参数资料
| 型号： | ISL6336BCRZ |
| 厂商： | Intersil |
| 文件页数： | 21/31页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR PWM SYNC BUCK 48-QFN |
| 标准包装： | 43 |
| 应用： | 控制器，Intel VR11.1 |
| 输入电压： | 3 V ~ 12 V |
| 输出数： | 1 |
| 输出电压： | 0.5 V ~ 1.6 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 48-VFQFN 裸露焊盘 |
| 供应商设备封装： | 48-QFN（7x7） |
| 包装： | 管件 |
| 产品目录页面： | 1248 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页
ISL6336B
IMON to offset for the tolerance at the maximum IMON
voltage value. This can be done by connecting a resistor
from the IMON pin to VCC as shown in Figure 11. The
required value for R VCC can be determined by using
Equation 18:
VR_RDY Signal
The VR_RDY pin is an open-drain logic output to indicate
that the soft-start period is completed and the output voltage
is within the regulated range. VR_RDY is pulled low during
shutdown and releases high after a successful soft-start and
V IMONOFS
R IMON ? ( VCC – V IMONOFS – V IMONMAX )
R VCC = ---------------------------------------------------------------------------------------------------------------------
(EQ. 18)
a fixed delay time, t D5 (see Figure 9). VR_RDY will be pulled
low when an undervoltage, overvoltage, or overcurrent
condition is detected, or if the controller is disabled by a
where R IMON is the resistor from IMON to GND, V IMONOFS
is the desired offset voltage at V IMONMAX , and V IMONMAX
is the voltage at IMON at the maximum load current.
For example, if the maximum IMON voltage is 900mV at full
load and the required offset voltage is 50mV and R IMON is
10k Ω then R VCC should be 810k Ω . R IMON should be
connected to GND near the load to increase accuracy.
reset from EN_PWR, EN_VTT, POR, or VID OFF-code.
Undervoltage Detection
The undervoltage threshold is set at 50% of the VID voltage.
When the output voltage at VSEN is below the undervoltage
threshold, VR_RDY gets pulled low. When the output voltage
comes back to 60% of the VID voltage, VR_RDY will return
back to high.
EXTERNAL CIRCUIT
V CC
ISL6336B
INTERNAL CIRCUIT
Overvoltage Protection
Regardless of the VR being enabled or not, the ISL6336B
overvoltage protection (OVP) circuit will be active after its
R VCC
R IMON
C IMON
IMON
+
V IMON
-
I AVG
POR. The OVP thresholds are different under different
operation conditions. When VR is not enabled and before the
2nd soft-start, the OVP threshold is 1.275V. Once the
controller detects a valid VID input, the OVP trip point will be
changed to the VID voltage plus 175mV.
Two actions are taken by the ISL6336B to protect the
microprocessor load when an overvoltage condition occurs.
NEAR LOAD GND
FIGURE 11. IMON RESISTOR DIVIDER
Fault Monitoring and Protection
The ISL6336B actively monitors output voltage and current to
detect fault conditions. Fault monitors trigger protective
measures to prevent damage to a microprocessor load. One
common power good indicator is provided for linking to external
system monitors. The schematic in Figure 12 outlines the
interaction between the fault monitors and the VR_RDY signal.
VR_RDY
UV
50%
At the inception of an overvoltage event, all PWM outputs are
commanded low instantly (in less than 20ns). This causes the
Intersil drivers to turn on the lower MOSFETs and pull the
output voltage down to avoid damaging the load. When the
voltage at VDIFF falls below the DAC plus 75mV, PWM
signals enter a high-impedance state. The Intersil drivers
respond to the high-impedance input by turning off both upper
and lower MOSFETs. If the overvoltage condition reoccurs,
the ISL6336B will again command the lower MOSFETs to turn
on. The ISL6336B will continue to protect the load in this
fashion as long as the overvoltage condition occurs.
Once an overvoltage condition is detected, normal PWM
operation ceases until the ISL6336B is reset. Cycling the
voltage on EN_PWR, EN_VTT or VCC below the POR-
falling threshold will reset the controller. Cycling the VID
codes will not reset the controller.
Overcurrent Protection
DAC
SOFT-START, FAULT
AND CONTROL LOGIC
OC
-
+
105μA
I AVG
ISL6336B has two levels of overcurrent protection. Each
phase is protected from a sustained overcurrent condition by
limiting its peak current, while the combined phase currents
are protected on an instantaneous basis.
VDIFF
+
-
OV
-
OC
+
1.11V
I MON
In instantaneous protection mode, the ISL6336B utilizes the
sensed average current I AVG to detect an overcurrent
condition. See “Channel-Current Balance” on page 15 for
VID + 0.175V
FIGURE 12. VR_RDY AND PROTECTION CIRCUITRY
21
more detail on how the average current is measured. The
average current is continually compared with a constant
105μA reference current, as shown in Figure 12. Once the
FN6696.2
August 31, 2010
相关PDF资料 |
PDF描述 |
|---|---|
| ISL6336IRZ | IC CTRLR PWM 6PHASE BUCK 48-QFN |
| ISL6341CIRZ | IC REG CTRLR BUCK PWM VM 10-TDFN |
| ISL6353IRTZ | IC CONTROLLER DDR VR12 40TQFN |
| ISL6363IRTZ-T | IC CONTROLLER VR12 48TQFN |
| ISL6401CR-T | IC REG CTRLR BST FLYBK ISO 16QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6336BCRZ-T | 功能描述:IC CTRLR PWM SYNC BUCK 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6336BIRZ | 功能描述:IC CTRLR PWM SYNC BUCK 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,000 系列:- 应用:电源，ICERA E400，E450 输入电压:4.1 V ~ 5.5 V 输出数:10 输出电压:可编程 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:42-WFBGA，WLCSP 供应商设备封装:42-WLP 包装:带卷 (TR) |
| ISL6336BIRZ-T | 功能描述:IC CTRLR PWM SYNC BUCK 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6336CRZ | 功能描述:IC CTRLR PWM 6PHASE BUCK 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
| ISL6336CRZ-T | 功能描述:IC CTRLR PWM 6PHASE BUCK 48-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 专用型 系列:- 标准包装:43 系列:- 应用:控制器，Intel VR11 输入电压:5 V ~ 12 V 输出数:1 输出电压:0.5 V ~ 1.6 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:48-VFQFN 裸露焊盘 供应商设备封装:48-QFN（7x7） 包装:管件 |
发布紧急采购，3分钟左右您将得到回复。