- 您现在的位置：买卖IC网 > PDF目录11593 > KSZ8873FLL (Micrel Inc)IC ETHERNET SW 3PORT 64LQFP PDF资料下载
参数资料
| 型号： | KSZ8873FLL |
| 厂商： | Micrel Inc |
| 文件页数： | 52/115页 |
| 文件大小： | 0K |
| 描述： | IC ETHERNET SW 3PORT 64LQFP |
| 产品培训模块： | KSZ8873 Ethernet Switches |
| 特色产品： | KSZ8873 Ethernet Switch Controller |
| 标准包装： | 160 |
| 控制器类型： | 以太网开关控制器 |
| 接口： | MII |
| 电源电压： | 1.8V，2.5V，3.3V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 64-LQFP |
| 供应商设备封装： | 64-LQFP（10x10） |
| 包装： | 托盘 |
| 其它名称： | 576-3631 KSZ8873FLL-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页当前第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页
Micrel, Inc.
KSZ8873MLL/FLL/RLL
September 20, 2013
41
Revision 1.6
All the packets received on port A and transmitted on port B are mirrored on the sniffer port. To turn on the “AND”
feature, set Register 5 bit [0] to ‘1’. For example, port 1 is programmed to be “receive sniff”, port 2 is programmed to
be “transmit sniff”, and port 3 is programmed to be the “sniffer port”. A packet received on port 1 is destined to port 2
after the internal lookup. The KSZ8873MLL/FLL/RLL forwards the packet to both port 2 and port 3.
Multiple ports can be selected as “receive sniff” or “transmit sniff”. In addition, any port can be selected as the “sniffer
port”. All these per port features can be selected through Registers 17, 33, and 49 for ports 1, 2 and 3, respectively.
Rate Limiting Support
The KSZ8873MLL/FLL/RLL provides a fine resolution hardware rate limiting from 64Kbps to 99Mbps. The rate step is
64Kbps when the rate range is from 64Kbps to 960Kbps and 1Mbps for 1Mbps to 100Mbps(100BT) or to 10Mbps(10BT)
(refer to Data Rate Limit Table). The rate limit is independently on the “receive side” and on the “transmit side” on a per
port basis. For 10BASE-T, a rate setting above 10 Mbps means the rate is not limited. On the receive side, the data
receive rate for each priority at each port can be limited by setting up Ingress Rate Control Registers. On the transmit
side, the data transmit rate for each priority queue at each port can be limited by setting up Egress Rate Control
Registers. The size of each frame has options to include minimum IFG (Inter Frame Gap) or Preamble byte, in addition to
the data field (from packet DA to FCS).
For ingress rate limiting, KSZ8873MLL/FLL/RLL provides options to selectively choose frames from all types, multicast,
broadcast, and flooded unicast frames. The KSZ8873MLL/FLL/RLL counts the data rate from those selected type of
frames. Packets are dropped at the ingress port when the data rate exceeds the specified rate limit.
For egress rate limiting, the Leaky Bucket algorithm is applied to each output priority queue for shaping output traffic. Inter
frame gap is stretched on a per frame base to generate smooth, non-burst egress traffic. The throughput of each output
priority queue is limited by the egress rate specified.
If any egress queue receives more traffic than the specified egress rate throughput, packets may be accumulated in the
output queue and packet memory. After the memory of the queue or the port is used up, packet dropping or flow control
will be triggered. As a result of congestion, the actual egress rate may be dominated by flow control/dropping at the
ingress end, and may be therefore slightly less than the specified egress rate.
To reduce congestion, it is a good practice to make sure the egress bandwidth exceeds the ingress bandwidth.
Unicast MAC Address Filtering
The unicast MAC address filtering function works in conjunction with the static MAC address table. First, the static MAC
address table is used to assign a dedicated MAC address to a specific port. If a unicast MAC address is not recorded in
the static table, it is also not learned in the dynamic MAC table. The KSZ8873MLL/FLL/RLL is then configured with the
option to either filter or forward unicast packets for an unknown MAC address. This option is enabled and configured in
Register 14.
This function is useful in preventing the broadcast of unicast packets that could degrade the quality of the port in
applications such as voice over Internet Protocol (VoIP).
Configuration Interface
The KSZ8873MLL/FLL/RLL can operate as both a managed switch and an unmanaged switch.
In unmanaged mode, the KSZ8873MLL/FLL/RLL is typically programmed using an EEPROM. If no EEPROM is present,
the KSZ8873MLL/FLL/RLL is configured using its default register settings. Some default settings are configured via strap-
in pin options. The strap-in pins are indicated in the “Pin Description and I/O Assignment” table.
I
2C Master Serial Bus Configuration
With an additional I
2C (“2-wire”) EEPROM, the KSZ8873MLL/FLL/RLL can perform more advanced switch features like
“broadcast storm protection” and “rate control” without the need of an external processor.
相关PDF资料 |
PDF描述 |
|---|---|
| VI-B6J-IW-F1 | CONVERTER MOD DC/DC 36V 100W |
| VI-B6H-IW-F2 | CONVERTER MOD DC/DC 52V 100W |
| VI-B6F-IX-F4 | CONVERTER MOD DC/DC 72V 75W |
| VI-B6F-IW-F2 | CONVERTER MOD DC/DC 72V 100W |
| VI-B6D-IX-F1 | CONVERTER MOD DC/DC 85V 75W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| KSZ8873FLL-EVAL | 功能描述:以太网开发工具 3-Port Fast Ethernet Switch with 2x FX Ports - Evaluation Board RoHS:否 制造商:Micrel 产品:Evaluation Boards 类型:Ethernet Transceivers 工具用于评估:KSZ8873RLL 接口类型:RMII 工作电源电压: |
| KSZ8873FLLI | 功能描述:以太网 IC 3-Port Fast Ethernet Switch with 2x FX Ports (Industrial Grade) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8873MLL | 功能描述:以太网 IC 3-Port Fast Ethernet Switch with 1x MII Interface - Lead Free RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8873MLL AM | 功能描述:以太网 IC 3-Port 10/100 Ethernet Switch with 1x MII Interface (Automotive Grade, Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
| KSZ8873MLL AM TR | 功能描述:以太网 IC 3-Port 10/100 Ethernet Switch with 1x MII Interface (Automotive Grade, Lead Free) RoHS:否 制造商:Micrel 产品:Ethernet Switches 收发器数量:2 数据速率:10 Mb/s, 100 Mb/s 电源电压-最大:1.25 V, 3.45 V 电源电压-最小:1.15 V, 3.15 V 最大工作温度:+ 85 C 封装 / 箱体:QFN-64 封装:Tray |
发布紧急采购，3分钟左右您将得到回复。