- 您现在的位置：买卖IC网 > PDF目录15058 > ISL8103IRZ (Intersil)IC REG CTRLR BUCK PWM VM 40-QFN PDF资料下载
参数资料
| 型号： | ISL8103IRZ |
| 厂商： | Intersil |
| 文件页数： | 25/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 40-QFN |
| 标准包装： | 50 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1.5MHz |
| 占空比： | 66.6% |
| 电源电压： | 4.75 V ~ 12.6 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 40-VFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页
ISL8103
0.3
I L,P-P = 0
I L,P-P = 0.5 I O
0.6
0.2
0.1
I L,P-P = 0.25 I O
I L,P-P = 0.75 I O
0.4
0.2
I L,P-P = 0
I L,P-P = 0.5 I O
I L,P-P = 0.75 I O
0
0
0.2
0.4
0.6
0.8
1.0
0
0
0.2
0.4
0.6
0.8
1.0
DUTY CYCLE (V IN/ V O )
FIGURE 24. NORMALIZED INPUT-CAPACITOR RMS
CURRENT FOR 3-PHASE CONVERTER
For a three-phase design, use Figure 24 to determine the
input-capacitor RMS current requirement set by the duty
cycle, maximum sustained output current (I O ), and the ratio
of the peak-to-peak inductor current (I L,P-P ) to I O . Select a
bulk capacitor with a ripple current rating which will minimize
the total number of input capacitors required to support the
RMS current calculated. The voltage rating of the capacitors
should also be at least 1.25 times greater than the maximum
input voltage. Figures 25 and 26 provide the same input
RMS current information for two-phase and single-phase
designs respectively. Use the same approach for selecting
the bulk capacitor type and number.
0.3
0.2
0.1
I L,P-P = 0
I L,P-P = 0.5 I O
I L,P-P = 0.75 I O
DUTY CYCLE (V IN /V O )
FIGURE 26. NORMALIZED INPUT-CAPACITOR RMS
CURRENT FOR SINGLE-PHASE CONVERTER
Low ESL, high-frequency ceramic capacitors are needed in
addition to the input bulk capacitors to suppress leading and
falling edge voltage spikes. The spikes result from the high
current slew rate produced by the upper MOSFET turn on
and off. Place them as close as possible to each upper
MOSFET drain to minimize board parasitics and maximize
suppression.
Layout Considerations
MOSFETs switch very fast and efficiently. The speed with
which the current transitions from one device to another
causes voltage spikes across the interconnecting
impedances and parasitic circuit elements. These voltage
spikes can degrade efficiency, radiate noise into the circuit
and lead to device overvoltage stress. Careful component
layout and printed circuit design minimizes the voltage
spikes in the converter. Consider, as an example, the turnoff
transition of the upper PWM MOSFET. Prior to turnoff, the
upper MOSFET was carrying channel current. During the
turnoff, current stops flowing in the upper MOSFET and is
picked up by the lower MOSFET. Any inductance in the
switched current path generates a large voltage spike during
the switching interval. Careful component selection, tight
layout of the critical components, and short, wide circuit
traces minimize the magnitude of voltage spikes.
0
0
0.2
0.4
0.6
0.8
1.0
There are two sets of critical components in a DC/DC
converter using a ISL8103 controller. The power
DUTY CYCLE (V IN/ V O )
FIGURE 25. NORMALIZED INPUT-CAPACITOR RMS
CURRENT FOR 2-PHASE CONVERTER
25
components are the most critical because they switch large
amounts of energy. Next are small signal components that
connect to sensitive nodes or supply critical bypassing
current and signal coupling.
It is important to have a symmetrical layout, preferably with
the controller equidistantly located from the three power
trains it controls. Equally important are the gate drive lines
(UGATE, LGATE, PHASE): since they drive the power train
FN9246.1
July 21, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| RSM08DTMT-S189 | CONN EDGECARD 16POS R/A .156 SLD |
| ISL6845IU | IC REG CTRLR BST FLYBK ISO 8MSOP |
| ISL6845IB-T | IC REG CTRLR BST FLYBK ISO 8SOIC |
| RGM08DTMT-S189 | CONN EDGECARD 16POS R/A .156 SLD |
| HMM10DRKF | CONN EDGECARD 20POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL8103IRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:75 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.3 V ~ 13.5 V 降压:是 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:0°C ~ 70°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:管件 产品目录页面:1051 (CN2011-ZH PDF) 其它名称:296-2543-5 |
| ISL8104 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Synchronous Buck Pulse-Width Modulator (PWM) Controller |
| ISL8104CBZ | 功能描述:IC REG CTRLR BUCK PWM VM 14-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL8104CBZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 14-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL8104CRZ | 功能描述:IC REG CTRLR BUCK PWM VM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。