- 您现在的位置：买卖IC网 > PDF目录44991 > LTC3553EUD#PBF (LINEAR TECHNOLOGY CORP) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 PDF资料下载
参数资料
| 型号： | LTC3553EUD#PBF |
| 厂商： | LINEAR TECHNOLOGY CORP |
| 元件分类： | 电源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PQCC20 |
| 封装： | 3 X 3 MM, 0.75 MM HEIGHT, LEAD FREE, PLASTIC, QFN-20 |
| 文件页数： | 10/36页 |
| 文件大小： | 518K |
| 代理商： | LTC3553EUD#PBF |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
LTC3553
18
3553fa
NTC Thermistor
The battery temperature is measured by placing a nega-
tive temperature coefcient (NTC) thermistor close to the
battery pack. To use this feature connect the NTC therm-
istor, RNTC, between the NTC pin and ground and a bias
resistor, RNOM, from VBUS to NTC, as shown in Figure 1.
RNOM should be a 1% resistor with a value equal to the
value of the chosen NTC thermistor at 25°C (R25). The
LTC3553 will pause charging when the resistance of the
NTC thermistor drops to 0.54 times the value of R25
or approximately 54k (for a Vishay curve 1 thermistor,
this corresponds to approximately 40°C). If the battery
charger is in constant-voltage mode, the safety timer also
pauses until the thermistor indicates a return to a valid
temperature. As the temperature drops, the resistance of
the NTC thermistor rises. The LTC3553 is also designed
to pause charging when the value of the NTC thermistor
increases to 3.17 times the value of R25. For a Vishay
curve 1 thermistor this resistance, 317k, corresponds to
approximately 0°C. The hot and cold comparators each
have approximately 3°C of hysteresis to prevent oscillation
about the trip point.
Alternate NTC Thermistors and Biasing
The LTC3553 provides temperature qualied charging if
a grounded thermistor and a bias resistor are connected
to NTC. By using a bias resistor whose value is equal to
the room temperature resistance of the thermistor (R25)
the upper and lower temperatures are preprogrammed
to approximately 40°C and 0°C, respectively (assuming
a Vishay curve 1 thermistor).
The upper and lower temperature thresholds can be
adjusted by either a modication of the bias resistor value
or by adding a second adjustment resistor to the circuit.
If only the bias resistor is adjusted, then either the upper
or the lower threshold can be modied but not both. The
other trip point will be determined by the characteristics
of the thermistor. Using the bias resistor in addition to an
adjustment resistor, both the upper and the lower tem-
perature trip points can be independently programmed
with the constraint that the difference between the upper
and lower temperature thresholds cannot decrease.
Examples of each technique are given below.
NTC thermistors have temperature characteristics which
are indicated on resistance-temperature conversion ta-
bles. The Vishay-Dale thermistor NTHS0603N011-N1003F,
used in the following examples, has a nominal value of
100k and follows the Vishay curve 1 resistance-tempera-
ture characteristic.
In the explanation below, the following notation is used.
R25 = Value of the thermistor at 25°C
RNTC|COLD = Value of thermistor at the cold trip point
RNTC|HOT = Value of the thermistor at the hot trip point
rCOLD = Ratio of RNTC|COLD to R25
rHOT = Ratio of RNTC|HOT to R25
RNOM = Primary thermistor bias resistor (see Figure 2)
R1 = Optional temperature range adjustment resistor (see
Figure 2)
OPERATION
Figure 1. Typical NTC Thermistor Circuit
–
+
–
+
RNOM
100k
RNTC
100k
NTC
VBUS
NTC_ENABLE
3553 F01
NTC BLOCK
TOO_COLD
TOO_HOT
0.76 VBUS
(NTC RISING)
0.35 VBUS
(NTC FALLING)
0.017 VBUS
(NTC FALLING)
–
+
20
15
相关PDF资料 |
PDF描述 |
|---|---|
| LTC3554EPD#TRPB | 0.5 A BATTERY CHARGE CONTROLLER, 1295 kHz SWITCHING FREQ-MAX, PQCC20 |
| LTC3560IS6#TRPBF | 2.1 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3563EDC | 1.75 A SWITCHING REGULATOR, 2700 kHz SWITCHING FREQ-MAX, PDSO6 |
| LTC3568EDD#TR | 4 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
| LTC3568IDD | 4 A SWITCHING REGULATOR, 4000 kHz SWITCHING FREQ-MAX, PDSO10 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3554 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower USB Power Manager with Li-Ion Charger and Two Step-Down Regulators |
| LTC3554EPD | 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower USB Power Manager with Li-Ion Charger and Two Step-Down Regulators |
| LTC3554EPD#PBF | 功能描述:IC USB POWER MANAGER 20-UTQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 标准包装:1 系列:- 应用:手持/移动设备 电流 - 电源:- 电源电压:3 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:14-WFDFN 裸露焊盘 供应商设备封装:14-LLP-EP（4x4） 包装:Digi-Reel® 配用:LP3905SD-30EV-ND - BOARD EVALUATION LP3905SD-30 其它名称:LP3905SD-30DKR |
| LTC3554EPD#TRPBF | 功能描述:IC USB POWER MANAGER 20-UTQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 电源管理 - 专用 系列:- 应用说明:Ultrasound Imaging Systems Application Note 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:37 系列:- 应用:医疗用超声波成像，声纳 电流 - 电源:- 电源电压:2.37 V ~ 6 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:56-WFQFN 裸露焊盘 供应商设备封装:56-TQFN-EP（8x8） 包装:管件 |
| LTC3554EPDPBF | 制造商:LINER 制造商全称:Linear Technology 功能描述:Micropower USB Power Manager with Li-Ion Charger and Two Step-Down Regulators |
发布紧急采购，3分钟左右您将得到回复。