参数资料
型号: DR-TRC105-304-EV
厂商: RFM
文件页数: 14/67页
文件大小: 0K
描述: BOARD EVALUATION 304MHZ RFM RFIC
标准包装: 1
类型: 收发器
频率: 303.325MHz ~ 307.3MHz
适用于相关产品: TRC105
已供物品: 2 个板,天线,电池
3.2 Continuous Mode Data and Clock Recovery
The raw output signal from the demodulator may contain jitter and glitches. Data and clock recovery converts the
data output of the demodulator into a glitch-free bit-stream DATA and generates a synchronized clock DCLK to be
used for sampling the DATA output as shown in Figure 8. DCLK is available on pin IRQ1 when the TRC105 oper-
ates in continuous mode.
Figure 8
To ensure correct operation of the data and clock recovery circuit, the following conditions have to be satisfied:
?
?
?
A 1-0-1- 0… preamble of at least 24 bits is required for synchronization
The transmitted bit stream must have at least one transition from 0 to 1 or from 1 to 0 every 8 bits during
transmission
The bit rate accuracy must be better than 2 %.
Data and clock recovery is enabled by default. It is controlled by RXCFG12_DCLK_Dis[6] . If data and clock re-
covery is disabled, the output of the demodulator is directed to DATA and the DCLK output (IRQ1 Pin in continu-
ous mode) is set to 0.
The received bit rate is defined by the values of the MCFG03 and MCFG04 configuration registers, and is calcu-
lated as follows:
BR = F XTAL /(2*(C + 1)*(D + 1)), with C in the range of 0 to 255, and D = 31 (suitable for most applications)
with BR the bit rate in kb/s, F XTAL the crystal frequency in kHz, C the value in MCFG03, and D the value in
MCFG04. For example, using a 12.8 MHz crystal (12,800 kHz), the bit rate is 25 kb/s when C = 7 and D = 31.
3.3 Continuous Mode Start Pattern Detection
Start pattern detection is activated by setting the RXCFG12_Recog[5] bit to 1. The demodulated signal is com-
pared with a pattern stored in the SYNCFG registers. The Start Pattern Detect signal (PATTERN) is driven by the
output of this comparator and is synchronized by DCLK. It is set to 1 when a pattern match is detected, otherwise
set to 0. The pattern detect output is updated at the rising edge of DCLK. The number of bytes used for compari-
son is defined in the RXCFG12_Pat_sz[4..3] register and the number of tolerated bit errors for pattern detection
is defined in the RXCFG12_Ptol[2..1] register. Figure 9 illustrates the pattern detection process.
www.RFM.com E-mail: info@rfm.com
? 2009-2013 by RF Monolithics, Inc.
Technical support +1.800.704.6079
Page 14 of 67
TRC105 - 05/29/13
相关PDF资料
PDF描述
GSCA06S2 SWITCH ROTARY SIDE
DR-TRC103-950-EV BOARD EVALUATION 950MHZ RFM RFIC
DR-TRC103-915-EV BOARD EVALUATION 915MHZ RFM RFIC
DR-TRC103-868-EV BOARD EVALUATION 868MHZ RFM RFIC
TC70N6C32K7680 OSCILLATOR 32.7680 KHZ 2.5V SMD
相关代理商/技术参数
参数描述
DR-TRC105-315-DK 功能描述:射频开发工具 TRC105 Development Kit 310-319 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-315-EV 功能描述:射频开发工具 TRC105 Evaluation Board 310-319 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-345-DK 功能描述:射频开发工具 TRC105 Development Kit 342-348 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-345-EV 功能描述:射频开发工具 TRC105 Evaluation Board 342-348 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V
DR-TRC105-372-DK 功能描述:射频开发工具 TRC105 Development Kit 365-381 MHz RoHS:否 制造商:Taiyo Yuden 产品:Wireless Modules 类型:Wireless Audio 工具用于评估:WYSAAVDX7 频率: 工作电源电压:3.4 V to 5.5 V