- 您现在的位置：买卖IC网 > PDF目录13936 > LT3501EFE#TRPBF (Linear Technology)IC REG BUCK ADJ 3A DL 20TSSOP PDF资料下载
参数资料
| 型号： | LT3501EFE#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 20/30页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 3A DL 20TSSOP |
| 标准包装： | 2,500 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 2 |
| 输出电压： | 0.8 V ~ 23.8 V |
| 输入电压： | 3.1 V ~ 25 V |
| PWM 型： | 电流模式 |
| 频率 - 开关： | 250kHz ~ 1.5MHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-TSSOP（0.173"，4.40mm 宽）裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 20-TSSOP-EP |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
LT3501
APPLICATIONS INFORMATION
If the synchronization signal powers up in a high impedance
state (Hi-Z), connect a resistor from the R T /SYNC pin to
ground. The equivalent resistance seen from the R T /SYNC
pin to ground will set the start-up frequency.
defaults the open-pin condition to be operating (see Typical
Performance Characteristics). Current hysteresis is added
above the SHDN threshold. This can be used to set voltage
hysteresis of the UVLO using the following:
V H – 1.28
+ 3 μ A
If the synchronization signal changes between high and
low impedance states during power-up (V OL , Hi-Z), connect
the synchronization circuitry to the LT3501 as shown in
the Typical Applications section. This will allow the LT3501
to start-up with a switching frequency determined by the
equivalent resistance from the R T /SYNC pin to ground.
R1 =
R2 =
V H – V L
7 μ A
1.28
R1
R1 =
? 143k
R2 =
? 47k
+ 3 μ A
ShutdownandUndervoltageLockout
Figure 8 shows how to add undervoltage lockout (UVLO)
to the LT3501. Typically, UVLO is used in situations where
the input supply is current limited, or has a relatively high
source resistance. A switching regulator draws constant
power from the source, so source current increases as
source voltage drops. This looks like a negative resistance
load to the source and can cause the source to current limit
or latch low under low source voltage conditions. UVLO
prevents the regulator from operating at source voltages
where these problems might occur.
An internal comparator will force the part into shutdown
below the minimum V IN1 of 2.8V. This feature can be
used to prevent excessive discharge of battery-operated
systems.
Since V IN2 supplies the output stage of channel 2 and is
not monitored, care must be taken to insure that V IN2 is
present before channel 2 is allowed to switch.
If an adjustable UVLO threshold is required, the SHDN
pin can be used. The threshold voltage of the SHDN
pin comparator is 1.28V. A 3μA internal current source
V H = Turn-on threshold
V L = Turn-off threshold
Example: switching should not start until the input is above
4.75V and is to stop if the input falls below 3.75V.
V H = 4.75V
V L = 3.75V
4.75 – 3.75
7 μ A
1.28
4.75 – 1.28
143k
Keep the connections from the resistors to the SHDN
pin short and make sure that the interplane or surface
capacitance to switching nodes is minimized. If high re-
sistor values are used, the SHDN pin should be bypassed
with a 1nF capacitor to prevent coupling problems from
the switch node.
Soft-Start
V IN1 > 2.8V
V IN1 OR V IN2
R1
LT3501
V IN1
SHDN
3μA
7μA
+
1.28V
INTERNAL
REGULATOR
The output of the LT3501 regulates to the lowest voltage
present at either the SS pin or an internal 0.8V reference.
A capacitor from the SS pin to ground is charged by an
internal 3.25μA current source resulting in a linear output
ramp from 0V to the regulated output whose duration is
given by:
C1
R2
Figure 8. Undervoltage Lockout
3501 F08
t RAMP =
C SS ? 0.8V
3.25 μ A
3501fd
20
相关PDF资料 |
PDF描述 |
|---|---|
| MAX6730UTLD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6731AUTWD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6730AUTSD2+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6730AUTSD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
| MAX6730AUTLD3+T | IC SUPERVISOR MPU W/WD SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| lt3501ife | 制造商:Linear Technology 功能描述:Conv DC-DC Dual Step Down 3.1V to 25V 20-Pin TSSOP EP |
| LT3501IFE#PBF | 功能描述:IC REG BUCK ADJ 3A DL 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3501IFE#TRPBF | 功能描述:IC REG BUCK ADJ 3A DL 20TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 设计资源:Design Support Tool 标准包装:1 系列:- 类型:升压（升压） 输出类型:固定 输出数:1 输出电压:3V 输入电压:0.75 V ~ 2 V PWM 型:- 频率 - 开关:- 电流 - 输出:100mA 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:SOT-23-5 细型，TSOT-23-5 包装:剪切带 (CT) 供应商设备封装:TSOT-23-5 其它名称:AS1323-BTTT-30CT |
| LT3502 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.1MHz/2.2MHz, 500mA Step-Down Regulators in 2mm × 2mm DFN and MS10 |
| LT3502AEDC#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3V to 40V 8-Pin DFN EP 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down 3V to 40V 8-Pin DFN EP Bulk 制造商:Linear Technology 功能描述:BUCK SW REG 0.5A 2.2MHZ 8D 制造商:Linear Technology 功能描述:BUCK, SW REG, 0.5A, 2.2MHZ, 8DFN |
发布紧急采购，3分钟左右您将得到回复。