- 您现在的位置：买卖IC网 > PDF目录1829 > LTC3425EUH#TRPBF (Linear Technology)IC REG BOOST SYNC ADJ 5A 32QFN PDF资料下载
参数资料
| 型号： | LTC3425EUH#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 8/24页 |
| 文件大小： | 0K |
| 描述： | IC REG BOOST SYNC ADJ 5A 32QFN |
| 标准包装： | 2,500 |
| 类型： | 升压（升压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 2.4 V ~ 5.25 V |
| 输入电压： | 0.5 V ~ 4.5 V |
| PWM 型： | 电流模式，混合 |
| 频率 - 开关： | 100kHz ~ 2MHz |
| 电流 - 输出： | 5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 32-QFN 裸露焊盘（5x5） |
LTC3425
PI FU CTIO S
V OUT = 1 . 22 ?
GNDA–D(Pins1,2,7,8,17,18,23,24): PowerGround
for the IC and the Four Internal N-channel MOSFETs.
Connect directly to the power ground plane.
SWA–D (Pins 3, 6, 19, 22): Switch Pins. Connect induc-
tors here. Minimize trace length to keep EMI to a mini-
mum. For discontinuous inductor current, a controlled
impedance is internally connected from SW to V IN to
minimize EMI. For applications where V OUT > 4.3V, it is
required to have Schottky diodes from SW to V OUT or a
snubber circuit to stay within absolute maximum rating on
the SW pins.
V OUTA–D (Pins 4, 5, 20, 21): Output of the Four Synchro-
nous Rectifiers. Connect output filter capacitors to these
pins. Connect one low ESR ceramic capacitor directly
from each pin to the ground plane.
REFEN (Pin 9): Pull this pin above 1.4V to enable the REF
output. Grounding this pin turns the REF output off to
reduce quiescent current.
V OUTS (Pin 10): V OUT Sense Pin. Connect V OUTS directly to
an output filter capacitor. The top of the feedback divider
network should also be tied to this point.
SGND (Pin 11): Signal Ground Pin. Connect to ground
plane, near the feedback divider resistor.
FB (Pin 12): Feedback Pin. Connect FB to a resistor divider,
keeping the trace as short as possible. The output voltage
can be adjusted according to the following formula:
R1 + R2
R 1
where R1 is connected from FB to SGND and R2 is
connected from FB to V OUTS .
COMP (Pin 13): Error Amp Output. A frequency compen-
sation network is connected from this pin to ground to
compensate the loop. See the section Closing the Feed-
back Loop for guidelines.
BURST (Pin 14): Burst Mode Threshold Adjust Pin. A
resistor/capacitor combination from this pin to ground
programs the average load current at which automatic
Burst Mode operation is entered.
For manual control of Burst Mode operation, ground
BURST to force Burst Mode operation or connect it to V OUT
to force fixed frequency PWM mode. Note that BURST
must not be pulled higher than V OUT .
REFOUT (Pin 15): Buffered 1.22V Reference Output. This
pin can source up to 100 μ A and sink up to 10 μ A (only
active when REFEN is pulled high). This pin must be
decoupled with a 0.1 μ F capacitor for stability.
PGOOD (Pin 16): Open-Drain Output of the Power Good
Comparator. This pin will go low when the output voltage
drops 11% below its regulated value. Maximum sink
current should be limited to 10mA.
SYNCOUT (Pin 25): Sync Output Pin. A clock is provided
at the oscillator frequency, but phase-shifted 180 degrees
to allow for synchronizing two devices for an 8-phase
converter.
CCM (Pin 26): This pin is used to select forced continuous
conduction mode. Normally this pin is grounded to allow
CCM or DCM operation. To force continuous conduction
mode, tie this pin to V OUT . In this mode, a reverse current
of up to about 0.6A will be allowed before turning off the
synchronous rectifier. This will prevent pulse skipping at
light load when Burst Mode operation is disabled, and will
also improve the large-signal transient response when
going from a heavy load to a light load. For Burst Mode
operation, CCM should be low.
3425f
8
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3426ES6#TRPBF | IC REG BOOST ADJ 2A TSOT23-6 |
| LTC3427EDC#TRPBF | IC REG BOOST SYNC ADJ 0.5A 6DFN |
| LTC3428EDD#TRPBF | IC REG BOOST ADJ 4A 10DFN |
| LTC3429ES6#TRM | IC REG BST SYNC ADJ .6A TSOT23-6 |
| LTC3440EDD#TRPBF | IC REG BUCK BOOST SYNC ADJ 10DFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3426 | 制造商:LINER 制造商全称:Linear Technology 功能描述:1.2MHz Step-Up DC/DC Converter in SOT-23 |
| LTC3426ES6 | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.3V 6-Pin TSOT-23 |
| LTC3426ES6#PBF | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.3V 6-Pin TSOT-23 |
| LTC3426ES6#TRM | 制造商:Linear Technology 功能描述:Conv DC-DC Single Step Up 1.6V to 4.3V 6-Pin TSOT-23 T/R |
| LTC3426ES6#TRMPBF | 功能描述:IC REG BOOST ADJ 2A TSOT23-6 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色产品:BD91x Series Step-Down Regulators 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:2 输出电压:3.3V，0.8 V ~ 2.5 V 输入电压:4.5 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:1MHz 电流 - 输出:1.5A 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 包装:带卷 (TR) 供应商设备封装:VQFN020V4040 产品目录页面:1373 (CN2011-ZH PDF) 其它名称:BD9152MUV-E2TR |
发布紧急采购，3分钟左右您将得到回复。