参数资料
型号: LMX2364TMX/NOPB
厂商: NATIONAL SEMICONDUCTOR CORP
元件分类: PLL合成/DDS/VCOs
英文描述: PLL FREQUENCY SYNTHESIZER, 2600 MHz, PDSO24
封装: TSSOP-24
文件页数: 13/39页
文件大小: 694K
代理商: LMX2364TMX/NOPB
Test Setup Procedures
Sensitivity
20050674
Frequency Input Pin
DC Blocking Capacitor
Corresponding Counter
Default Counter Value
MUX Value
OSCinIF
1 nF
IF_R/RF_R
5000
9 (IF R/2)
FinIF
100 pF
IF_N
5000
10 (IF N/2)
OSCinRF
1 nF
RF_R
50
11 (RF R/2)
FinRF
100 pF
RF_N
50
12 (RF N/2)
Sensitivity is defined as the power level limits beyond which
the output of the counter being tested is off by 1 Hz or more
of its expected value. It is typically measured over frequency,
voltage, and temperature. In order to test sensitivity, the
MUX[3:0] word is programmed to the appropriate value. The
counter value isthen programmed to a fixed value and a
frequency counter is set to monitor the frequency of this pin.
The expected frequency at the Ftest/LD pin should be the
signal generator frequency divided by twice the correspond-
ing counter value. The factor of two comes in because the
LMX2364 has a flip-flop which divides this frequency by two
to make the duty cycle 50% in order to make it easier to read
with the frequency counter. The frequency counter input
impedance should be set to high impedance.
In order to perform the measurement, the temperature, fre-
quency, and voltage is set to a fixed value and the power
level of the signal is varied. Note that the power level at the
part is assumed to be 4 dB less than the signal generator
power level. This accounts for 1 dB for cable losses and 3 dB
for the pad. The power level range where the frequency is
correct at the Ftest/LD pin to within 1 Hz accuracy is re-
corded for the sensitivity limits. The temperature, frequency,
and voltage can be varied in order to produce a family of
sensitivity curves. Since this is an open-loop test, the charge
pump is set to TRI-STATE and the unused side of the PLL
(RF or IF) is powered down when not being tested.
For this part, there are actually four frequency input pins,
although there is only one frequency test pin (Ftest/LD). The
conditions specific to each pin are show above.
LMX2364
www.national.com
20
相关PDF资料
PDF描述
LMX2372MDC PLL FREQUENCY SYNTHESIZER, 1200 MHz, UUC
LMX2531LQ1500EX PLL FREQUENCY SYNTHESIZER, 80 MHz, QCC36
LMZ12003EXTTZX SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PSSO7
LMZ12003EXTTZ SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PSSO7
LMZ12003EXTTZE SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PSSO7
相关代理商/技术参数
参数描述
LMX2370 制造商:NSC 制造商全称:National Semiconductor 功能描述:PLLatinum⑩ Dual Frequency Synthesizer for RF Personal Communications
LMX2370SLBX 功能描述:IC FREQ SYNTH DUAL 24LAMINATECSP RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:PLLatinum™ 标准包装:39 系列:- 类型:* PLL:带旁路 输入:时钟 输出:时钟 电路数:1 比率 - 输入:输出:1:10 差分 - 输入:输出:是/是 频率 - 最大:170MHz 除法器/乘法器:无/无 电源电压:2.375 V ~ 3.465 V 工作温度:0°C ~ 70°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LMX2370SLDX 功能描述:IC FREQ SYNTH DUAL 24LAMINATECSP RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:PLLatinum™ 标准包装:39 系列:- 类型:* PLL:带旁路 输入:时钟 输出:时钟 电路数:1 比率 - 输入:输出:1:10 差分 - 输入:输出:是/是 频率 - 最大:170MHz 除法器/乘法器:无/无 电源电压:2.375 V ~ 3.465 V 工作温度:0°C ~ 70°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LMX2370TM 功能描述:IC FREQ SYNTH DL 2.5GHZ 20TSSOP RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:PLLatinum™ 标准包装:39 系列:- 类型:* PLL:带旁路 输入:时钟 输出:时钟 电路数:1 比率 - 输入:输出:1:10 差分 - 输入:输出:是/是 频率 - 最大:170MHz 除法器/乘法器:无/无 电源电压:2.375 V ~ 3.465 V 工作温度:0°C ~ 70°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*
LMX2370TMX 功能描述:IC FREQ SYNTH DL 2.5GHZ 20-TSSOP RoHS:否 类别:集成电路 (IC) >> 时钟/计时 - 时钟发生器,PLL,频率合成器 系列:PLLatinum™ 标准包装:39 系列:- 类型:* PLL:带旁路 输入:时钟 输出:时钟 电路数:1 比率 - 输入:输出:1:10 差分 - 输入:输出:是/是 频率 - 最大:170MHz 除法器/乘法器:无/无 电源电压:2.375 V ~ 3.465 V 工作温度:0°C ~ 70°C 安装类型:* 封装/外壳:* 供应商设备封装:* 包装:*