参数资料
| 型号： | IR3508ZMTRPBF |
| 厂商： | International Rectifier |
| 文件页数： | 14/19页 |
| 文件大小： | 0K |
| 描述： | IC CTRL XPHASE3 20MLPQ |
| 标准包装： | 1 |
| 系列： | * |
IR3508Z
DESIGN PROCEDURES - IR3508Z
Inductor Current Sensing Capacitor C CS and Resistor R CS
The DC resistance of the inductor is utilized to sense the inductor current. Usually the resistor R CS and capacitor C CS
in parallel with the inductor are chosen to match the time constant of the inductor, and therefore the voltage across
the capacitor C CS represents the inductor current. If the two time constants are not the same, the AC component of
the capacitor voltage is different from that of the real inductor current. The time constant mismatch does not affect the
average current sharing among the multiple phases, but does affect the current signal IOUT as well as the output
voltage during a load current transient if adaptive voltage positioning is being implemented.
Measure the inductance L and the inductor DC resistance R L . Pre-select the capacitor C CS and calculate R CS as
follows.
R CS =
L R L
C CS
(1)
Bootstrap Capacitor C BST
Depending on the duty cycle and gate drive current of the phase IC, a capacitor in the range of 0.1uF to 1uF is
needed for the bootstrap circuit.
Decoupling Capacitors for Phase IC
A 0.1uF-1uF decoupling capacitor is required at the VCCL pin.
CURRENT SHARE LOOP COMPENSATION
The internal compensation of current share loop ensures that crossover frequency of the current share loop is at least
one decade lower than that of the voltage loop so that the interaction between the two loops is eliminated. The
crossover frequency of current share loop is approximately 8 kHz.
Page 14 of 19
Jan 09, 2009
相关PDF资料 |
PDF描述 |
|---|---|
| IR3510MPBF | IC XPHASE CONTROL 32-MLPQ |
| IR3513ZMTRPBF | IC CTRL XPHASE3 POL 32-MLPQ |
| IR3514MTRPBF | IC XPHASE3 CONTROL HYBRD 40-MLPQ |
| IR3521MTRPBF | IC CTRL XPHASE3 SVID 32-MLPQ |
| IR3522MTRPBF | IC CTRL XPHASE3 DDR/VVT 32-MLPQ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3510 | 制造商:IRF 制造商全称:International Rectifier 功能描述:HOT-SWAP N+1 REDUNDANT XPHASETM CONTROL IC |
| IR3510MPBF | 功能描述:IC XPHASE CONTROL 32-MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:XPhase™ 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| IR3510MTRPBF | 功能描述:热插拔功率分布 HOT-SWAP N+1 XPHASE CTRL IC RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| IR3513MTRPBF | 功能描述:开关变换器、稳压器与控制器 2 CH OR 2 PHASE SYNC PWM CNTRLR RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| IR3513XMTRPBF | 功能描述:功率驱动器IC RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。