- 您现在的位置：买卖IC网 > PDF目录3784 > DS87C550-QNL (Maxim Integrated Products)IC MCU EPROM ADC/PWM HS 68-PLCC PDF资料下载
参数资料
| 型号： | DS87C550-QNL |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 16/49页 |
| 文件大小： | 0K |
| 描述： | IC MCU EPROM ADC/PWM HS 68-PLCC |
| 标准包装： | 18 |
| 系列： | 87C |
| 核心处理器： | 8051 |
| 芯体尺寸： | 8-位 |
| 速度： | 33MHz |
| 连通性： | EBI/EMI，SIO，UART/USART |
| 外围设备： | 电源故障复位，PWM，WDT |
| 输入/输出数： | 55 |
| 程序存储器容量： | 8KB（8K x 8） |
| 程序存储器类型： | OTP |
| RAM 容量： | 1K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 4.5 V ~ 5.5 V |
| 数据转换器： | A/D 6x10b |
| 振荡器型： | 外部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 68-LCC（J 形引线） |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页
DS87C550 EPROM High-Speed Microcontroller with ADC and PWM
23 of 49
of the 10-bit conversion (i.e., bits 9-2). If OUTCF is a 1, then ADMSB contains A/D output bits 9-8 (right
justified). The upper 6 bits of the register are set to 0 in this case.
The value stored in the output registers is given by the following equation:
1024 x ((VIN- AVREF-)/( AVREF+ - AVREF-))
This equation shows that the A/D conversion result is a 10-bit binary number that represents what
fraction of the available reference voltage the input signal is. As you can see with a reference voltage of
2.5 volts, the output has a resolution of 2.44 millivolts. This shows that the reference voltage must be
very well regulated to ensure satisfactory performance. It should be noted that the output of the A/D
conversion process will be “0000000000” for voltages from AVREF- to (AVREF- +1/2 LSB). In addition,
“1111111111” will be output for voltages from (AVREF+ - 3/2 LSB) to AVREF+.
The DS87C550 offers a unique feature that allows the result of an A/D conversion to be compared with
two user-defined values stored in the WINHI and WINLO registers. The results of this comparison will
set or clear the WCM (ADCON 1.2) bit, and this bit can be used as a qualifier to the A/D interrupt. This
comparison is built into hardware so that this feature is performed without any burden on the software,
and A/D results that are not of particular interest to the application can be ignored. Special function
registers WINHI and WINLO are loaded by application software with 8-bit numbers that are compared
with the 8 MSBs of the A/D result. These user-defined numbers form a range of values, and the A/D
result is evaluated to be inside or outside of this range. When WCIO (ADCON.1) is 0, then WCM is set if
the A/D result is found to be inside the range. Otherwise WCM is cleared. When WCIO is a 1, then
WCM is set if the A/D result is found to be outside the range. Otherwise WCM is cleared. The state of the
WCM bit is expressed by the following equation:
WCM = WCIO
(WINHI ADMSB) (WINLO ADMSB)
This equation precisely identifies the relationship between the window registers (WINHI and WINLO),
the MSB of the A/D conversion (ADMSB), and the WCIO and WCM bits. However by observation, it is
not particularly intuitive as to how this interaction works in a practical sense. If the user makes the
assumption that the value stored in WINHI is greater that the value stored in WINLO (this is normally but
not necessarily the case), then this equation can be simplified to the following two cases:
For WCIO = 0: WCM = (WINHI > ADMSB) AND (ADMSB
WINLO)
For WCIO = 1: WCM = (WINHI
ADMSB) OR (ADMSB < WINLO)
It is clear that these two equations now express the cases where the A/D result is inside the comparison
window (WCIO = 0) and outside the comparison window (WCIO = 1). It is important to note the
and
symbols and account for the specific values that are included in the comparison.
There is another SFR bit, WCQ, that further defines the action taken when the WCM is set. If WCQ is 0,
then an A/D interrupt will occur (if enabled) regardless of the comparison results. When WCQ is set to a
1, then an A/D interrupt will only occur if WCM is set (i.e., the A/D result comparison was true). This
feature allows software to respond only to conditions that meet the programmed range.
相关PDF资料 |
PDF描述 |
|---|---|
| MC908LK24CPBE | IC MCU 8BIT 64-LQFP |
| 1588908-1 | JR FRRL KIT, PC 126 SEALED |
| 1278530-1 | RETAINING CLIP, 1X4 BACKPLANE |
| 1544551-1 | CONNECTOR 5V 6.35 |
| 492578-1 | DUST COVER,DAUGHTER CARD HSG |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DS88 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| DS8800 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:Dual Voltage Level Translator |
| DS8800H | 制造商:NSC 制造商全称:National Semiconductor 功能描述:Dual Voltage Level Translator |
| DS8800H/A+ | 制造商:未知厂家 制造商全称:未知厂家 功能描述:TTL-to-MOS Translator |
| DS8802J/A+ | 制造商:未知厂家 制造商全称:未知厂家 功能描述:MOS-to-TTL Translator |
发布紧急采购，3分钟左右您将得到回复。