- 您现在的位置：买卖IC网 > PDF目录10307 > AD7795BRUZ-REEL (Analog Devices Inc)IC ADC 16BIT 6CH LOW-PWR 24TSSOP PDF资料下载
参数资料
| 型号： | AD7795BRUZ-REEL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 26/37页 |
| 文件大小： | 0K |
| 描述： | IC ADC 16BIT 6CH LOW-PWR 24TSSOP |
| 标准包装： | 2,500 |
| 位数： | 16 |
| 采样率（每秒）： | 470 |
| 数据接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 转换器数目： | 1 |
| 功率耗散（最大）： | 2.5mW |
| 电压电源： | 模拟和数字 |
| 工作温度： | -40°C ~ 105°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 24-TSSOP |
| 包装： | 带卷 (TR) |
| 输入数目和类型： | 6 个差分，单极；6 个差分，双极 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页
AD7794/AD7795
Rev. D | Page 31 of 36
CIRCUIT DESCRIPTION
ANALOG INPUT CHANNEL
The AD7794/AD7795 have six differential analog input
channels. These are connected to the on-chip buffer amplifier
when the devices are operated in buffered mode. When in
unbuffered mode, the channels connect directly to the
modulator. In buffered mode (the BUF bit in the configuration
register is set to 1), the input channel feeds into a high
impedance input stage of the buffer amplifier. Therefore, the
input can tolerate significant source impedances and is tailored
for direct connection to external resistive-type sensors such as
strain gages or resistance temperature detectors (RTDs).
When BUF = 0, the parts operate in unbuffered mode. This
results in a higher analog input current. Note that this
unbuffered input path provides a dynamic load to the driving
source. Therefore, resistor/capacitor combinations on the input
pins can cause gain errors, depending on the output impedance
of the source that is driving the ADC input. Table 22 shows the
allowable external resistance/capacitance values for unbuffered
mode so that no gain error at the 20-bit level is introduced.
Table 22. External R-C Combination for 20-Bit No Gain Error
Capacitance (pF)
Resistance (Ω)
50
9 k
100
6 k
500
1.5 k
1000
900
5000
200
The AD7794/AD7795 can be operated in unbuffered mode
only when the gain equals 1 or 2. At higher gains, the buffer
is automatically enabled. The absolute input voltage range in
buffered mode is restricted to a range between GND + 100 mV
and AVDD 100 mV. When the gain is set to 4 or higher, the
in-amp is enabled. The absolute input voltage range when the in-
amp is active is restricted to a range between GND + 300 mV and
AVDD 1.1 V. Care must be taken in setting up the common-
mode voltage so that these limits are not exceeded. Otherwise,
there is degradation in linearity and noise performance.
The absolute input voltage in unbuffered mode includes the
range between GND 30 mV and AVDD + 30 mV as a result of
being unbuffered. The negative absolute input voltage limit does
allow the possibility of monitoring small, true bipolar signals
with respect to GND.
INSTRUMENTATION AMPLIFIER
Amplifying the analog input signal by a gain of 1 or 2 is
performed digitally within the AD7794/AD7795. However,
when the gain equals 4 or higher, the output from the buffer is
applied to the input of the on-chip instrumentation amplifier.
This low noise in-amp means that signals of small amplitude
can be gained within the AD7794/AD7795 while still
maintaining excellent noise performance. For example, when
the gain is set to 64, the rms noise is 40 nV typically, which is
equivalent to 21 bits effective resolution or 18.5 bits peak-to-
peak resolution.
Each AD7794/AD7795 can be programmed to have a gain of 1,
2, 4, 8, 16, 32, 64, and 128 using Bit G2 to Bit G0 in the
configuration register. Therefore, with an external 2.5 V
reference, the unipolar ranges are from 0 mV to 20 mV to 0 V
to 2.5 V and the bipolar ranges are from ±20 mV to ±2.5 V.
When the in-amp is active (gain ≥ 4), the common-mode
voltage ((AIN(+) + AIN())/2) must be greater than or equal to
0.5 V when chop is enabled. With chop disabled, and with the
AMP-CM bit set to 1 to prevent degradation in the common-
mode rejection, the allowable common-mode voltage is limited
to between
0.2 + (Gain/2 × (AIN(+) AIN()))
and
AVDD 0.2 (Gain/2 × (AIN(+) AIN()))
If the AD7794/AD7795 are operated with an external reference
that has a value equal to AVDD, for correct operation, the analog
input signal must be limited to 90% of VREF/gain when the in-
amp is active.
BIPOLAR/UNIPOLAR CONFIGURATION
The analog input to the AD7794/AD7795 can accept either
unipolar or bipolar input voltage ranges. A bipolar input range
does not imply that the parts can tolerate negative voltages with
respect to system GND. Unipolar and bipolar signals on the
AIN(+) input are referenced to the voltage on the AIN() input.
For example, if AIN() is 2.5 V and the ADC is configured for
unipolar mode with a gain of 1, the input voltage range on the
AIN(+) pin is 2.5 V to 5 V.
If the ADC is configured for bipolar mode, the analog input
range on the AIN(+) input is 0 V to 5 V. The bipolar/unipolar
option is chosen by programming the U/B bit in the
configuration register.
相关PDF资料 |
PDF描述 |
|---|---|
| 14292-20PG-300 | CONN RCPT 20POS PNL MNT PIN |
| MS27466T15F5SC | CONN RCPT 5POS WALL MT W/SCKT |
| CXC3102A14S2S | CONN RCPT 4POS PNL MNT SKT |
| VE-BNX-IW-B1 | CONVERTER MOD DC/DC 5.2V 100W |
| AD9281ARSRL | IC ADC 8BIT DUAL CMOS 28-SSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD7795BRUZ-REEL1 | 制造商:AD 制造商全称:Analog Devices 功能描述:6-Channel, Low Noise, Low Power, 24-/16-Bit ?￡-?? ADC with On-Chip In-Amp and Reference |
| AD7796 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Power, 16-/24-Bit Sigma-Delta ADC for Bridge Sensors |
| AD7796BRUZ | 功能描述:IC ADC 16BIT SIG-DEL 1CH 16TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:1 系列:microPOWER™ 位数:8 采样率（每秒）:1M 数据接口:串行，SPI? 转换器数目:1 功率耗散（最大）:- 电压电源:模拟和数字 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:24-VFQFN 裸露焊盘 供应商设备封装:24-VQFN 裸露焊盘（4x4） 包装:Digi-Reel® 输入数目和类型:8 个单端，单极 产品目录页面:892 (CN2011-ZH PDF) 其它名称:296-25851-6 |
| AD7796BRUZ-REEL | 功能描述:IC ADC 16BIT SIG-DEL 1CH 16TSSOP RoHS:是 类别:集成电路 (IC) >> 数据采集 - 模数转换器 系列:- 标准包装:2,500 系列:- 位数:16 采样率（每秒）:15 数据接口:MICROWIRE?，串行，SPI? 转换器数目:1 功率耗散（最大）:480µW 电压电源:单电源 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:38-WFQFN 裸露焊盘 供应商设备封装:38-QFN（5x7） 包装:带卷 (TR) 输入数目和类型:16 个单端，双极；8 个差分，双极 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494 |
| AD7797 | 制造商:AD 制造商全称:Analog Devices 功能描述:Low Power, 16-/24-Bit Sigma-Delta ADC for Bridge Sensors |
发布紧急采购，3分钟左右您将得到回复。