参数资料
型号: IR3523MTRPBF
厂商: International Rectifier
文件页数: 20/37页
文件大小: 0K
描述: IC XPHASE3 CTLR VR11.1 40-MLPQ
标准包装: 3,000
系列: XPhase3™
应用: 处理器
电流 - 电源: 10mA
电源电压: 4.75 V ~ 7.5 V
工作温度: 0°C ~ 100°C
安装类型: 表面贴装
封装/外壳: 40-MLPQ
供应商设备封装: 40-MLPQ(6x6)
包装: 带卷 (TR)
IR3523
Figure 13 - VCCL regulator stability with 5 phases and PHSOUT equals 750 kHz
VCCL Under Voltage Lockout (UVLO)
The IR3523 has no under voltage lockout protection for the converter input voltage (VCC), but monitors the VCCL
voltage instead. The VCCL is used to power both the control IC and phase ICs including the phase ICs internal gate
drivers. During power up, the UVLO fault latch will be reset if VCCL is above 94% of the voltage set by resistor
divider at VCCLFB pin. If VCCL voltage drops below 86% of the set value, the UVLO fault latch will be set.
Power Good (PG1, 2)
The PGx pin is an open-collector output and should be pulled up to a voltage source through a resistor. During soft
start, the PGx remains low until the output voltage is in regulation and SS/DELx is above 3.93V. The PGx pin
becomes low if any of the fault latches are triggered (See Table 3).
PGx monitors the output voltage. If any of the voltage planes fall out of regulation, PGx will become low, but the VR
will continue to attempt to regulate the output voltages. Output voltage out of spec is defined as 315mV to 275mV
below nominal voltage. VID on-the-fly transition, which is a voltage plane transitioning between two different VID
codes, is not considered to be out of specification.
A high level at the PGx pins indicates that the converter is in operation with no fault and ensures the output voltage
is within the regulation.
The PG outputs derive power from either VCCL or VCCLDRV to ensure they can assert with input voltage as low as
possible.
Open Control Loop Detection
The error amplifier’s output voltage is monitored to ensure the control loop is in regulation. If any fault condition
forces the error amplifier output above VCCL-1.08 V for 8 switching cycles, the Open Control Loop fault latch is set.
This fault latch can only be cleared by cycling power to VCCL.
Load Current Indicator Output
The VDRP pin voltage represents the average current of the converter plus the VDAC1 voltage. The load current
information can be retrieved by using a differential amplifier to subtracts the VDAC1 voltage from the VDRP1
voltage.
Page 20 of 37
June 20, 2008
相关PDF资料
PDF描述
IR3527MTRPBF IC CTRL XPHASE3 DUAL 24-MLPQ
IR3529MTRPBF IC CTRL XPHASE CPU/ASIC 20-MLPQ
IR3550MTRPBF IC DRIVER GATE 60A PQFN
IR3553MTRPBF IC DRIVER GATE 40A PQFN
IR3621FTR IC REG CTRLR BUCK PWM VM 28TSSOP
相关代理商/技术参数
参数描述
IR3527 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL PHASE IC
IR3527MPBF 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM DUAL PHASE IC
IR3527MTRPBF 功能描述:开关变换器、稳压器与控制器 XPHASE3 Dual Phase 7V 1.3A PMIC RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
IR3529 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM PHASE IC
IR3529MPBF 制造商:IRF 制造商全称:International Rectifier 功能描述:XPHASE3TM PHASE IC