- 您现在的位置：买卖IC网 > PDF目录15164 > ISL6326CRZ-T (Intersil)IC REG CTRLR BUCK PWM VM 40-QFN PDF资料下载
参数资料
| 型号： | ISL6326CRZ-T |
| 厂商： | Intersil |
| 文件页数： | 10/30页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 40-QFN |
| 标准包装： | 4,000 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 275kHz |
| 占空比： | 25% |
| 电源电压： | 4.75 V ~ 5.25 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 40-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
ISL6326
inductor current. Therefore, the sense current is proportional
to the inductor current, and scaled by the DCR of the
inductor and R ISEN .
To match the time delay of the internal circuit, a capacitor is
needed between each ISEN+ pin and GND, as described in
“Current Sensing” on page 12.
VR_RDY
VR_RDY indicates that soft-start has completed and the
output voltage is within the regulated range around VID
setting. It is an open-drain logic output. When OCP or OVP
occurs, VR_RDY will be pulled to low. It will also be pulled
low if the output voltage is below the undervoltage threshold.
OFS
The OFS pin can be used to program a DC offset current
which will generate a DC offset voltage between the REF
and DAC pins. The offset current is generated via an
external resistor and precision internal voltage references.
The polarity of the offset is selected by connecting the
resistor to GND or VCC. For no offset, the OFS pin should
be left unterminated.
TCOMP
Temperature compensation scaling input. The voltage
sensed on the TM pin is utilized as the temperature input to
adjust ldroop and the overcurrent protection limit to
effectively compensate for the temperature coefficient of the
current sense element. To implement the integrated
temperature compensation, a resistor divider circuit is
needed with one resistor being connected from TCOMP to
VCC of the controller and another resistor being connected
from TCOMP to GND. Changing the ratio of the resistor
values will set the gain of the integrated thermal
compensation. When integrated temperature compensation
function is not used, connect TCOMP to GND.
IDROOP
IDROOP is the output pin of the sensed average channel
current which is proportional to the load current. In the
application which does not require loadline, this pin can be
connected to GND through a resistor to generate a voltage
signal, which is proportional the load current and the resistor
value. In the application which requires load line, connect
this pin to FB so that the sensed average current will flow
through the resistor between FB and VDIFF to create a
voltage drop which is proportional to load current. Tie this pin
to GND if not used.
TM
TM is an input pin for the VR temperature measurement.
Connect this pin through an NTC thermistor to GND and a
resistor to VCC of the controller. The voltage at this pin is
reverse proportional to the VR temperature. ISL6326
monitors the VR temperature based on the voltage at the TM
pin and outputs VR_HOT and VR_FAN signals.
10
VR_HOT
VR_HOT is used as an indication of high VR temperature. It
is an open-drain logic output. It will be pulled low if the
measured VR temperature is less than a certain level, and
open when the measured VR temperature reaches a certain
level. A external pull-up resistor is needed.
VR_FAN
VR_FAN is an output pin with open-drain logic output. It will
be pulled low if the measured VR temperature is less than a
certain level, and open when the measured VR temperature
reaches a certain level. An external pull-up resistor is
needed.
Operation
Multiphase Power Conversion
Microprocessor load current profiles have changed to the
point that the advantages of multiphase power conversion
are impossible to ignore. The technical challenges
associated with producing a single-phase converter which is
both cost-effective and thermally viable have forced a
change to the cost-saving approach of multiphase. The
ISL6326 controller helps reduce the complexity of
implementation by integrating vital functions and requiring
4, and 5 provide top level views of multiphase power
conversion using the ISL6326 controller.
Interleaving
The switching of each channel in a multiphase converter is
timed to be symmetrically out-of-phase with each of the
other channels. In a 3-phase converter, each channel
switches 1/3 cycle after the previous channel and 1/3 cycle
before the following channel. As a result, the 3-phase
converter has a combined ripple frequency 3x greater than
the ripple frequency of any one phase. In addition, the
peak-to-peak amplitude of the combined inductor currents is
reduced in proportion to the number of phases
(Equations 1 and 2). Increased ripple frequency and lower
ripple amplitude mean that the designer can use less
per-channel inductance and lower total output capacitance
for any performance specification.
Figure 1 illustrates the multiplicative effect on output ripple
frequency. The three channel currents (IL1, IL2, and IL3)
combine to form the AC ripple current and the DC load
current. The ripple component has 3x the ripple frequency of
each individual channel current. Each PWM pulse is
terminated 1/3 of a cycle after the PWM pulse of the previous
phase. The DC components of the inductor currents combine
to feed the load.
FN9262.1
May 5, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| ECM24DTBS-S189 | CONN EDGECARD 48POS R/A .156 SLD |
| UVR1A223MRD6 | CAP ALUM 22000UF 10V 20% RADIAL |
| ECM25DTBN-S189 | CONN EDGECARD 50POS R/A .156 SLD |
| CAT1022ZI-30-GT3 | IC SUPERVISOR CPU 2K EEPR 8MSOP |
| GCC61DCSH-S288 | CONN EDGECARD 122POS .100 EXTEND |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6326CRZ-TR5453 | 制造商:Intersil Corporation 功能描述:STD. ISL6326CRZ-T W/GOLD BOND WIRE ONLY - Tape and Reel |
| ISL6326IRZ | 功能描述:电流型 PWM 控制器 W/ANNEAL 4-PHS VR11 CNTRLR IND RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL6326IRZ-T | 功能描述:电流型 PWM 控制器 W/ANNEAL 4-PHS VR11 CNTRLR IND RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
| ISL6327ACRZ | 功能描述:IC REG CTRLR BUCK PWM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6327ACRZ-T | 功能描述:IC REG CTRLR BUCK PWM 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。