参数资料
| 型号： | LC75808W-E |
| 厂商： | ON Semiconductor |
| 文件页数： | 22/38页 |
| 文件大小： | 0K |
| 描述： | IC LCD DISPLAY DRIVER 100SQFP |
| 标准包装： | 60 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页
LC75808W
Key Scan Operation Functions
1. Key scan timing
The key scan period is 384T(s). To reliably determine the on/off state of the keys, the LC75808W scans the keys
twice and determines that a key has been pressed when the key data agrees. It outputs a key data read request (a low
level on DO) 800T(s) after starting a key scan. If the key data dose not agree and a key was pressed at that point, it
scans the keys again. Thus the LC75808W cannot detect a key press shorter than 800T(s).
KS1
KS2
KS3
*3
*3
*3
1
2
3
1
2
3
*3
*3
*3
KS4
KS5
KS6
*3
*3
*3
4
5
6
4
5
6
*3
*3
*3
T=
1
fosc
Key on
768T [s]
A12911
? If a key is pressed for longer than 800T(s) (Where T= fOSC ) the LC75808W outputs a key data read request (a low
Note: * 3. Note that the high/low states of these pins are determined by the KC1 to KC6 bits in the control data, and
that key scan output signals are not output from pins that are set to low.
2. In normal mode
? The pins KS1 to KS6 are set to high or low by the KC1 to KC6 bits in the control data.
? If a key on one of the lines corresponding to a KS1 to KS6 pin which is set high is pressed, a key scan is started
and the keys are scanned until all keys are released. Multiple key presses are recognized by determining whether
multiple key data bits are set.
1
level on DO) to the controller. The controller acknowledges this request and reads the key data. However, if CE is
high during a serial data transfer, DO will be set high.
? After the controller reads the key data, the key data read request is cleared (DO is set high) and the LC75808W
performs another key scan. Also note that DO, being an open-drain output, requires a pull-up resistor (between 1k Ω
and 10k Ω ).
Key input 1
Key input 2
Key scan
CE
800T [s ]
800T [s]
800T [s ]
Serial data
transfer
Serial data
transfer
Key address(43H)
Serial data
transfer
Key address
Key address
DI
DO
Key data read request
Key data read
Key data read
Key data read request
Key data read
Key data read request
1
T=
fosc
A12912
No.6370-22/38
相关PDF资料 |
PDF描述 |
|---|---|
| LC75812PT-8565-H | IC LCD DISPLAY DRIVER 100TQFP |
| LC75813E-E | IC LCD DISPLAY DRIVER 100QLP |
| LC75832W-E | IC LCD DISPLAY DRIVER 64SQFP |
| LC75841PE-H | IC LCD DISPLAY DRIVER 36QFP |
| LC75844M-E | IC LCD DISPLAY DRIVER MFP36SDJ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LC75808WS-E | 功能描述:LCD 驱动器 RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
| LC75808W-SH-E | 功能描述:LCD 驱动器 RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
| LC75809PT-H | 制造商:ON Semiconductor 功能描述:LCD DISPLAY DRIVER - Trays |
| LC75809PTH-H | 制造商:ON Semiconductor 功能描述:LCD DISPLAY DRIVER - Trays |
| LC75809PTS-H | 制造商:ON Semiconductor 功能描述:LCD DISPLAY DRIVER - Trays |
发布紧急采购，3分钟左右您将得到回复。