- 您现在的位置：买卖IC网 > PDF目录1829 > LTC3425EUH#TRPBF (Linear Technology)IC REG BOOST SYNC ADJ 5A 32QFN PDF资料下载
参数资料
| 型号： | LTC3425EUH#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 15/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST SYNC ADJ 5A 32QFN |
| 标准包装： | 2,500 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 2.4 V ~ 5.25 V |
| 输入电压： | 0.5 V ~ 4.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 100kHz ~ 2MHz |
| 电流 - 输出： | 5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 32-QFN 裸露焊盘（5x5） |
LTC3425
OPERATIO
Current Limit: The programmable current limit circuit sets
the maximum peak current in the NMOS switches. The
current limit level is programmed using a resistor to
ground on the I LIM pin. Do not use values below 75k. In
Burst Mode operation, the current limit is automatically
set to a nominal value of 0.6A peak for optimal efficiency.
the soft-start capacitor will be reset. The part will be
enabled again when the die temperature has dropped
about 10 ° C. Note: Overtemperature protection is intended
to protect the device during momentary overload condi-
tions. Continuous operation above the specified maxi-
mum operating junction temperature may result in device
I LIM =
130
R
per Phase
degradation or failure.
Burst Mode Operation
where I is in Amps and R is in k ? .
Synchronous Rectifier and Zero Current Amp: To pre-
vent the inductor current from running away, the PMOS
synchronous rectifier is only enabled when V OUT > (V IN +
0.3V) and FB is > 0.8V.The zero current amplifier monitors
the inductor current to the output and shuts off the
synchronous rectifier once the current is below 50mA
typical, preventing negative inductor current. If CCM is
tied high, the amplifier will allow up to 0.6A of negative
current in the synchronous rectifier.
Antiringing Control: The antiringing control connects a
resistor across the inductor to damp the ringing on SW in
discontinuous conduction mode. The LC SW ringing (L =
inductor, C SW = Capacitance on Switch pin) is low energy,
but can cause EMI radiation.
Power Good: An internal comparator monitors the FB
voltage. If FB drops 11.4% below the regulation value,
PGOOD will pull low (sink current should be limited to
10mA max). The output will stay low until the FB voltage
is within 9.5% of the regulation voltage. A filter prevents
noise spikes from causing nuisance trips.
Reference Output: The internal 1.22V reference is buff-
ered and brought out to REFOUT. It is active when REFEN
is pulled high (above 1.4V). For stability, a minimum of
0.1 μ F capacitor must be placed on REFOUT. The output
can source up to 100 μ A and sink up to 10 μ A. For the lowest
possible quiescent current in Burst Mode operation, the
reference output should be disabled by grounding REFEN.
Thermal Shutdown: An internal temperature monitor will
start to reduce the programmed peak current limit if the
die temperature exceeds 135 ° C. If the die temperature
continues to rise and reaches 150 ° C, the part will go into
thermal shutdown and all switches will be turned off and
Burst Mode operation can be automatic or user controlled.
In automatic operation, the IC will automatically enter
Burst Mode operation at light load and return to fixed
frequency PWM mode for heavier loads. The user can
program the average load current at which the mode
transition occurs using a single resistor.
During Burst Mode operation, only Phase A is active and
the other three phases are turned off, reducing quiescent
current and switching losses by 75%. Note that the
oscillator is also shut down in this mode, since the on time
is determined by the time it takes the inductor current to
reach a fixed peak current, and the off time is determined
by the time it takes for the inductor current to return to
zero.
In Burst Mode operation, the IC delivers energy to the
output until it is regulated and then goes into a sleep mode
where the outputs are off and the IC is consuming only
12 μ A of quiescent current. In this mode, the output ripple
has a variable frequency component with load current and
will be typically 2% peak-peak. This maximizes efficiency
at very light loads by minimizing switching and quiescent
losses. Burst Mode ripple can be reduced slightly by using
more output capacitance (47 μ F or greater). This capacitor
does not need to be a low ESR type if low ESR ceramics are
also used. Another method of reducing Burst Mode ripple
is to place a small feedforward capacitor across the upper
resistor in the V OUT feedback divider network.
During Burst Mode operation, COMP is disconnected
from the error amplifier in an effort to hold the voltage on
the external compensation network where it was before
entering Burst Mode operation. To minimize the effects of
leakage current and stray resistance, voltage clamps limit
the min and max voltage on COMP during Burst Mode
operation. This minimizes the transient experienced when
3425f
15
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3426ES6#TRPBF | IC REG BOOST ADJ 2A TSOT23-6 |
| LTC3427EDC#TRPBF | IC REG BOOST SYNC ADJ 0.5A 6DFN |
| LTC3428EDD#TRPBF | IC REG BOOST ADJ 4A 10DFN |
| LTC3429ES6#TRM | IC REG BST SYNC ADJ .6A TSOT23-6 |
| LTC3440EDD#TRPBF | IC REG BUCK BOOST SYNC ADJ 10DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3426 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23 |
| LTC3426ES6 | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.3V 6-Pin TSOT-23 |
| LTC3426ES6#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.3V 6-Pin TSOT-23 |
| LTC3426ES6#TRM | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.3V 6-Pin TSOT-23 T/R |
| LTC3426ES6#TRMPBF | 功能描述:IC REG BOOST ADJ 2A TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色产品:BD91x Series Step-Down Regulators 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:2 输出电压:3.3V，0.8 V ~ 2.5 V 输入电压:4.5 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:1MHz 电流 - 输出:1.5A 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 包装:带卷 (TR) 供应商设备封装:VQFN020V4040 产品目录页面:1373 (CN2011-ZH PDF) 其它名称:BD9152MUV-E2TR |
发布紧急采购，3分钟左右您将得到回复。