参数资料
| 型号： | IR3510MPBF |
| 厂商： | International Rectifier |
| 文件页数： | 16/36页 |
| 文件大小： | 0K |
| 描述： | IC XPHASE CONTROL 32-MLPQ |
| 标准包装： | 100 |
| 系列： | XPhase™ |
| 应用： | 处理器 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-MLPQ（5x5） |
| 包装： | 剪切带 (CT) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
IR3510
Loss-less inductor current sensing
Inductor current can be sensed by connecting a series resistor and a capacitor network in parallel with the inductor
and measuring the voltage across the capacitor.
v L
i L
CSA
L
R s
R L
C s
v c
V o
C o
CO
Figure 4 – Inductor Current Sensing and Current Sense Amplifier
The equation of the sensing network is,
v C ( s ) = v L ( s )
1
1 + sR S C S
= i L ( s )
R L + sL
1 + sR S C S
Usually the resistor Rcs and capacitor Ccs are chosen so that the time constant of Rcs and Ccs equals the time
constant of the inductor which is the inductance L over the inductor DCR. If the two time constants match, the
voltage across Ccs is proportional to the current through L, and the sense circuit can be treated as if only a sense
resistor with the value of R L was used. The mismatch of the time constants does not affect the measurement of
inductor DC current, but affects the AC component of the inductor current.
The advantage of sensing the inductor current versus high side or low side sensing is that actual output current
being delivered to the load is obtained rather than peak or sampled information about the switch currents. The
output voltage can be positioned to meet a load line based on real time information. Except for a sense resistor in
series with the inductor, this is the only sense method that can support a single cycle transient response. Other
methods provide no information during either load increase (low side sensing) or load decrease (high side
sensing).
An additional problem associated with peak or valley current mode control for voltage positioning is that they suffer
from peak?to?average errors. These errors will show in many ways but one example is the effect of frequency
variation. If the frequency of a particular unit is 10% low, the peak to peak inductor current will be 10% larger and
the output impedance of the converter will drop by about 10%. Variations in inductance, current sense amplifier
bandwidth, PWM prop delay, any added slope compensation, input voltage, and output voltage are all additional
sources of peak?to?average errors.
Current Sense Amplifier
A high speed differential current sense amplifier is located in the Phase IC, as shown in Figure 1. Its gain
decreases with increasing temperature and is nominally 34 at 25oC and 29 at 125oC (?1470 ppm/oC). This
reduction of gain tends to compensate the 3850 ppm/oC increase in inductor DCR. Since in most designs the
Phase IC junction is hotter than the inductor, these two effects tend to cancel such that no additional temperature
compensation of the load line is required.
The current sense amplifier can accept positive differential input up to 100mV and negative up to ?20mV before
clipping. The output of the current sense amplifier is summed with the DAC voltage and sent to the Control IC and
other Phases through an on-chip 10K
resistor connected to the ISHARE pin. The ISHARE pins of all the phases
Page 16 of 36
IR Confidential
May 18, 2009
相关PDF资料 |
PDF描述 |
|---|---|
| IR3513ZMTRPBF | IC CTRL XPHASE3 POL 32-MLPQ |
| IR3514MTRPBF | IC XPHASE3 CONTROL HYBRD 40-MLPQ |
| IR3521MTRPBF | IC CTRL XPHASE3 SVID 32-MLPQ |
| IR3522MTRPBF | IC CTRL XPHASE3 DDR/VVT 32-MLPQ |
| IR3523MTRPBF | IC XPHASE3 CTLR VR11.1 40-MLPQ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3510MTRPBF | 功能描述:热插拔功率分布 HOT-SWAP N+1 XPHASE CTRL IC RoHS:否 制造商:Texas Instruments 产品:Controllers & Switches 电流限制: 电源电压-最大:7 V 电源电压-最小:- 0.3 V 工作温度范围: 功率耗散: 安装风格:SMD/SMT 封装 / 箱体:MSOP-8 封装:Tube |
| IR3513MTRPBF | 功能描述:开关变换器、稳压器与控制器 2 CH OR 2 PHASE SYNC PWM CNTRLR RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| IR3513XMTRPBF | 功能描述:功率驱动器IC RoHS:否 制造商:Micrel 产品:MOSFET Gate Drivers 类型:Low Cost High or Low Side MOSFET Driver 上升时间: 下降时间: 电源电压-最大:30 V 电源电压-最小:2.75 V 电源电流: 最大功率耗散: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 封装:Tube |
| IR3513Z | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM POL CONTROL IC |
| IR3513ZMPBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM POL CONTROL IC |
发布紧急采购，3分钟左右您将得到回复。