参数资料
型号: DS1820
厂商: Maxim Integrated
文件页数: 2/23页
文件大小: 0K
描述: IC DGTL THERMOMETER TO92-3
其它有关文件: DS1820 Digital Thermometer
标准包装: 500
感应温度: -55°C ~ 125°C
输出类型: 开路漏极
电源电压: 3 V ~ 5.5 V
精确度: ±0.5°C
封装/外壳: TO-226-3、TO-92-3 标准主体
供应商设备封装: TO-92
包装: 散装
DS18S20
ORDERING INFORMATION
PART
DS18S20
DS18S20+
DS18S20/T&R
DS18S20+T&R
DS18S20-SL/T&R
DS18S20-SL+T&R
DS18S20Z
DS18S20Z+
DS18S20Z/T&R
DS18S20Z+T&R
TEMP RANGE
–55°C to +125°C
–55°C to +125°C
–55°C to +125°C
–55°C to +125°C
–55°C to +125°C
–55°C to +125°C
–55°C to +125°C
–55°C to +125°C
–55°C to +125°C
–55°C to +125°C
PIN-PACKAGE
3 TO-92
3 TO-92
3 TO-92 (2000 Piece)
3 TO-92 (2000 Piece)
3 TO-92 (2000 Piece)*
3 TO-92 (2000 Piece)*
8 SO
8 SO
8 SO (2500 Piece)
8 SO (2500 Piece)
+ Denotes a lead(Pb)-free/RoHS-compliant package. A “+” appears on the top mark of lead(Pb)-free packages.
T&R = Tape and reel.
*TO-92 packages in tape and reel can be ordered with straight or formed leads. Choose “SL” for straight leads. Bulk TO-92 orders are straight
leads only.
PIN DESCRIPTION
PIN
TO-92 SO
NAME
FUNCTION
1
2
3
5
4
3
1, 2, 6, 7,
8
GND
DQ
V DD
N.C.
Ground
Data Input/Output. Open-drain 1-Wire interface pin. Also provides
power to the device when used in parasite power mode (see the
Powering the DS18S20 section.)
Optional V DD . V DD must be grounded for operation in parasite
power mode.
No Connection
OVERVIEW
Figure 1 shows a block diagram of the DS18S20, and pin descriptions are given in the Pin Description
table. The 64-bit ROM stores the device’s unique serial code. The scratchpad memory contains the 2-byte
temperature register that stores the digital output from the temperature sensor. In addition, the scratchpad
provides access to the 1-byte upper and lower alarm trigger registers (T H and T L ). The T H and T L registers
are nonvolatile (EEPROM), so they will retain data when the device is powered down.
The DS18S20 uses Maxim’s exclusive 1-Wire bus protocol that implements bus communication using
one control signal. The control line requires a weak pullup resistor since all devices are linked to the bus
via a 3-state or open-drain port (the DQ pin in the case of the DS18S20). In this bus system, the
microprocessor (the master device) identifies and addresses devices on the bus using each device’s unique
64-bit code. Because each device has a unique code, the number of devices that can be addressed on one
bus is virtually unlimited. The 1-Wire bus protocol, including detailed explanations of the commands and
“time slots,” is covered in the 1-Wire Bus System section.
Another feature of the DS18S20 is the ability to operate without an external power supply. Power is
instead supplied through the 1-Wire pullup resistor via the DQ pin when the bus is high. The high bus
signal also charges an internal capacitor (C PP ), which then supplies power to the device when the bus is
low. This method of deriving power from the 1-Wire bus is referred to as “parasite power.” As an
alternative, the DS18S20 may also be powered by an external supply on V DD .
2 of 23
相关PDF资料
PDF描述
DS1822+PAR IC THERMOMETER ECONO DIG TO-92
DS1822Z/T&R IC THERMOMETER ECONO DIG 8-SOIC
DS1870E-010+T&R IC CNTRLR RF POWER AMP 16TSSOP
DS18S20-PAR+T&R IC THERM MICROLAN HI-PREC TO-92
DS60R+T&R IC SENSOR MICRO CENTIGRADE SOT23
相关代理商/技术参数
参数描述
DS1820K 制造商:Maxim Integrated Products 功能描述:THERMOMETER DEMO KIT
DS1820S 制造商:未知厂家 制造商全称:未知厂家 功能描述:DS1820.DS1820S Digital Thermometer Replacements
DS1821 功能描述:板上安装温度传感器 RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
DS1821_07 制造商:DALLAS 制造商全称:Dallas Semiconductor 功能描述:Programmable Digital Thermostat and Thermometer
DS1821+ 功能描述:板上安装温度传感器 Programmable Digital Thermostat/Thrmmtr RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor