参数资料
| 型号： | ISL6568IRZ-TR5184 |
| 厂商： | Intersil |
| 文件页数： | 9/30页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR PWM 2PHASE BUCK 32-QFN |
| 标准包装： | 6,000 |
| 应用： | 控制器，Intel VRM9，VRM10，AMD Hammer 应用 |
| 输入电压： | 3 V ~ 12 V |
| 输出数： | 1 |
| 输出电压： | 0.84 V ~ 1.6 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 供应商设备封装： | 32-QFN（5x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
ISL6568
VSEN and RGND
VSEN and RGND are inputs to the precision differential
remote-sense amplifier and should be connected to the sense
pins of the remote load.
ICOMP, ISUM, and IREF
ISUM, IREF, and ICOMP are the DCR current sense amplifier’s
negative input, positive input, and output respectively. For
accurate DCR current sensing, connect a resistor from each
channel’s phase node to ISUM and connect IREF to the
summing point of the output inductors, roughly V OUT . A parallel
R-C feedback circuit connected between ISUM and ICOMP will
then create a voltage from IREF to ICOMP proportional to the
voltage drop across the inductor DCR. This voltage is referred to
as the droop voltage and is added to the differential
remote-sense amplifier output.
Note: An optional 0.01μF ceramic capacitor can be placed
from the IREF pin to the ISUM pin to help reduce any noise
affects that may occur due to layout.
VDIFF
VDIFF is the output of the differential remote-sense amplifier.
The voltage on this pin is equal to the difference between VSEN
and RGND added to the difference between IREF and ICOMP.
VDIFF therefore represents the output voltage plus the droop
voltage.
FB and COMP
These pins are the internal error amplifier inverting input and
output respectively. FB, VDIFF, and COMP are tied together
through external R-C networks to compensate the regulator.
REF
The REF input pin is the positive input of the error amplifier. It is
internally connected to the DAC output through a 1k Ω resistor. A
capacitor is used between the REF pin and ground to smooth
the voltage transition during Dynamic VID operations.
OFS
The OFS pin provides a means to program a dc current for
generating an offset voltage across the resistor between FB and
VDIFF. The offset current is generated via an external resistor
and precision internal voltage references. The polarity of the
offset is selected by connecting the resistor to GND or VCC. For
no offset, the OFS pin should be left unconnected.
OCSET
This is the overcurrent set pin. Placing a resistor from OCSET to
ICOMP allows a 100 μ A current to flow out this pin, producing a
voltage reference. Internal circuitry compares the voltage at
OCSET to the voltage at ISUM, and if ISUM ever exceeds OCSET,
the overcurrent protection activates.
ISEN1 and ISEN2
These pins are used for balancing the channel currents by
UGATE1 and UGATE2
Connect these pins to the corresponding upper MOSFET gates.
These pins are used to control the upper MOSFETs and are
monitored for shoot-through prevention purposes. Maximum
individual channel duty cycle is limited to 66%.
BOOT1 and BOOT2
These pins provide the bias voltage for the corresponding
upper MOSFET drives. Connect these pins to
appropriately-chosen external bootstrap capacitors. Internal
bootstrap diodes connected to the PVCC pins provide the
necessary bootstrap charge.
PHASE1 and PHASE2
Connect these pins to the sources of the upper MOSFETs.
These pins are the return path for the upper MOSFET drives.
LGATE1 and LGATE2
These pins are used to control the lower MOSFETs. Connect
these pins to the corresponding lower MOSFETs’ gates.
PGOOD
During normal operation PGOOD indicates whether the output
voltage is within specified overvoltage and undervoltage limits.
If the output voltage exceeds these limits or a reset event occurs
(such as an overcurrent event), PGOOD is pulled low. PGOOD is
always low prior to the end of soft-start.
Operation
Multi-Phase Power Conversion
Microprocessor load current profiles have changed to the point
that the advantages of multi-phase power conversion are
impossible to ignore. The technical challenges associated with
producing a single-phase converter that is both cost-effective
and thermally viable have forced a change to the cost-saving
approach of multi-phase. The ISL6568 controller helps simplify
implementation by integrating vital functions and requiring
provides a top level view of multi-phase power conversion
using the ISL6568 controller.
IL1 + IL2 + IL3, 7A/DIV
IL3, 7A/DIV
PWM3, 5V/DIV
IL2, 7A/DIV
PWM2, 5V/DIV
IL1, 7A/DIV
sensing the current through each channel’s lower MOSFET
when it is conducting. Connect a resistor between the ISEN1
and ISEN2 pins and their respective phase node. This resistor
PWM1, 5V/DIV
1 μ s/DIV
sets a current proportional to the current in the lower MOSFET
during its conduction interval.
9
FIGURE 1. PWM AND INDUCTOR-CURRENT WAVEFORMS FOR
3-PHASE CONVERTER
FN9187.5
January 12, 2012
相关PDF资料 |
PDF描述 |
|---|---|
| ISL6568IRZA-T | IC CTRLR PWM BUCK 2PHASE 32-QFN |
| MIC5320-MFYML TR | IC REG LDO 2.8V/1.5V .15A 6-MLF |
| ISL6568IRZ-T | IC CTRLR PWM BUCK 2PHASE 32-QFN |
| LT1175CS8#PBF | IC REG LDO NEG ADJ .5A 8SOIC |
| ABC17DRES | CONN EDGECARD 34POS .100 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL6569ACB | 功能描述:IC REG CTRLR BUCK PWM 24-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
| ISL6569ACB-T | 功能描述:IC REG CTRLR BUCK PWM 24-SOIC RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
| ISL6569ACBZ | 功能描述:IC REG CTRLR BUCK PWM 24-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6569ACBZ-T | 功能描述:IC REG CTRLR BUCK PWM 24-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL6569ACR | 功能描述:IC REG CTRLR BUCK PWM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:100% 电源电压:8.2 V ~ 30 V 降压:无 升压:无 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:0°C ~ 70°C 封装/外壳:8-DIP（0.300"，7.62mm） 包装:管件 产品目录页面:1316 (CN2011-ZH PDF) |
发布紧急采购，3分钟左右您将得到回复。