- 您现在的位置：买卖IC网 > PDF目录79850 > LT3757MPMSE#PBF (LINEAR TECHNOLOGY CORP) SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 PDF资料下载
参数资料
| 型号： | LT3757MPMSE#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 稳压器 |
| 英文描述： | SWITCHING REGULATOR, 1000 kHz SWITCHING FREQ-MAX, PDSO10 |
| 封装： | 3 X 3 MM, LEAD FREE, PLASTIC, MSOP-10 |
| 文件页数： | 2/36页 |
| 文件大小： | 436K |
| 代理商： | LT3757MPMSE#PBF |
第1页当前第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LT3757
10
3757fc
applicaTions inForMaTion
For applications where the SHDN/UVLO pin is only used
as a logic input, the SHDN/UVLO pin can be connected
directly to the input voltage VIN for always-on operation.
INTVCC Regulator Bypassing and Operation
An internal, low dropout (LDO) voltage regulator produces
the 7.2V INTVCC supply which powers the gate driver, as
shown in Figure 1. If a low input voltage operation is ex-
pected (e.g., supplying power from a lithium-ion battery
or a 3.3V logic supply), low threshold MOSFETs should
be used. The LT3757 contains an undervoltage lockout
comparator A8 and an overvoltage lockout comparator
A9 for the INTVCC supply. The INTVCC undervoltage (UV)
threshold is 2.7V (typical), with 100mV hysteresis, to
ensure that the MOSFETs have sufficient gate drive voltage
before turning on. The logic circuitry within the LT3757 is
also powered from the internal INTVCC supply.
The INTVCC overvoltage (OV) threshold is set to be 17.5V
(typical) to protect the gate of the power MOSFET. When
INTVCC is below the UV threshold, or above the OV thresh-
old, the GATE pin will be forced to GND and the soft-start
operation will be triggered.
The INTVCC regulator must be bypassed to ground im-
mediately adjacent to the IC pins with a minimum of 4.7F
ceramic capacitor. Good bypassing is necessary to supply
the high transient currents required by the MOSFET gate
driver.
In an actual application, most of the IC supply current is
used to drive the gate capacitance of the power MOSFET.
Theon-chippowerdissipationcanbeasignificantconcern
when a large power MOSFET is being driven at a high fre-
quency and the VIN voltage is high. It is important to limit
the power dissipation through selection of MOSFET and/
or operating frequency so the LT3757 does not exceed its
maximum junction temperature rating. The junction tem-
peratureTJcanbeestimatedusingthefollowingequations:
TJ = TA + PIC θJA
TA = ambient temperature
θJA = junction-to-ambient thermal resistance
PIC = IC power consumption
= VIN (IQ + IDRIVE)
IQ = VIN operation IQ = 1.6mA
IDRIVE = average gate drive current = f QG
f = switching frequency
QG = power MOSFET total gate charge
The LT3757 uses packages with an Exposed Pad for en-
hanced thermal conduction. With proper soldering to the
Exposed Pad on the underside of the package and a full
copper plane underneath the device, thermal resistance
(
θJA)willbeabout43°C/WfortheDDpackageand40°C/W
for the MSE package. For an ambient board temperature of
TA = 70°C and maximum junction temperature of 125°C,
the maximum IDRIVE (IDRIVE(MAX)) of the DD package can
be calculated as:
IDRIVE(MAX) =
(TJ TA)
(
θJA VIN)
IQ =
1.28W
VIN
1.6mA
The LT3757 has an internal INTVCC IDRIVE current limit
function to protect the IC from excessive on-chip power
dissipation. The IDRIVE current limit decreases as the VIN
increases (see the INTVCCMinimumOutputCurrentvsVIN
graph in the Typical Performance Characteristics section).
If IDRIVE reaches the current limit, INTVCC voltage will fall
and may trigger the soft-start.
BasedontheprecedingequationandtheINTVCCMinimum
Output Current vs VIN graph, the user can calculate the
maximum MOSFET gate charge the LT3757 can drive at
a given VIN and switch frequency. A plot of the maximum
QG vs VIN at different frequencies to guarantee a minimum
4.5V INTVCC is shown in Figure 2.
As illustrated in Figure 2, a trade-off between the operating
frequencyandthesizeofthepowerMOSFETmaybeneeded
in order to maintain a reliable IC junction temperature.
Prior to lowering the operating frequency, however, be
sure to check with power MOSFET manufacturers for their
most recent low QG, low RDS(ON) devices. Power MOSFET
manufacturingtechnologiesarecontinuallyimproving,with
newer and better performance devices being introduced
almost yearly.
相关PDF资料 |
PDF描述 |
|---|---|
| LM4040ESD-250GT3 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 2.5 V, PDSO5 |
| LM4040DSD-330GT3 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 3.3 V, PDSO5 |
| LM4040BIZ-5.0 | 1-OUTPUT TWO TERM VOLTAGE REFERENCE, 5 V, PBCY3 |
| LK5660-7EPD4TB1 | 2-OUTPUT 150 W AC-DC PWR FACTOR CORR MODULE |
| LT1374IR-5#TR | 8.5 A SWITCHING REGULATOR, 560 kHz SWITCHING FREQ-MAX, PSSO7 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LT3757MPMSE-TRPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Boost, Flyback, SEPIC and Inverting Controller |
| LT3758 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Input Voltage, Boost, Flyback, SEPIC and Inverting Controller |
| LT3758A | 制造商:LINER 制造商全称:Linear Technology 功能描述:60V Low IQ Inverting DC/DC Controller Wide Operating VIN Range: 3.5V to 60V |
| LT3758AEDD#PBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BST FLYBK INV 10DFN |
| LT3758AEDD#TRPBF | 制造商:Linear Technology 功能描述:IC REG CTRLR BST FLYBK INV 10DFN 制造商:Linear Technology 功能描述:SP-SWREG/Controller, High Input Voltage, Boost, Flyback, SEPIC and Inverting Con |
发布紧急采购，3分钟左右您将得到回复。