- 您现在的位置：买卖IC网 > PDF目录299186 > HSMS-2863-TR2 (AGILENT TECHNOLOGIES INC) SILICON, UHF-C BAND, MIXER DIODE PDF资料下载
参数资料
| 型号： | HSMS-2863-TR2 |
| 厂商： | AGILENT TECHNOLOGIES INC |
| 元件分类： | 参考电压二极管 |
| 英文描述： | SILICON, UHF-C BAND, MIXER DIODE |
| 封装： | SOT-23, 3 PIN |
| 文件页数： | 15/17页 |
| 文件大小： | 205K |
| 代理商： | HSMS-2863-TR2 |
7
high value of current (such as
5 mA). This slope is converted
into a resistance Rd.
0.026
RS = Rd – ––––––
If
For n-type diodes with relatively
low values of saturation current,
Cj is obtained by measuring the
total capacitance (see AN1124).
Rj, the junction resistance, is
calculated using the equation
given above.
The characterization of the
surface mount package is too
complex to describe here — linear
equivalent circuits can be found in
AN1124.
Detector Circuits
(small signal)
When DC bias is available,
Schottky diode detector circuits
can be used to create low cost RF
and microwave receivers with a
sensitivity of -55 dBm to
-57 dBm.[1] Moreover, since
external DC bias sets the video
impedance of such circuits, they
display classic square law
response over a wide range of
input power levels[2,3]. These
circuits can take a variety of
forms, but in the most simple case
they appear as shown in Figure 9.
This is the basic detector circuit
used with the HSMS-286x family
of diodes.
Output voltage can be virtually
doubled and input impedance
(normally very high) can be
halved through the use of the
voltage doubler circuit[4].
In the design of such detector
circuits, the starting point is the
equivalent circuit of the diode. Of
interest in the design of the video
portion of the circuit is the diode’s
video impedance — the other
elements of the equivalent circuit
disappear at all reasonable video
frequencies. In general, the lower
the diode’s video impedance, the
better the design.
VIDEO
OUT
RF
IN
Z-MATCH
NETWORK
L1
DC BIAS
VIDEO
OUT
Z-MATCH
NETWORK
L1
DC BIAS
RF
IN
Figure 9. Basic Detector Circuits.
The situation is somewhat more
complicated in the design of the
RF impedance matching network,
which includes the package
inductance and capacitance
(which can be tuned out), the
series resistance, the junction
capacitance and the video
resistance. Of the elements of the
diode’s equivalent circuit, the
parasitics are constants and the
video resistance is a function of
the current flowing through the
diode.
RV = Rj + RS
The sum of saturation current and
bias current sets the detection
sensitivity, video resistance and
input RF impedance of the
Schottky detector diode. Where
bias current is used, some
tradeoff in sensitivity and square
law dynamic range is seen, as
shown in Figure 5 and described
in reference [3].
The most difficult part of the
design of a detector circuit is the
input impedance matching
network. For very broadband
detectors, a shunt 60
resistor
will give good input match, but at
the expense of detection
sensitivity.
When maximum sensitivity is
required over a narrow band of
frequencies, a reactive matching
network is optimum. Such net-
works can be realized in either
lumped or distributed elements,
depending upon frequency, size
constraints and cost limitations,
but certain general design
principals exist for all types.[5]
Design work begins with the RF
impedance of the HSMS-286x
series when bias current is set to
3
A. See Figure 10.
1 GHz
2
3
4
5
6
0.2
0.6
1
2
5
Figure 10. RF Impedance of the
Diode.
[1] Agilent Application Note 923, Schottky Barrier Diode Video Detectors.
[2] Agilent Application Note 986, Square Law and Linear Detection.
[3] Agilent Application Note 956-5, Dynamic Range Extension of Schottky Detectors.
[4] Agilent Application Note 956-4, Schottky Diode Voltage Doubler.
[5] Agilent Application Note 963, Impedance Matching Techniques for Mixers and Detectors.
相关PDF资料 |
PDF描述 |
|---|---|
| HSS104TA-E | 0.11 A, SILICON, SIGNAL DIODE, DO-34 |
| HSS81TA-E | 0.15 A, SILICON, SIGNAL DIODE, DO-34 |
| HSS83TA | 0.15 A, SILICON, SIGNAL DIODE, DO-34 |
| HSS83TDX | 0.15 A, SILICON, SIGNAL DIODE, DO-34 |
| HSS83 | 0.15 A, SILICON, SIGNAL DIODE, DO-34 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| HSMS-2863-TR2G | 功能描述:射频检测器 4 VBR 0.3 pF RoHS:否 制造商:Skyworks Solutions, Inc. 配置: 频率范围:650 MHz to 3 GHz 最大二极管电容: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SC-88 封装:Reel |
| HSMS-2864 | 制造商:AGILENT 制造商全称:AGILENT 功能描述:Surface Mount Microwave Schottky Detector Diodes |
| HSMS-2864-BLKG | 功能描述:射频检测器 4 VBR 0.3 pF RoHS:否 制造商:Skyworks Solutions, Inc. 配置: 频率范围:650 MHz to 3 GHz 最大二极管电容: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SC-88 封装:Reel |
| HSMS-2864-TR1G | 功能描述:射频检测器 4 VBR 0.3 pF RoHS:否 制造商:Skyworks Solutions, Inc. 配置: 频率范围:650 MHz to 3 GHz 最大二极管电容: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SC-88 封装:Reel |
| HSMS-2864-TR2G | 功能描述:射频检测器 4 VBR 0.3 pF RoHS:否 制造商:Skyworks Solutions, Inc. 配置: 频率范围:650 MHz to 3 GHz 最大二极管电容: 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SC-88 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。