参数资料
型号: DR-TRC103-915-EV
厂商: RFM
文件页数: 14/65页
文件大小: 0K
描述: BOARD EVALUATION 915MHZ RFM RFIC
标准包装: 1
类型: 收发器,SRR
频率: 902MHz ~ 928MHz
适用于相关产品: TRC103-915
已供物品: 2 个板,天线,电池
Data and clock recovery is enabled by default. It is controlled by RXCFG12_DCLK_Dis[6] . If data and clock re-
covery is disabled, the output of the demodulator is directed to DATA and the DCLK output (IRQ1 Pin in continu-
ous mode) is set to 0.
The received bit rate is defined by the value of the MCFG03_Bit_Rate[6..0] configuration register, and is calcu-
lated as follows:
BR = F XTAL /(64*(D + 1)), with D in the range of 0 to 127
with BR the bit rate in kb/s, F XTAL the crystal frequency in kHz, and D the value in MCFG03_Bit_Rate[6..0] . For
example, using a 12.8 MHz crystal (12,800 kHz), the bit rate is 25 kb/s when D = 7.
3.3 Continuous Mode Start Pattern Recognition
Start pattern detection (recognition) is activated by setting the RXCFG12_Recog[5] bit to 1. The demodulated
signal is compared with a pattern stored in the SYNCFG registers. The Start Pattern Detect (PATTERN) signal,
mapped to output pin IRQ0, is driven by the output of this comparator and is synchronized by DCLK. It is set to 1
when a start pattern match is detected, otherwise it is set to 0. The Start Pattern Detect output is updated at the
rising edge of DCLK. The number of bytes used for comparison is defined in the RXCFG12_Pat_sz[4..3] register
and the number of tolerated bit errors for the pattern detection is defined in the RXCFG12_Ptol[2..1] register.
Figure 9 illustrates the pattern detection process.
S ta r t P a tte r n D e te c tio n T im in g
D A T A
B it 0
B it 1
B it N -1
B it N
B it N + 1
D C L K
P A T T E R N
D E T E C T
Figure 9
Note that start pattern detection is enabled only if data and clock recovery is enabled.
3.4 RSSI
The received signal strength is measured in the amplifier chains behind the second mixers. Each amplifier chain
is composed of 11 amplifiers each having a gain of 6 dB and an intermediate output at 3 dB. By monitoring the
two outputs of each stage, an estimation of the signal strength with a resolution of 3 dB and a dynamic range of
63 dB is obtained without IF gain compensation. This estimation is performed 16 times over a period of the I and
Q signals and the 16 samples are averaged to obtain a final RSSI value with a 0.5 dB step. The period of the I
and Q signal is the inverse of the deviation frequency, which is the low-IF frequency in OOK mode. The RSSI
effective dynamic range can be increased to 70 dB by adjusting MCFG01_IF_Gain[1..0] for less gain on high
signal levels.
www.RFM.com E-mail: info@rfm.com
? 2009-2010 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 14 of 65
TRC103 - 11/29/12
相关PDF资料
PDF描述
DR-TRC103-868-EV BOARD EVALUATION 868MHZ RFM RFIC
TC70N6C32K7680 OSCILLATOR 32.7680 KHZ 2.5V SMD
TC70N3A32K7680 OSCILLATOR 32.7680 KHZ 2.5V SMD
TC70L3C32K7680 OSCILLATOR 32.7680 KHZ 3.3V SMD
EK64905-01 KIT EVAL FOR 64904 NO CABLES
相关代理商/技术参数
参数描述
DR-TRC103-950-DK 功能描述:KIT DEV 950MHZ RFIC SRR RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件,板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
DR-TRC103-950-EV 功能描述:BOARD EVALUATION 950MHZ RFM RFIC RoHS:否 类别:RF/IF 和 RFID >> RF 评估和开发套件,板 系列:- 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796
DR-TRC104-2400-DK 功能描述:射频开发工具 TRC104 Development Kit 2.4 GHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC104-2400-EV 制造商:RFM 功能描述:BOARD EVALUATION 2.4GHZ RFM RFIC
DR-TRC105-304-DK 功能描述:射频开发工具 TRC105 Development Kit 303-307 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V