- 您现在的位置：买卖IC网 > PDF目录15058 > ISL8103IRZ (Intersil)IC REG CTRLR BUCK PWM VM 40-QFN PDF资料下载
参数资料
| 型号： | ISL8103IRZ |
| 厂商： | Intersil |
| 文件页数： | 9/28页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 40-QFN |
| 标准包装： | 50 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 1.5MHz |
| 占空比： | 66.6% |
| 电源电压： | 4.75 V ~ 12.6 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 40-VFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
ISL8103
PHASE1, PHASE2, and PHASE3 (Pins 29, 28, 22)
Connect these pins to the sources of the upper MOSFETs.
These pins are the return path for the upper MOSFETs’
drives.
LGATE1, LGATE2, and LGATE3 (Pins 34, 23, 17)
These pins are used to control the lower MOSFETs and are
monitored for shoot-through prevention purposes. Connect
these pins to the lower MOSFETs’ gates. Do not use
external series gate resistors as this might lead to
shoot-through.
PGOOD (Pin 35)
PGOOD is used as an indication of the end of soft-start. It is
an open-drain logic output that is low impedance until the
soft-start is completed and VOUT is equal to the VID setting.
Once in normal operation PGOOD indicates whether the
output voltage is within specified overvoltage and
undervoltage limits. If the output voltage exceeds these limits
or a reset event occurs (such as an overcurrent event),
PGOOD becomes high impedance again. The potential at
this pin should not exceed that of the potential at VCC pin by
more than a typical forward diode drop at any time.
OVP (Pin 38)
Overvoltage protection pin. This pin pulls to VCC when an
overvoltage condition is detected. Connect this pin to the
gate of an SCR or MOSFET tied across V IN and ground to
prevent damage to a load device.
Operation
Mulitphase Power Conversion
per-channel inductance and lower total output capacitance
for any performance specification.
Figure 1 illustrates the multiplicative effect on output ripple
frequency. The three channel currents (I L1 , I L2 , and I L3 )
combine to form the AC ripple current and the DC load
current. The ripple component has three times the ripple
frequency of each individual channel current. Each PWM
pulse is terminated 1/3 of a cycle after the PWM pulse of the
previous phase. The peak-to-peak current for each phase is
about 7A, and the dc components of the inductor currents
combine to feed the load.
I L1 + I L2 + I L3 , 7A/DIV
I L3 , 7A/DIV
PWM3, 5V/DIV
I L2 , 7A/DIV
PWM2, 5V/DIV
I L1 , 7A/DIV
PWM1, 5V/DIV
FIGURE 1. PWM AND INDUCTOR-CURRENT WAVEFORMS
FOR 3-PHASE CONVERTER
To understand the reduction of ripple current amplitude in the
multiphase circuit, examine the equation representing an
individual channel peak-to-peak inductor current.
( V IN – V OUT ) ? V OUT
L ? F SW ? V IN
Modern low voltage DC/DC converter load current profiles
have changed to the point that the advantages of multiphase
power conversion are impossible to ignore. The technical
I PP = ----------------------------------------------------------
(EQ. 1)
challenges associated with producing a single-phase
converter that is both cost-effective and thermally viable
have forced a change to the cost-saving approach of
mulitphase. The ISL8103 controller helps simplify
implementation by integrating vital functions and requiring
provides a top level view of mulitphase power conversion
using the ISL8103 controller.
Interleaving
The switching of each channel in a mulitphase converter is
timed to be symmetrically out-of-phase with each of the
other channels. In a 3-phase converter, each channel
switches 1/3 cycle after the previous channel and 1/3 cycle
before the following channel. As a result, the three-phase
converter has a combined ripple frequency three times
In Equation 1, V IN and V OUT are the input and output
voltages respectively, L is the single-channel inductor value,
and F SW is the switching frequency.
The output capacitors conduct the ripple component of the
inductor current. In the case of multiphase converters, the
capacitor current is the sum of the ripple currents from each
of the individual channels. Compare Equation 1 to the
expression for the peak-to-peak current after the summation
of N symmetrically phase-shifted inductor currents in
Equation 2. Peak-to-peak ripple current decreases by an
amount proportional to the number of channels. Output
voltage ripple is a function of capacitance, capacitor
equivalent series resistance (ESR), and inductor ripple
current. Reducing the inductor ripple current allows the
designer to use fewer or less costly output capacitors.
L ? F SW ? V
greater than the ripple frequency of any one phase. In
addition, the peak-to-peak amplitude of the combined
inductor currents is reduced in proportion to the number of
phases (Equations 1 and 2). Increased ripple frequency and
lower ripple amplitude mean that the designer can use less
9
( V IN – N ? V OUT ) ? V OUT
I C , P – P = --------------------------------------------------------------------
IN
(EQ. 2)
FN9246.1
July 21, 2008
相关PDF资料 |
PDF描述 |
|---|---|
| RSM08DTMT-S189 | CONN EDGECARD 16POS R/A .156 SLD |
| ISL6845IU | IC REG CTRLR BST FLYBK ISO 8MSOP |
| ISL6845IB-T | IC REG CTRLR BST FLYBK ISO 8SOIC |
| RGM08DTMT-S189 | CONN EDGECARD 16POS R/A .156 SLD |
| HMM10DRKF | CONN EDGECARD 20POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL8103IRZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 40-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:75 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.3 V ~ 13.5 V 降压:是 升压:是 回扫:是 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:0°C ~ 70°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:管件 产品目录页面:1051 (CN2011-ZH PDF) 其它名称:296-2543-5 |
| ISL8104 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Synchronous Buck Pulse-Width Modulator (PWM) Controller |
| ISL8104CBZ | 功能描述:IC REG CTRLR BUCK PWM VM 14-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL8104CBZ-T | 功能描述:IC REG CTRLR BUCK PWM VM 14-SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL8104CRZ | 功能描述:IC REG CTRLR BUCK PWM VM 16-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。