- 您现在的位置：买卖IC网 > PDF目录1829 > LTC3425EUH#TRPBF (Linear Technology)IC REG BOOST SYNC ADJ 5A 32QFN PDF资料下载
参数资料
| 型号： | LTC3425EUH#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 14/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST SYNC ADJ 5A 32QFN |
| 标准包装： | 2,500 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 2.4 V ~ 5.25 V |
| 输入电压： | 0.5 V ~ 4.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 100kHz ~ 2MHz |
| 电流 - 输出： | 5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 32-QFN 裸露焊盘（5x5） |
LTC3425
OPERATIO
T A = 25 ° C
98
96 V IN = 2.4V
V OUT = 3.3V
94 1MHz/PHASE
f OSC =
60
R T
92
90
4 PHASE
f SWITCH =
f OSC
4
=
15
R T
88
86
where f OSC is in MHz and R T is in k ? .
84
82
80
100
2 PHASE
1000
LOAD (mA)
3 PHASE
10000
The oscillator can be synchronized with an external clock
applied to SYNCIN. When synchronizing the oscillator, the
free running frequency must be set to an approximately
30% lower frequency than the desired synchronized fre-
3425 G13
Figure 4. LTC3425 Efficiency vs
Load for 2-, 3- and 4-Phase Operation
Low Noise Fixed Frequency Operation
Shutdown: The part is shut down by pulling SHDN below
0.25V and made active by pulling the pin above 1V. Note
that SHDN can be driven above V IN or V OUT , as long as it
is limited to less than 5.5V.
Soft-Start: The soft-start time is programmed with an
external capacitor to ground on SS. An internal current
source charges it with a nominal 2.5 μ A (1 μ A while in start-
up mode when V IN and V OUT are both below 2.3V). The
voltage on the soft-start pin (in conjunction with the
external resistor on the I LIM pin) is used to control the peak
current limit until the voltage on the capacitor exceeds
1.6V, at which point the external resistor sets the peak
current. In the event of a commanded shutdown or a
thermal shutdown, the capacitor is discharged automati-
cally. Note that Burst Mode operation is inhibited during
the soft-start time.
t(ms) = C SS ( μ F) ? 320
Oscillator: The frequency of operation is set through a re-
sistor from the R T pin to ground. An internally trimmed
timing capacitor resides inside the IC. The internal
oscillator frequency is then divided by four to generate the
four phases, each phase shifted by 90 ° . The oscillator fre-
quency. SYNCOUT is provided for synchronizing two or
more devices. The output sync pulse is 180 ° out of phase
from the internal oscillator, allowing two devices to be
synchronized to create an 8-phase converter. Note that in
Burst Mode operation, the oscillator is turned off and
SYNCOUT is driven low.
In fixed frequency operation, the minimum on-time before
pulse skipping occurs (at light load) is typically 110ns.
Current Sensing: Lossless current sensing converts the
peak current signal to a voltage to sum in with the internal
slope compensation. This summed signal is compared to
the error amplifier output to provide a peak current control
command for the PWM. The internal slope-compensation
is adaptive to the input and output voltage, therefore the
converter provides the proper amount of slope compensa-
tion to ensure stability, but not an excess to cause a loss
of phase margin in the converter.
Error Amp: The error amplifier is a transconductance
amplifier with its positive input internally connected to the
1.22V reference and its negative input connected to FB. A
simple compensation network is placed from COMP to
ground. Internal clamps limit the minimum and maximum
error amp output voltage for improved large-signal tran-
sient response. During Burst Mode operation, the com-
pensation pin is high impedance, however clamps limit the
voltage on the external compensation network, preventing
the compensation capacitor from discharging to zero.
quency and resulting switching frequency of each of the four
phases are calculated using the following formula:
3425f
14
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3426ES6#TRPBF | IC REG BOOST ADJ 2A TSOT23-6 |
| LTC3427EDC#TRPBF | IC REG BOOST SYNC ADJ 0.5A 6DFN |
| LTC3428EDD#TRPBF | IC REG BOOST ADJ 4A 10DFN |
| LTC3429ES6#TRM | IC REG BST SYNC ADJ .6A TSOT23-6 |
| LTC3440EDD#TRPBF | IC REG BUCK BOOST SYNC ADJ 10DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3426 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23 |
| LTC3426ES6 | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.3V 6-Pin TSOT-23 |
| LTC3426ES6#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.3V 6-Pin TSOT-23 |
| LTC3426ES6#TRM | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.3V 6-Pin TSOT-23 T/R |
| LTC3426ES6#TRMPBF | 功能描述:IC REG BOOST ADJ 2A TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色产品:BD91x Series Step-Down Regulators 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:2 输出电压:3.3V，0.8 V ~ 2.5 V 输入电压:4.5 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:1MHz 电流 - 输出:1.5A 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 包装:带卷 (TR) 供应商设备封装:VQFN020V4040 产品目录页面:1373 (CN2011-ZH PDF) 其它名称:BD9152MUV-E2TR |
发布紧急采购，3分钟左右您将得到回复。