- 您现在的位置：买卖IC网 > PDF目录1994 > DS1689SN+T&R (Maxim Integrated Products)IC RTC SER NV RAM CTRL IN 28SOIC PDF资料下载
参数资料
| 型号： | DS1689SN+T&R |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 13/36页 |
| 文件大小： | 0K |
| 描述： | IC RTC SER NV RAM CTRL IN 28SOIC |
| 标准包装： | 1,000 |
| 类型： | 时钟/日历 |
| 特点： | NVSRAM |
| 存储容量： | 114B |
| 时间格式： | HH:MM:SS（12/24 小时） |
| 数据格式： | YY-MM-DD-dd |
| 接口： | 并联 |
| 电源电压： | 2.7 V ~ 3.3 V，4.5 V ~ 5.5 V |
| 电压 - 电源，电池： | 2.5 V ~ 3.7 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 28-SOIC |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
DS1689/DS1693
20 of 36
applied, the on-chip logic always attempts to drive the
PWR pin active in response to the enabled
kickstart or wake-up condition. This is true even if
PWR was previously inactive as the result of power
being applied by some means other than wake-up or kickstart.
The system can be powered down under software control by setting the PAB bit to logic 1. This causes
the open-drain
PWR pin to be placed in a high-impedance state, as shown at the beginning of interval 4 in
the timing diagram. As VCC voltage decays, the IRQ output pin is placed in a high-impedance state when
VCC goes below VPF. If the system is to be again powered on in response to a wake-up or kickstart, then
both the WF and KF flags should be cleared and WIE and/or KSE should be enabled prior to setting the
PAB bit.
During interval 5, the system is fully powered down. Battery backup of the clock calendar and NV RAM
is in effect,
PWR and IRQ are tri-stated, and monitoring of wake-up and kickstart takes place.
RAM CLEAR
The DS1689/DS1693 provide a RAM clear function for the 114 bytes of user RAM. When enabled, this
function can be performed regardless of the condition of the VCC pin.
The RAM clear function is enabled or disabled via the RAM Clear Enable bit (RCE; bank 1, register
04BH). When this bit is set to logic 1, the 114 bytes of user RAM are cleared (all bits set to 1) when an
active-low transition is sensed on the
RCLR pin. This action has no effect on either the clock/calendar
settings or upon the contents of the external extended RAM. The RAM clear flag (RF, bank 1, register
04BH) is set when the RAM clear operation has been completed. If VCC is present at the time of the RAM
clear and RIE = 1, the
IRQ line is also driven low upon completion. The interrupt condition can be
cleared by writing a 0 to the RF bit. The
IRQ line then returns to its inactive high level, provided there are
no other pending interrupts. Once the
RCLR pin is activated, all read/write accesses are locked out for a
minimum recover time, specified as tREC in the Electrical Characteristics section.
When RCE is cleared to 0, the RAM clear function is disabled. The state of the
RCLR pin has no effect
on the contents of the user RAM, and transitions on the
RCLR pin have no effect on RF.
相关PDF资料 |
PDF描述 |
|---|---|
| DS17285S-3NT | IC RTC 3V 2K NV RAM 24-SOIC |
| DS1742-100IND | IC RTC RAM Y2K 5V 100NS 24-EDIP |
| DS1743P-70+ | IC RTC RAM Y2K 5V 70NS 34-PCM |
| DS1744-70IND | IC RTC RAM Y2K 5V 70NS 28-EDIP |
| DS1746-70IND | IC RTC RAM Y2K 5V 70NS 32-EDIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS1689S-TRL | 功能描述:IC RTC SER W/NV RAM CTRL 28-SOIC RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 实时时钟 系列:- 产品培训模块:Obsolescence Mitigation Program 标准包装:1 系列:- 类型:时钟/日历 特点:警报器，闰年，SRAM 存储容量:- 时间格式:HH:MM:SS（12/24 小时） 数据格式:YY-MM-DD-dd 接口:SPI 电源电压:2 V ~ 5.5 V 电压 - 电源，电池:- 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-WDFN 裸露焊盘 供应商设备封装:8-TDFN EP 包装:管件 |
| DS1691 | 功能描述:实时时钟 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube |
| DS1691 WAF | 制造商:Texas Instruments 功能描述: |
| DS1691/1692 WAF | 制造商:Texas Instruments 功能描述: |
| DS1691A | 制造商:NSC 制造商全称:National Semiconductor 功能描述:(RS-422/RS-423) Line Drivers with TRI-STATE Outputs |
发布紧急采购，3分钟左右您将得到回复。