- 您现在的位置：买卖IC网 > PDF目录298893 > BXM80526B700 (INTEL CORP) 64-BIT, 700 MHz, MICROPROCESSOR, CPGA495 PDF资料下载
参数资料
| 型号： | BXM80526B700 |
| 厂商： | INTEL CORP |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 64-BIT, 700 MHz, MICROPROCESSOR, CPGA495 |
| 封装： | MICRO, PGA2-495 |
| 文件页数： | 7/85页 |
| 文件大小： | 795K |
| 代理商： | BXM80526B700 |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页
Mobile Intel Pentium III Processor in BGA2 and Micro-PGA2 Packages
at 850 MHz, 800 MHz, 750 MHz, 700 MHz, and Low-voltage 600 MHz
Order#-XXX
Datasheet
7
2.2 Power Management
2.2.1 Clock Control Architecture
The mobile Pentium III processor clock control architecture (Figure 3) has been optimized for
leading edge deep green desktop and mobile computer designs. The clock control architecture
consists of seven different clock states: Normal, Stop Grant, Auto Halt, Quick Start, HALT/Grant
Snoop, Sleep, and Deep Sleep states. The Auto Halt state provides a low-power clock state that
can be controlled through the software execution of the HLT instruction. The Quick Start state
provides a very low power and low exit latency clock state that can be used for hardware
controlled “idle” computer states. The Deep Sleep state provides an extremely low-power state
that can be used for “Power-On-Suspend” computer states, which is an alternative to shutting off
the processor’s power. Compared to the Pentium processor exit latency of 1 msec, the exit latency
of the Deep Sleep state has been reduced to 30
sec in the mobile Pentium III processor. The Stop
Grant and Sleep states shown in Figure 3 are intended for use in “Deep Green” desktop and server
systems — not in mobile systems. Performing state transitions not shown in Figure 3 is neither
recommended nor supported.
The Stop Grant and Quick Start clock states are mutually exclusive, i.e., a strapping option on
signal A15# chooses which state is entered when the STPCLK# signal is asserted. The Quick Start
state is enabled by strapping the A15# signal to ground at Reset; otherwise, asserting the
STPCLK# signal puts the processor into the Stop Grant state. The Stop Grant state has a higher
power level than the Quick Start state and is designed for Symmetric Multi-Processing (SMP)
platforms. The Quick Start state has a much lower power level, but it can only be used in
uniprocessor platforms. Table 3 provides clock state characteristics, which are described in detail
in the following sections.
2.2.2 Normal State
The Normal state of the processor is the normal operating mode where the processor’s core clock
is running and the processor is actively executing instructions.
2.2.3 Auto Halt State
This is a low-power mode entered by the processor through the execution of the HLT instruction.
The power level of this mode is similar to the Stop Grant state. A transition to the Normal state is
made by a halt break event (one of the following signals going active: NMI, INTR, BINIT#,
INIT#, RESET#, FLUSH#, or SMI#).
Asserting the STPCLK# signal while in the Auto Halt state will cause the processor to transition
to the Stop Grant or Quick Start state, where a Stop Grant Acknowledge bus cycle will be issued.
Deasserting STPCLK# will cause the processor to return to the Auto Halt state without issuing a
new Halt bus cycle.
The SMI# interrupt is recognized in the Auto Halt state. The return from the System Management
Interrupt (SMI) handler can be to either the Normal state or the Auto Halt state. See the Intel
Architecture Software Developer’s Manual, Volume III: System Programmer’s Guide for more
information. No Halt bus cycle is issued when returning to the Auto Halt state from the System
Management Mode (SMM).
The FLUSH# signal is serviced in the Auto Halt state. After the on-chip and off-chip caches have
been flushed, the processor will return to the Auto Halt state without issuing a Halt bus cycle.
相关PDF资料 |
PDF描述 |
|---|---|
| BXM80536GC2100F | 32-BIT, 2100 MHz, MICROPROCESSOR, CPGA478 |
| BXM80536GC1800F | 32-BIT, 1800 MHz, MICROPROCESSOR, CPGA478 |
| BXM80536GC1600F | 32-BIT, 1600 MHz, MICROPROCESSOR, CPGA478 |
| BYP60K4 | 60 A, 400 V, SILICON, RECTIFIER DIODE |
| BYS10-45TR3 | 1.5 A, 45 V, SILICON, RECTIFIER DIODE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BXM80536NC1400ES L7LS | 制造商:Intel 功能描述:CELERON M,360,1.40GHZ,1M CACHE, 400MHZ FSB,1.26V,UFCPGA - Boxed Product (Development Kits) |
| BXMP1000 | 制造商:SPECTRUM 制造商全称:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
| BXMP1001 | 制造商:SPECTRUM 制造商全称:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
| BXMP1002 | 制造商:SPECTRUM 制造商全称:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
| BXMP1003 | 制造商:SPECTRUM 制造商全称:Spectrum Microwave, Inc. 功能描述:RF AMPLIFIER |
发布紧急采购，3分钟左右您将得到回复。