参数资料
| 型号： | ISL6314IRZ-T |
| 厂商： | Intersil |
| 文件页数： | 22/32页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR PWM 1PHASE BUCK 32-QFN |
| 产品培训模块： | Solutions for Industrial Control Applications |
| 标准包装： | 6,000 |
| 应用： | 控制器，Intel VR11，AMD CPU |
| 输入电压： | 5 V ~ 12 V |
| 输出数： | 1 |
| 输出电压： | 0.38 V ~ 1.6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-QFN 裸露焊盘（5x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
ISL6314
.
R OCSET
VSEN is outside this window. Even if the controller is shut
down the PGOOD signal will still stay high until VSEN falls
ISEN+
ISEN-
+
ISEN
-
ISENO
-
V DROOP
+
-
V OCSET
+
OCSET
100μA
below the undervoltage threshold.
Overvoltage Protection
The ISL6314 constantly monitors the difference between the
VSEN and RGND voltages to detect if an overvoltage event
occurs. During soft-start, while the DAC is ramping up, the
overvoltage trip level is the higher of a fixed voltage 1.27V or
DAC + 175mV for Intel modes of operation and DAC + 225mV
VDIFF
+1V
+
-
OC
for AMD modes of operation. Upon successful soft-start, the
overvoltage trip level is only DAC + 175mV or DAC + 225mV
depending on whether the controller is running in Intel or AMD
mode. When the output voltage rises above the OVP trip level
VID + OFFSET mV
V OVP
SOFT-START, FAULT
AND CONTROL LOGIC
-
actions are taken by the ISL6314 to protect the microprocessor
load.
At the inception of an overvoltage event, LGATE is
commanded high and the PGOOD signal is driven low. This
turns on the lower MOSFETs and pulls the output voltage
below a level that might cause damage to the load. The
LGATE output remains high until VSEN falls 100mV below
the OVP threshold that tripped the overvoltage protection
VSEN
+
+
OV
PGOOD
circuitry. The ISL6314 will continue to protect the load in this
fashion as long as the overvoltage condition recurs. Once an
RGND
-
x1
-
+
UV
overvoltage condition ends, the ISL6314 latches off, and
must be reset by toggling EN, or through POR, before a
soft-start can be reinitiated.
There is an OVP condition that exists that will not latch off the
VID - OFFSET mV ISL6314 INTERNAL CIRCUITRY
FIGURE 14. POWER-GOOD AND PROTECTION CIRCUITRY
Power-Good Signal
The power-good pin (PGOOD) is an open-drain logic output
that signals whether or not the ISL6314 is regulating the
output voltage within the proper levels, and whether any fault
conditions exist. This pin should be tied through a resistor to
a voltage source that’s equal to or less than VCC.
For Intel mode of operation, PGOOD indicates whether VSEN
is within specified overvoltage and undervoltage limits after a
fixed delay from the end of soft-start. PGOOD transitions low
when an undervoltage, overvoltage, or overcurrent condition
is detected or when the controller is disabled by a reset from
EN, POR, or one of the no-CPU VID codes. In the event of
an overvoltage or overcurrent condition, or a no-CPU VID
code, the controller latches off and PGOOD will not return
high until EN is toggled and a successful soft-start is
completed. In the case of an undervoltage event, PGOOD
will return high when the output voltage rises above the
undervoltage hysteresis level. PGOOD is always low prior to
the end of soft-start.
For AMD modes of operation, PGOOD will always be high as
long as VSEN is within the specified undervoltage/overvoltage
window and soft-start has ended. PGOOD only goes low if
22
ISL6314. During a soft-start sequence, if the VSEN voltage is
above the OVP threshold an overvoltage event will occur, but
will be released once VSEN falls 100mV below the OVP
threshold. If VSEN then rises above the OVP trip threshold a
second time, the ISL6314 will be latched off and cannot be
restarted until the controller is reset.
Pre-POR Overvoltage Protection
Prior to PVCC and VCC exceeding their POR levels, the
ISL6314 is designed to protect the load from any overvoltage
events that may occur. This is accomplished by means of an
internal 10k Ω resistor tied from PHASE to LGATE, which
turns on the lower MOSFET to control the output voltage
until the overvoltage event ceases or the input power supply
cuts off. For complete protection, the low side MOSFET
should have a gate threshold well below the maximum
voltage rating of the load/microprocessor. In the event that
during normal operation the PVCC or VCC voltage falls back
below the POR threshold, the pre-POR overvoltage
protection circuitry reactivates to protect from any more
pre-POR overvoltage events.
Undervoltage Detection
The undervoltage threshold is set at DAC - 350mV of the
VID code. When the output voltage (V SEN - R GND ) is below
the undervoltage threshold, PGOOD gets pulled low. No
other action is taken by the controller. PGOOD will return
high if the output voltage rises above DAC - 250mV.
FN6455.2
October 8, 2009
相关PDF资料 |
PDF描述 |
|---|---|
| ESM24DRYI-S13 | CONN EDGECARD 48POS .156 EXTEND |
| 1944-06M | COIL RF .27UH MOLDED UNSHIELDED |
| ISL95870HRUZ-T | IC CTRLR PWM 1PHASE GPU 16UTQFN |
| MIC5301-2.85YML TR | IC REG LDO 2.85V .15A 6-MLF |
| ISL95870AHRUZ-T | IC CTRLR PWM 1PHASE GPU 20UTQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6315CRZ | 功能描述:IC REG CTRLR BUCK PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6315CRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6315CRZ-TK | 功能描述:IC REG CTRLR BUCK PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6315IRZ | 功能描述:IC REG CTRLR BUCK PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6315IRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。