参数资料
型号: LTC3709EUH#TRPBF
厂商: Linear Technology
文件页数: 8/24页
文件大小: 0K
描述: IC REG CTRLR BUCK PWM CM 32-QFN
标准包装: 2,500
系列: PolyPhase®
PWM 型: 电流模式
输出数: 1
频率 - 最大: 200kHz
占空比: 90%
电源电压: 5 V ~ 36 V
降压:
升压:
回扫:
反相:
倍增器:
除法器:
Cuk:
隔离:
工作温度: -40°C ~ 85°C
封装/外壳: 32-WFQFN 裸露焊盘
包装: 带卷 (TR)
LTC3709
PI FU CTIO S
(QFN/SSOP)
NC (Pin 12/Pins 1, 17, 18, 19, 20): No Connect.
V CC (Pin 17/Pin 25): Main Input Supply. Decouple this pin
to SGND with an RC filter (1 ? , 0.1 μ F).
DRV CC (Pin 21/Pin 29): Driver Supply. Provides supply to
the driver for the bottom gate. Also used for charging the
bootstrap capacitor.
BG1, BG2 (Pins 22, 20/Pins 30, 28): Bottom Gate Drive.
Drives the gate of the bottom N-channel MOSFET between
ground and DRV CC .
PGND1, PGND2 (Pins 23, 19/Pins 31, 27): Power Ground.
Connect this pin closely to the source of the bottom N-
channel MOSFET, the (–) terminal of C DRVCC and the (–) ter-
minal of C IN .
SENSE1 – , SENSE2 – (Pins 24, 18/Pins 32, 26): Current
Sense Comparator Input. The (–) input to the current
comparator is used to accurately Kelvin sense the bottom
side of the sense resistor or MOSFET.
SENSE1 + , SENSE2 + (Pins 25, 16/Pins 33, 24): Current
Sense Comparator Input. The (+) input to the current
comparator is normally connected to the SW node unless
using a sense resistor (see Applications Information).
SW1, SW2 (Pins 26, 15/Pins 34, 23): Switch Node. The
(–) terminal of the bootstrap capacitor C B connects here.
This pin swings from a Schottky diode voltage drop below
ground up to V IN .
TG1, TG2 (Pins 27, 14/Pins 35, 22): Top Gate Drive.
Drives the top N-channel MOSFET with a voltage swing
equal to DRV CC superimposed on the switch node voltage
SW.
BOOST1, BOOST2 (Pins 28, 13/Pins 36, 21): Boosted
Floating Driver Supply. The (+) terminal of the bootstrap
capacitor C B connects here. This pin swings from a diode
voltage drop below DRV CC up to V IN + DRV CC .
PGOOD (Pin 29/Pin 2): Power Good Output. Open-drain
logic output that is pulled to ground when output voltage
is not within ± 10% of the regulation point. The output
voltage must be out of regulation for at least 100 μ s before
the power good output is pulled to ground.
I ON (Pin 30/Pin 3): On-Time Current Input. Tie a resistor
from V IN to this pin to set the one-shot timer current and
thereby set the switching frequency.
FCB (Pin 31/Pin 4): Forced Continuous and External Clock
Input. Tie this pin to ground to force continuous synchro-
nous operation or to V CC to enable discontinuous mode
operation at light load. Feeding an external clock signal
into this pin will synchronize the LTC3709 to the external
clock and enable forced continuous mode.
V RNG (Pin 32/Pin 5): Sense Voltage Range Input. The volt-
age at this pin is ten times the nominal sense voltage at maxi-
mum output current and can be programmed from 0.5V to
2V. The sense voltage defaults to 70mV when this pin is tied
to ground, 140mV when tied to V CC .
3709fb
8
相关PDF资料
PDF描述
LTC3829IUHF#TRPBF IC REG CTRLR BUCK PWM CM 38-QFN
LTC1266ACS#TRPBF IC REG CTRLR BST PWM CM 16-SOIC
LTC1266ACS#TR IC REG CTRLR BST PWM CM 16-SOIC
LTC1625CGN#TRPBF IC REG CTRLR BUCK PWM CM 16-SSOP
LTC1625CGN#TR IC REG CTRLR BUCK PWM CM 16-SSOP
相关代理商/技术参数
参数描述
LTC-3710 制造商:LITEON 制造商全称:Lite-On Technology Corporation 功能描述:0.3 FOUR LED CLOCK FREQUENCY DISPLAYS
LTC-3710E 制造商:LITEON 制造商全称:Lite-On Technology Corporation 功能描述:0.3 FOUR LED CLOCK FREQUENCY DISPLAYS
LTC-3710G 功能描述:LED 显示器和配件 4 Digit, Green RoHS:否 制造商:Avago Technologies 显示器类型:7 Segment 数位数量:2 字符大小:7.8 mm x 14.22 mm 照明颜色:Red 波长:628 nm 共用管脚:Common Anode 工作电压:2.05 V 工作电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 35 C 封装:Tube
LTC-3710HR 功能描述:LED 显示器和配件 4 Digit, Red RoHS:否 制造商:Avago Technologies 显示器类型:7 Segment 数位数量:2 字符大小:7.8 mm x 14.22 mm 照明颜色:Red 波长:628 nm 共用管脚:Common Anode 工作电压:2.05 V 工作电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 35 C 封装:Tube
LTC-3710P 功能描述:LED 显示器和配件 4 Digit, Red RoHS:否 制造商:Avago Technologies 显示器类型:7 Segment 数位数量:2 字符大小:7.8 mm x 14.22 mm 照明颜色:Red 波长:628 nm 共用管脚:Common Anode 工作电压:2.05 V 工作电流:20 mA 最大工作温度:+ 85 C 最小工作温度:- 35 C 封装:Tube