- 您现在的位置：买卖IC网 > PDF目录1809 > IR3523MTRPBF (International Rectifier)IC XPHASE3 CTLR VR11.1 40-MLPQ PDF资料下载
参数资料
| 型号： | IR3523MTRPBF |
| 厂商： | International Rectifier |
| 文件页数： | 13/37页 |
| 文件大小： | 0K |
| 描述： | IC XPHASE3 CTLR VR11.1 40-MLPQ |
| 标准包装： | 3,000 |
| 系列： | XPhase3™ |
| 应用： | 处理器 |
| 电流 - 电源： | 10mA |
| 电源电压： | 4.75 V ~ 7.5 V |
| 工作温度： | 0°C ~ 100°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 40-MLPQ |
| 供应商设备封装： | 40-MLPQ（6x6） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页
IR3523
PHASE IC
CLOCK
PULSE
EAIN
PWMRMP
VDAC
GATEH
GATEL
STEADY-STATE
OPERATION
DUTY CYCLE INCREASE
DUE TO LOAD
INCREASE
DUTY CYCLE DECREASE
DUE TO VIN INCREASE
(FEED-FORWARD)
DUTY CYCLE DECREASE DUE TO LOAD
DECREASE (BODY BRAKING) OR FAULT
(VCC UV, OCP, VID FAULT)
STEADY-STATE
OPERATION
Figure 7 - PWM Operating Waveforms
Body Braking
TM
In a conventional synchronous buck converter, the minimum time required to reduce the current in the inductor in
response to a load step decrease is;
T SLEW =
L * ( I MAX ? I MIN )
V O
The slew rate of the inductor current can be significantly increased by turning off the synchronous rectifier in
response to a load step decrease. The switch node voltage is then forced to decrease until conduction of the
synchronous rectifier’s body diode occurs. This increases the voltage across the inductor from Vout to Vout +
V BODYDIODE . The minimum time required to reduce the current in the inductor in response to a load transient
decrease is now;
T SLEW =
L * ( I MAX ? I MIN )
V O + V BODYDIODE
Since the voltage drop in the body diode is often higher than output voltage, the inductor current slew rate can be
increased by 2X or more. This patent pending technique is referred to as “body braking” and is accomplished
through the “body braking comparator” located in the phase IC. If the error amplifier’s output voltage drops below
the VDAC voltage or a programmable voltage, this comparator turns off the low side gate driver.
Lossless Average Inductor Current Sensing
Inductor current can be sensed by connecting a series resistor and a capacitor network in parallel with the inductor
and measuring the voltage across the capacitor, as shown in Figure 8. The equation of the sensing network is,
v C ( s ) = v L ( s )
1
1 + sR CS C CS
= i L ( s )
R L + sL
1 + sR CS C CS
Usually the resistor Rcs and capacitor Ccs are chosen so that the time constant of Rcs and Ccs equals the time
constant of the inductor which is the inductance L over the inductor DCR (R L ). If the two time constants match, the
voltage across Ccs is proportional to the current through L, and the sense circuit can be treated as if only a sense
resistor with the value of R L was used. The mismatch of the time constants does not affect the measurement of
inductor DC current, but affects the AC component of the inductor current.
Page 13 of 37
June 20, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| IR3527MTRPBF | IC CTRL XPHASE3 DUAL 24-MLPQ |
| IR3529MTRPBF | IC CTRL XPHASE CPU/ASIC 20-MLPQ |
| IR3550MTRPBF | IC DRIVER GATE 60A PQFN |
| IR3553MTRPBF | IC DRIVER GATE 40A PQFN |
| IR3621FTR | IC REG CTRLR BUCK PWM VM 28TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| IR3527 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL PHASE IC |
| IR3527MPBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL PHASE IC |
| IR3527MTRPBF | 功能描述:开关变换器、稳压器与控制器 XPHASE3 Dual Phase 7V 1.3A PMIC RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| IR3529 | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM PHASE IC |
| IR3529MPBF | 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM PHASE IC |
发布紧急采购，3分钟左右您将得到回复。