- 您现在的位置：买卖IC网 > PDF目录15163 > ISL8126IRZ-TK (Intersil)IC REG CTRLR BUCK PWM VM 32-QFN PDF资料下载
参数资料
| 型号： | ISL8126IRZ-TK |
| 厂商： | Intersil |
| 文件页数： | 25/39页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 32-QFN |
| 标准包装： | 1,000 |
| PWM 型： | 电压模式 |
| 输出数： | 2 |
| 频率 - 最大： | 1.5MHz |
| 占空比： | 90% |
| 电源电压： | 3 V ~ 5.6 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页
ISL8126
Functional Description
Initialization
Initially, the ISL8126 Power-On Reset (POR) circuits continually
monitor the bias voltages (PVCC and VCC) and the voltage at the
EN/VFF pin. The POR function initiates soft-start operation 192
clock cycles after the following conditions are met:
? VCC and PVCC voltages exceed their POR thresholds.
? PLL locking time has expired.
? EN/VFF pin voltage is pulled to be above 0.8V.
? For Channel 1 only, ISHARE voltage must fall below 70%
(typical) of VCC.
ISHARE is also pulled to VCC when Channel1 detects fault
conditions or EN/VFF1 is below its POR threshold. ISHARE is
released from VCC after EN/VFF1’s voltage higher than its POR
threshold for 16 switching cycles; therefore, there is 176 cycles
delay from ISHARE falls to 0.7*VCC to the beginning of soft start.
HIGH = ABOVE POR; LOW = BELOW POR
COMPARATOR
During shutdown or fault conditions, the soft-start is reset quickly
while UGATE and LGATE change states immediately (<100ns)
upon the input drop below falling POR. The soft-start initialization
circuit is shown in Figure 10.
The EN/VFF pin can be used as a voltage monitor and to set
desired hysteresis with an internal 30 μ A sinking current going
through an external resistor divider. The sinking current is
disengaged after the system is enabled. This feature is especially
designed for applications that require higher input rail POR for
better undervoltage protection. For example, in single-phase 12V
input applications, R UP = 53.6k and R DOWN = 5.23k will set the
turn-on threshold (V EN_RTH ) to 10.6V and turn-off threshold
(V EN_FTH ) to 9V, with 1.6V hysteresis (V EN_HYS ).
There is an internal transistor, which will pull down the EN/VFF
pin under fault conditions. The multiphase system can
immediately turn off all ICs under fault conditions of one or more
phases by pulling all EN/VFF pins low. Thus, no bouncing occurs
among channels at fault and no single phase could carry all
current and be over stressed. The pull-up resistor (R UP ) should be
scaled to sink no more than 5mA current to the EN/VFF pin.
Essentially, the EN/FF pins cannot be directly connected to VCC.
0.7*VCC
ISHARE
+
-
VCC POR
PVCC POR
EN/VFF1 POR
AND
176
Cycles
SOFT-START
OF CHANNEL 1
PLL LOCKING
SOFT-START
VCC POR
PVCC POR
AND
192
Cycles
OF CHANNEL 2
EN/VFF2 POR
FIGURE 10. SOFT-START INITIALIZATION LOGIC
Nx I EN_HYS
V EN_FTH – V EN_REF
V EN_HYS
R UP = --------------------------------
R UP ? V EN_REF
R DOWN = -------------------------------------------------------
VCC
where N is number of EN/VFF pins connected together
G RAMP = 1.25
VCC - 1.4V
V
EN_FTH
= V
EN_RTH
– V
EN_HYS
∑
UPPER LIMIT
= max (V CC_FF × G
Δ V
)
RAMP RAMP
V CC_FF = max(0.8V, V ENFF )
, VCC - 1.4V - V
RAMP_OFFSET
VIN
0.8V
V CC_FF
LIMITER
V RAMP_OFFSET = 1.0V
SAWTOOTH
AMPLITUDE
( Δ V RAMP )
LOWER LIMIT
(RAMP OFFSET)
0.8V
R UP
EN/VFF
EN_POR
SYSTEM DELAY
R DOWN
I EN_HYS = 30μA
OV, OT, OC, AND PLL LOCKING FAULTS (ONLY FOR EN/VFF1)
FIGURE 11. SIMPLIFIED ENABLE AND VOLTAGE FEEDFORWARD CIRCUIT
25
FN7892.1
August 16, 2012
相关PDF资料 |
PDF描述 |
|---|---|
| VE-J5M-EY-F1 | CONVERTER MOD DC/DC 10V 50W |
| VE-2TV-EW-F3 | CONVERTER MOD DC/DC 5.8V 100W |
| ISL8126IRZ-T | IC REG CTRLR BUCK PWM VM 32-QFN |
| VE-2TV-EW-F2 | CONVERTER MOD DC/DC 5.8V 100W |
| VE-2TV-EW-F1 | CONVERTER MOD DC/DC 5.8V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL8128IAZ-TK | 制造商:Intersil Corporation 功能描述:PB-FREE SYNC BUCK PWM CONT. W/ 4.5V-28V |
| ISL8130 | 制造商:INTERSIL 制造商全称:Intersil Corporation 功能描述:Advanced Single Universal Pulse-Width Modulation (PWM) Controller |
| ISL8130EVAL3Z | 制造商:Intersil Corporation 功能描述:ISL8130 EVALUATION BOARD 3 - 20LD QSOP - ROHS COMPLIANT - Bulk 制造商:Intersil Corporation 功能描述:BOARD EVAL FOR ISL8130 制造商:Intersil Corporation 功能描述:ISL8130 EVALUATION BOARD 3 - 20LD QSOP - RoHS COMPLIANT |
| ISL8130IAZ | 功能描述:IC REG CTRLR BST FLYBK VM 20QSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:275kHz 占空比:50% 电源电压:18 V ~ 110 V 降压:无 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:是 工作温度:-40°C ~ 85°C 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 包装:带卷 (TR) |
| ISL8130IAZ-T7A | 功能描述:电流型 PWM 控制器 PB-FREE SYNC BUCK PWM CONT. W/ 4.5V-28V INPUT,20LD QSOP, 250 RoHS:否 制造商:Texas Instruments 开关频率:27 KHz 上升时间: 下降时间: 工作电源电压:6 V to 15 V 工作电源电流:1.5 mA 输出端数量:1 最大工作温度:+ 105 C 安装风格:SMD/SMT 封装 / 箱体:TSSOP-14 |
发布紧急采购，3分钟左右您将得到回复。