75 μA typical at 3 V. When using a crystal or
ceramic resonator across the MCLK pins as the clock source for the device, the internal oscillator continues to run in standby mode and the power dissipation depends
on the crystal or resonator type (see the Standby Mode section).
Table 2. Low Level Input Channels, AIN1 and AIN2
Gain
1
2
4
8 to 128
AVDD = 3 V
86
78
85
93
AVDD = 5 V
90
78
84
91
Table 3. High Level Input Channel, AIN3
Gain
1
2
4
8 to 128
AVDD = 3 V
68
60
67
75
AVDD = 5 V
72
60
66
73
相关PDF资料 |
PDF描述 |
|---|---|
| MS27468T25B46B | CONN HSG RCPT 46POS JAMNUT SCKT |
| LTC2366CS6#TRPBF | IC ADC 12BIT 3MSPS TSOT23-6 |
| LTC1404IS8#PBF | IC A/D CONV 12BIT W/SHTDN 8-SOIC |
| MS27468E25B46B | CONN HSG RCPT 46POS JAMNUT SCKT |
| LTC1404IS8 | IC A/D CONV 12BIT W/SHTDN 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD7707BRZ-REEL7 | 功能描述:IC ADC 16BIT 3CHAN 20SOIC RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| AD7707EB | 制造商:AD 制造商全称:Analog Devices 功能描述:3 V/5 V 610 V Input Range 1 mW 3-Channel 16-Bit Sigma-Delta ADC(316.51 k) |
| AD7708 | 制造商:AD 制造商全称:Analog Devices 功能描述:8-/10-Channel, Low Voltage, Low Power, ADCs |
| AD7708BR | 功能描述:IC ADC 16BIT R-R 8/10CH 28-SOIC RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
| AD7708BR-REEL | 功能描述:IC ADC 16BIT R-R 8/10CH 28-SOIC RoHS:否 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1,000 系列:- 位数:16 采样率（每秒）:45k 数据接口:串行 转换器数目:2 功率耗散（最大）:315mW 电压电源:模拟和数字 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:28-SOIC（0.295"，7.50mm 宽） 供应商设备封装:28-SOIC W 包装:带卷 (TR) 输入数目和类型:2 个单端，单极 |
发布紧急采购，3分钟左右您将得到回复。