- 您现在的位置：买卖IC网 > PDF目录13936 > LT3501EFE#TRPBF (Linear Technology)IC REG BUCK ADJ 3A DL 20TSSOP PDF资料下载
参数资料
| 型号： | LT3501EFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/30页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 3A DL 20TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.8 V ~ 23.8 V |
| 输入电压： | 3.1 V ~ 25 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 250kHz ~ 1.5MHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 20-TSSOP-EP |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LT3501
PIN FUNCTIONS
V IN1 (Pin 1): The V IN1 pin powers the internal control
circuitry for both channels and is monitored by the under-
voltage lockout comparator. The V IN1 pin is also connected
to the collector of channel 1’s on-chip power NPN switch.
The V IN1 pin has high dI/dt edges and must be decoupled
to ground close to the pin of the device.
SW1/SW2 (Pins 2, 9): The SW pin is the emitter of the on-
chip power NPN. At switch-off, the inductor will drive this
pin below ground with a high dV/dt. An external Schottky
catch diode to ground, close to the SW pin and respective
V IN decoupling capacitor’s ground, must be used to prevent
this pin from excessive negative voltages.
IND1/IND2 (Pins 3, 8): The IND pin is the input to the
on-chip sense resistor that measures current flowing in
the inductor. When the current in the resistor exceeds
the current dictated by the V C pin, the SW latch is held in
reset, disabling the output switch. Bias current flows out
of the IND pin when IND is less than 1.6V.
V OUT1 /V OUT2 (Pins 4, 7): The V OUT pin is the output to
the on-chip sense resistor that measures current flowing
in the inductor. When the current in the resistor exceeds
the current dictated by the V C pin, the SW latch is held in
reset, disabling the output switch. Bias current flows out
of the V OUT pin when V OUT is less than 1.6V.
PG1/PG2 (Pins 5, 6): The power good pin is an open-col-
lector output that sinks current when the feedback falls
below 90% of its nominal regulating voltage. For V IN1
above 1V, its output state remains true, although during
shutdown, V IN1 undervoltage lockout or thermal shutdown,
its current sink capability is reduced. The PG pins can be
left open circuit or tied together to form a single power
good signal.
V IN2 (Pin 10): The V IN2 pin is the collector of channel 2’s
on-chip power NPN switch. This pin is independent of V IN1
and may be connected to the same or a separate supply. In
either case, high dI/dt edges are present and decoupling
to ground must be used close to this pin.
SS1/SS2 (Pins 19, 12): The SS1/2 pins control the soft-
start and sequence of their respective outputs. A single
capacitor from the SS pin to ground determines the output
ramp rate. For soft-start and output tracking/sequencing
details, see the Applications Information section.
V C1 /V C2 (Pins 18, 13): The V C pin is the output of the
error amplifier and the input to the peak switch current
comparator. It is normally used for frequency compensa-
tion, but can also be used as a current clamp or control
loop override. If the error amplifier drives V C above the
maximum switch current level, a voltage clamp activates.
This indicates that the output is overloaded and current is
pulled from the SS pin, reducing the regulation point.
FB1/FB2 (Pins 17, 14): The FB pin is the negative input
to the error amplifier. The output switches regulate this
pin to 0.8V, with respect to the exposed ground pad. Bias
current flows out of the FB pin.
SHDN (Pin 15): The shutdown pin is used to turn off both
channels and control circuitry to reduce quiescent current
to a typical value of 9μA. The accurate 1.28V threshold and
input current hysteresis can be used as an undervoltage
lockout, preventing the regulator from operating until the
input voltage has reached a predetermined level. Force
the SHDN pin above its threshold or let it float for normal
operation.
R T /SYNC (Pin 16): This R T /SYNC pin provides two modes
of setting the constant switch frequency.
Connecting a resistor from the R T /SYNC pin to ground
will set the R T /SYNC pin to a typical value of 0.975V. The
resultant switching frequency will be set by the resistor
value. The minimum value of 15.4k and maximum value of
133k sets the switching frequency to 1.5MHz and 250kHz,
respectively.
Driving the R T /SYNC pin with an external clock signal will
synchronize the switch to the applied frequency. Synchro-
nization occurs on the rising edge of the clock signal after
3501fd
8
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6730UTLD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6731AUTWD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6730AUTSD2+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6730AUTSD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6730AUTLD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| lt3501ife | 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 3.1V to 25V 20-Pin TSSOP EP |
| LT3501IFE#PBF | 功能描述:IC REG BUCK ADJ 3A DL 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3501IFE#TRPBF | 功能描述:IC REG BUCK ADJ 3A DL 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3502 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.1MHz/2.2MHz, 500mA Step-Down Regulators in 2mm × 2mm DFN and MS10 |
| LT3502AEDC#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3V to 40V 8-Pin DFN EP 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3V to 40V 8-Pin DFN EP Bulk 制造商:Linear Technology 功能描述:BUCK SW REG 0.5A 2.2MHZ 8D 制造商:Linear Technology 功能描述:BUCK, SW REG, 0.5A, 2.2MHZ, 8DFN |
发布紧急采购，3分钟左右您将得到回复。