- 您现在的位置：买卖IC网 > PDF目录13936 > LT3501EFE#TRPBF (Linear Technology)IC REG BUCK ADJ 3A DL 20TSSOP PDF资料下载
参数资料
| 型号： | LT3501EFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 16/30页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 3A DL 20TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.8 V ~ 23.8 V |
| 输入电压： | 3.1 V ~ 25 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 250kHz ~ 1.5MHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 20-TSSOP-EP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LT3501
APPLICATIONS INFORMATION
? I
?
C OUT > 10 L ? LIM ?
C VOUT =
C VOUT =
= 12 μ F
eitherclamptheinputvoltageordampenthetankcircuit
by adding a lossy capacitor in parallel with the ceramic
capacitor. For details, see Application Note 88.
Output Capacitor Selection
Typically step-down regulators are easily compensated
with an output crossover frequency that is one-tenth of
the switching frequency. This means that the time that the
output capacitor must supply the output load during a tran-
sient step is ~2 or 3 switching periods. With an allowable
5% drop in output voltage during the step, a good starting
value for the output capacitor can be expressed by:
Max Load Step
Frequency ? 0.05 ? V OUT
Example:
V OUT = 3.3V, Frequency = 1MHz, Max Load Step = 3A
2
1e6 ? 0.05 ? 3.3V
The calculated value is only a suggested starting value.
Increase the value if transient response needs improvement
or reduce the capacitance if size is a priority.
The output capacitor filters the inductor current to generate
an output with low voltage ripple. It also stores energy in
order to satisfy transient loads and to stabilize the LT3501’s
control loop. The switching frequency of the LT3501 deter-
mines the value of output capacitance required. Also, the
current mode control loop doesn’t require the presence
of output capacitor series resistance (ESR). For these
reasons, you are free to use ceramic capacitors to achieve
very low output ripple and small circuit size.
Estimate output ripple with the following equations:
V RIPPLE = Δ I L /(8f C OUT ) for ceramic capacitors,
and
V RIPPLE = Δ I L ESR for electrolytic capacitors (tantalum
and aluminum)
where Δ I L is the peak-to-peak ripple current in the
inductor.
The RMS content of this ripple is very low, and the RMS
current rating of the output capacitor is usually not of
concern.
Another constraint on the output capacitor is that it must
have greater energy storage than the inductor; if the stored
energy in the inductor is transferred to the output, you
would like the resulting voltage step to be small compared
to the regulation voltage. For a 5% overshoot, this require-
ment becomes
2
? V OUT ?
Finally, there must be enough capacitance for good transient
performance. The last equation gives a good starting point.
Alternatively, you can start with one of the designs in this
data sheet and experiment to get the desired performance.
This topic is covered more thoroughly in the section on
loop compensation.
The high performance (low ESR), small size and robustness
of ceramic capacitors make them the preferred type for
LT3501 applications. However, all ceramic capacitors are
not the same. As mentioned above, many of the high value
capacitors use poor dielectrics with high temperature and
voltage coefficients. In particular, Y5V and Z5U types lose
a large fraction of their capacitance with applied voltage
and temperature extremes. Because the loop stability and
transient response depend on the value of C OUT , you may
not be able to tolerate this loss. Use X7R and X5R types.
You can also use electrolytic capacitors. The ESRs of most
aluminum electrolytics are too large to deliver low output
ripple. Tantalum and newer, lower ESR organic electrolytic
capacitors intended for power supply use, are suitable
and the manufacturers will specify the ESR. The choice of
capacitor value will be based on the ESR required for low
ripple. Because the volume of the capacitor determines
its ESR, both the size and the value will be larger than a
ceramic capacitor that would give you similar ripple per-
formance. One benefit is that the larger capacitance may
give better transient response for large changes in load
current. Table 2 lists several capacitor vendors.
3501fd
16
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6730UTLD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6731AUTWD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6730AUTSD2+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6730AUTSD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6730AUTLD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| lt3501ife | 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 3.1V to 25V 20-Pin TSSOP EP |
| LT3501IFE#PBF | 功能描述:IC REG BUCK ADJ 3A DL 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3501IFE#TRPBF | 功能描述:IC REG BUCK ADJ 3A DL 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3502 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.1MHz/2.2MHz, 500mA Step-Down Regulators in 2mm × 2mm DFN and MS10 |
| LT3502AEDC#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3V to 40V 8-Pin DFN EP 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3V to 40V 8-Pin DFN EP Bulk 制造商:Linear Technology 功能描述:BUCK SW REG 0.5A 2.2MHZ 8D 制造商:Linear Technology 功能描述:BUCK, SW REG, 0.5A, 2.2MHZ, 8DFN |
发布紧急采购，3分钟左右您将得到回复。