参数资料
| 型号： | CAT25512YI-GT3 |
| 厂商： | ON Semiconductor |
| 文件页数： | 9/16页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 512KB SPI SER 8-TSSOP |
| 标准包装： | 1 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 512K (64K x 8) |
| 速度： | 20MHz |
| 接口： | SPI 3 线串行 |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 标准包装 |
| 其它名称： | CAT25512YI-GT3OSDKR |
CAT25512
READ OPERATIONS
Read from Memory Array
To read from memory, the host sends a READ instruction
followed by a 16 ? bit address.
After receiving the last address bit, the CAT25512 will
respond by shifting out data on the SO pin (as shown in
Figure 9). Sequentially stored data can be read out by simply
continuing to run the clock. The internal address pointer is
automatically incremented to the next higher address as data
is shifted out. After reaching the highest memory address,
the address counter “rolls over” to the lowest memory
address, and the read cycle can be continued indefinitely.
The read operation is terminated by taking CS high.
Read Identification Page
Reading the additional 128 ? byte Identification Page (IP)
is achieved using the same Read command sequence as used
for Read from main memory array (Figure 9). The IPL bit
from the Status Register must be set (IPL = 1) before
attempting to read from the IP. The [A6:A0] are the address
significant bits that point to the data byte shifted out on the
SO pin. If the CS continues to be held low, the internal
address register defined by [A6:A0] bits is automatically
CS
incremented and the next data byte from the IP is shifted out.
The byte address must not exceed the 128 ? byte page
boundary.
Read Status Register
To read the status register, the host simply sends a RDSR
command. After receiving the last bit of the command, the
CAT25512 will shift out the contents of the status register on
the SO pin (Figure 10). The status register may be read at
any time, including during an internal write cycle.
While the internal write cycle is in progress, the RDSR
command will output the full content of the status register.
For easy detection of the internal write cycle completion,
during writing to the memory array we recommend
sampling the RDY bit only through the polling routine.
After detecting the RDY bit “0”, the next RDSR instruction
will always output the expected content of the status register.
Note: During writing to the status register (WRSR) we
recommend to avoid the polling routine and do insert a
fixed delay of 5 ms to allow the internal write cycle to
complete.
0
1
2
3
4
5
6
7
8
9
10
20 21
22 23
24
25
26 27
28 29
30
SCK
OPCODE
BYTE ADDRESS*
SI
0
0
0
0
0
0
1
1
A N
A 0
SO
HIGH IMPEDANCE
7
6
5
DATA OUT
4 3 2
1
0
CS
Dashed Line = mode (1, 1)
* Please check the Byte Address Table (Table 11)
Figure 9. READ Timing
MSB
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
SCK
OPCODE
SI
0
0
0
0
0
1
0
1
SO
HIGH IMPEDANCE
7
6
5
4
DATA OUT
3
2
1
0
Dashed Line = mode (1, 1)
MSB
Figure 10. RDSR Timing
http://onsemi.com
9
相关PDF资料 |
PDF描述 |
|---|---|
| RBB108DHAD | CONN EDGECARD 216PS R/A .050 DIP |
| HSC49DRYI | CONN EDGECARD 98POS DIP .100 SLD |
| ASC50DRTN | CONN EDGECARD 100PS .100 DIP SLD |
| CAT25512VI-GT3 | IC EEPROM 512KB SPI SER 8-SOIC |
| ASC50DRTH | CONN EDGECARD 100PS .100 DIP SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CAT25-513JA | 功能描述:电阻器网络与阵列 51K 5% Concave 8resistors RoHS:否 制造商:Vishay/Thin Film 产品类型:Networks 电路类型:Divider 电阻器数量: 电阻数值:10 kOhms 容差:0.1 % 温度系数: 管脚数量:3 工作温度范围:- 55 C to + 155 C 尺寸:1.02 mm W x 3.05 mm L x 1.4 mm H 引线间隔: 端接类型:SMD/SMT 封装:Reel |
| CAT25-513JALF | 功能描述:电阻器网络与阵列 51K 5% Concave 8resistors RoHS:否 制造商:Vishay/Thin Film 产品类型:Networks 电路类型:Divider 电阻器数量: 电阻数值:10 kOhms 容差:0.1 % 温度系数: 管脚数量:3 工作温度范围:- 55 C to + 155 C 尺寸:1.02 mm W x 3.05 mm L x 1.4 mm H 引线间隔: 端接类型:SMD/SMT 封装:Reel |
| CAT25-560JA | 功能描述:电阻器网络与阵列 56ohm 5% Concave 8resistors RoHS:否 制造商:Vishay/Thin Film 产品类型:Networks 电路类型:Divider 电阻器数量: 电阻数值:10 kOhms 容差:0.1 % 温度系数: 管脚数量:3 工作温度范围:- 55 C to + 155 C 尺寸:1.02 mm W x 3.05 mm L x 1.4 mm H 引线间隔: 端接类型:SMD/SMT 封装:Reel |
| CAT25-560JALF | 功能描述:电阻器网络与阵列 56ohm 5% Concave 8resistors RoHS:否 制造商:Vishay/Thin Film 产品类型:Networks 电路类型:Divider 电阻器数量: 电阻数值:10 kOhms 容差:0.1 % 温度系数: 管脚数量:3 工作温度范围:- 55 C to + 155 C 尺寸:1.02 mm W x 3.05 mm L x 1.4 mm H 引线间隔: 端接类型:SMD/SMT 封装:Reel |
| CAT25-561JA | 功能描述:电阻器网络与阵列 560ohm 5% Concave 8resistors RoHS:否 制造商:Vishay/Thin Film 产品类型:Networks 电路类型:Divider 电阻器数量: 电阻数值:10 kOhms 容差:0.1 % 温度系数: 管脚数量:3 工作温度范围:- 55 C to + 155 C 尺寸:1.02 mm W x 3.05 mm L x 1.4 mm H 引线间隔: 端接类型:SMD/SMT 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。