- 您现在的位置：买卖IC网 > PDF目录17314 > ISL8200MEVAL1PHZ (Intersil)EVAL BAORD FOR ISL8200 PDF资料下载
参数资料
| 型号： | ISL8200MEVAL1PHZ |
| 厂商： | Intersil |
| 文件页数： | 16/23页 |
| 文件大小： | 0K |
| 描述： | EVAL BAORD FOR ISL8200 |
| 产品培训模块： | Solutions for Industrial Control Applications |
| 标准包装： | 1 |
| 主要目的： | DC/DC，步降 |
| 输出及类型： | 1，非隔离 |
| 输出电压： | 0.6 ~ 6 V |
| 电流 - 输出： | 10A |
| 输入电压： | 3 ~ 20 V |
| 稳压器拓扑结构： | 降压 |
| 频率 - 开关： | 700kHz ~ 1.5MHz |
| 板类型： | 完全填充 |
| 已供物品： | 板 |
| 已用 IC / 零件： | ISL8200 |
ISL8200M
Power Good
The Power-Good comparators monitor the voltage on the
internal VMON1 pin. The trip points are shown in
Figure 26. PGOOD will not be asserted until after the
completion of the soft-start cycle. The PGOOD pulls low
upon both EN’s disabling it or the internal VMON1 pin’ s
voltage is out of the threshold window. PGOOD will not
be asserted until after the completion of the soft-start
cycle. PGOOD will not pull low until the fault presents for
three consecutive clock cycles.
The UV indication is not enabled until the end of
soft-start. In a UV event, if the output drops below
-13% of the target level due to some reason (cases
when EN is not pulled low) other than OV, OC, OT, and
PLL faults, PGOOD will be pulled low.
CHANNEL 1 UV/OV
Overvoltage Protection (OVP)
The Overvoltage (OV) protection indication circuitry
monitor the voltage on the internal VMON1 pin.
OV protection is active from the beginning of
soft-start. An OV condition (>120%) would latch IC off
(the high-side MOSFET to latch off permanently; the
low-side MOSFET turns on immediately at the time of
OV trip and then turns off permanently after the output
voltage drops below 87%). The EN and PGOOD are
also latched low at OV event. The latch condition can
be reset only by recycling V CC .
There is another non-latch OV protection (113% of
target level). At the condition of EN low and the output
over 113% OV, the lower side MOSFET will turn on until
the output drops below 87%. This is to protect the
overall power trains in case of a single channel of a
multi-module system detecting OV. The low-side MOSFET
END OF SS1
AND
PGOOD
always turns on at the conditions of EN = LOW and the
output voltage above 113% (all EN pins are tied
together) and turns off after the output drops below
+20%
87%. Thus, in a high phase count application
(multi-module mode), all cascaded modules can latch off
VMON1
PGOOD
+13%
+9%
V REF
-9%
-13%
PGOOD latch off after 120% OV
simultaneously via the EN pins (EN pins are tied together
in multiphase mode), and each IC shares the same sink
current to reduce the stress and eliminate the bouncing
among phases.
Over-Temperature Protection (OTP)
When the junction temperature of the IC is greater than
+150°C (typically), EN pin will be pulled low to inform
other cascaded channels via their EN pins. All connected
ENs stay low and release after the IC’s junction
temperature drops below +125°C (typically), a +25°C
hysteresis (typically).
FIGURE 26. POWER-GOOD THRESHOLD WINDOW
Current Share
The IAVG_CS is the current of the module. ISHARE and
ISET pins source a copy of IAVG_CS with 15μA offset,
i.e., the full scale will be 123μA.
The share bus voltage (VISHARE) set by an external
resistor (RISHARE = RISET/NCTRL) represents the
average current of all active modules. The voltage
(VISET) set by RISET represents the average current of
the corresponding module and is compared with the
share bus (VISHARE). The current share error signal
(ICSH_ER) is then fed into current correction block to
adjust each module’s PWM pulse accordingly. The current
share function provides at least 10% overall accuracy
between ICs, when using 1% resistor to sense 10mV
signal. The current share bus works for up to 6-phase.
When there is only one module in the system, the ISET
and ISHARE pins can be shorted together and
grounded via a single resistor to ensure zero share
error - a resistor value of 5k (paralleling 10k on ISET
and ISHARE) will allow operation up to the OCP level
16
Overcurrent Protection (OCP)
The OCP function is enabled at startup. The module’s
output current (I CS1 ) plus a fixed internal 15μA offset
forms a voltage (V ISHARE ) across the external resistor,
R ISHARE . V ISHARE is compared with a precision
internal 1.2V threshold. The Channel Overcurrent Limit
‘108μA OCP’ comparator, waits 7-cycles before
monitoring for an OCP condition.
In multi-module operation, by connecting modules’
ISHARE pin together, results in the V ISHARE
representing the average current of all active channels.
The total system currents are compared with a
precision 1.2V threshold to determine the overcurrent
condition as well as each channel having additional
overcurrent trip point at 108μA with 7-cycle delay. This
scheme helps protect from damaging a module(s) in
multi-module mode by not having a single module
carrying more than 108μA. Note that it is not
necessary for the R ISHARE to be scaled to trip at the
same level as the 108μA OCP comparator. Typically the
ISHARE pin average current protection level should be
higher than the phase current protection level. For
instance, when Channel 1 operates independently, the
FN6727.1
February 26, 2010
相关PDF资料 |
PDF描述 |
|---|---|
| ECM10DSXH | CONN EDGECARD 20POS DIP .156 SLD |
| ISL8105AEVAL1Z | EVALUATION BOARD FOR ISL8105A |
| EBM12DSES | CONN EDGECARD 24POS .156 EYELET |
| EBM10DSEI | CONN EDGECARD 20POS .156 EYELET |
| EEM15DRYS | CONN EDGECARD 30POS DIP .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ISL8200MEVAL2PHZ | 功能描述:电源管理IC开发工具 ISL8200M EVAL BBRD 2 PHS 23LD ROH RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| ISL8200MIRZ | 功能描述:DC/DC转换器 STAND ALONE 10A DC/D CSTEPDWNPWRSUPPYMOD1 RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| ISL8200MIRZ-T | 功能描述:DC/DC转换器 ST& ALONE 10A DC/DC DWN PWR SUPPLY MOD RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| ISL8200MIRZ-TR5545 | 制造商:Intersil Corporation 功能描述:STAND ALONE 10A DC/DC STEP DOWN POWER SUPPLY MODULE, 15 X 15 - Tape and Reel |
| ISL8200MMREP | 制造商:Intersil Corporation 功能描述:V62/10608-01XB, STAND ALONE 10A DC/DC STEP DOWN POWER SUPPLY - Trays |
发布紧急采购，3分钟左右您将得到回复。