- 您现在的位置：买卖IC网 > PDF目录30768 > LT3751IUFD#TRPBF (LINEAR TECHNOLOGY CORP) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 PDF资料下载
参数资料
| 型号： | LT3751IUFD#TRPBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 电源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 |
| 封装： | 4 X 5 MM, LEAD FREE, PLASTIC, QFN-20 |
| 文件页数： | 7/34页 |
| 文件大小： | 403K |
| 代理商： | LT3751IUFD#TRPBF |
第1页第2页第3页第4页第5页第6页当前第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
LT3751
15
3751fb
APPLICATIONS INFORMATION
The LT3751 charger controller can be optimized for either
capacitor charging only or low noise regulation applica-
tions. Several equations are provided to aid in the design
process.
Safety Warning
Large capacitors charged to high voltage can deliver a lethal
amount of energy if handled improperly. It is particularly
important to observe appropriate safety measures when
designing the LT3751 into applications. First, create a dis-
charge circuit that allows the designer to safely discharge
the output capacitor. Second, adequately space high voltage
nodes from adjacent traces to satisfy printed circuit board
voltage breakdown requirements.
Selecting Operating Mode
Tie the FB pin to GND to operate the LT3751 as a capacitor
charger. In this mode, the LT3751 charges the output at
peak primary current in boundary mode operation. This
constitutes maximum power delivery and yields the fast-
est charge times. Power delivery is halted once the output
reaches the desired output voltage set by the RVOUT and
RBG pins.
Tie a resistor divider from the FB pin to VOUT and GND
to operate the LT3751 as a low noise voltage regulator
(refer to Low Noise regulation section for proper design
procedures). The LT3751 operates as a voltage regulator
using both peak current and duty cycle modulation to vary
output current during different loading conditions.
Selecting Component Parameters
Most designs start with the initial selection of VTRANS,
VOUT, COUT, and either charge time, tCHARGE, (capacitor
charger) or POUT,MAX (regulator). These design inputs
are then used to select the transformer ratio, N, the peak
primary current, IPK, and the primary inductance, LPRI.
Figure 7 can be used as a rough guide for maximum power
output for a given VTRANS and IPK.
Selecting Transformer Turns Ratio
The transformer ratio, N, should be selected based on the
input and output voltages. Smaller N values equate to faster
charge times and larger available output power. Note that
drastically reducing N below the VOUT/VTRANS ratio will
increase the yback voltage on the drain of the NMOS and
increase the current through the output diode. The ratio,
N, should not be drastically increased either, due to the
increased capacitance, N2 CSEC, reected to the primary.
A good choice is to select N equal to VOUT/VTRANS.
N
≤
V
OUT
V
TRANS
Choosing Capacitor Charger IPK
When operating the LT3751 as capacitor charger, choose
IPK based on the required capacitor charge time, tCHARGE,
and the initial design inputs.
I
PK =
2 N V
TRANS + VOUT
()C
OUT VOUT
Efficiency V
TRANS tCHARGE td
()
The converter efciency varies over the output voltage
range. The IPK equation is based on the average ef-
ciency over the entire charging period. Several factors can
cause the charge time to increase. Efciency is the most
dominant factor and is mainly affected by the transformer
winding resistance, core losses, leakage inductance, and
transistor RDS. Most applications have overall efciencies
above 70%.
Figure 7. Maximum Power Output
PEAK PRIMARY CURRENT (A)
V
TRANS
(V)
3751 F07
100
10
20
30
40
50
60
70
80
90
0
1
10
100
P = 20 WATTS
P = 50 WATTS
P = 100 WATTS
相关PDF资料 |
PDF描述 |
|---|---|
| LT3751EFE | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 |
| LT3751EUFD#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 |
| LT3751EUFD | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 |
| LT3751IFE#TRPBF | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO20 |
| LT3782AEFE#TR | SWITCHING CONTROLLER, PDSO28 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3754 | 制造商:LINER 制造商全称:Linear Technology 功能描述:16-Channel 50mA LED |
| LT3754EUH#PBF | 功能描述:IC LED DRIVER AUTOMOTIVE 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LT3754EUH#TRPBF | 功能描述:IC LED DVR 16CH 50MA 32QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| LT3754EUHPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:16-Channel × 50mA LED Driver |
| LT3754EUHTRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:16-Channel × 50mA LED Driver |
发布紧急采购，3分钟左右您将得到回复。