参数资料
| 型号： | LTC3730CG#TR |
| 厂商： | Linear Technology |
| 文件页数： | 10/28页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR BUCK POLYPHASE 36-SSOP |
| 标准包装： | 2,000 |
| 应用： | 控制器，Intel 移动式 VID |
| 输入电压： | 4 V ~ 36 V |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 1.75 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 36-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 36-SSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页当前第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3730
OPERATIO
(Refer to Functional Diagram)
The top MOSFET drivers are biased from floating boot-
strap capacitor C B , which is normally recharged through
an external Schottky diode during each off cycle. When V IN
decreases to a voltage close to V OUT , however, the loop
may enter dropout and attempt to turn on the top MOSFET
continuously. The dropout detector counts the number of
oscillator cycles that the bottom MOSFET remains off and
periodically forces a brief on period to allow C B to re-
charge.
The main control loop is shut down by pulling the RUN/SS
pin low. Releasing RUN/SS allows an internal 1.5 μ A
current source to charge soft-start capacitor C SS . When
C SS reaches 1.5V, the main control loop is enabled and the
internally buffered I TH voltage is clamped but allowed to
ramp as the voltage on C SS continues to ramp. This “soft-
start” clamping prevents abrupt current from being drawn
from the input power source. When the RUN/SS pin is low,
all functions are kept in a controlled state. The RUN/SS pin
is pulled low when the V CC input voltage is below 4V or
when the IC die temperature rises above 150 ° C.
Low Current Operation
The FCB pin is a multifunction pin: 1) an analog compara-
tor input to provide regulation for a secondary winding by
forcing temporary forced PWM operation and 2) a logic
input to select between three modes of operation.
A) Burst Mode Operation
When the FCB pin voltage is below 0.6V, the controller
performs as a continuous, PWM current mode synchro-
nous switching regulator. The top and bottom MOSFETs
are alternately turned on to maintain the output voltage
independent of direction of inductor current. When the
FCB pin is below V CC – 1.5V but greater than 0.6V, the
controller performs as a Burst Mode switching regulator.
Burst Mode operation sets a minimum output current level
before turning off the top switch and turns off the synchro-
nous MOSFET(s) when the inductor current goes nega-
tive. This combination of requirements will, at low current,
force the I TH pin below a voltage threshold that will
temporarily shut off both output MOSFETs until the output
voltage drops slightly. There is a burst comparator having
60mV of hysteresis tied to the I TH pin. This hysteresis
results in output signals to the MOSFETs that turn them on
for several cycles, followed by a variable “sleep” interval
depending upon the load current. The resultant output
voltage ripple is held to a very small value by having the
hysteretic comparator after the error amplifier gain block.
B) Stage Shedding Operation
When the FCB pin is tied to the V CC pin, Burst Mode
operation is disabled and the forced minimum inductor
current requirement is removed. This provides constant
frequency, discontinuous current operation over the wid-
est possible output current range. At approximately 10%
of maximum designed load current, the second and third
output stages are shut off and the first output stage alone
is active in discontinuous current mode. This “stage
shedding” optimizes efficiency by eliminating the gate
charging losses and switching losses of the other two
output stages. Additional cycles will be skipped when the
output load current drops below 1% of maximum de-
signed load current in order to maintain the output voltage.
This Stage Shedding operation is not as efficient as Burst
Mode operation at very light loads, but does provide lower
noise, constant frequency operating mode down to light
load conditions.
C) Continuous Current Operation
Tying the FCB pin to ground will force continuous current
operation. This is the least efficient operating mode, but
may be desirable in certain applications. The output can
source or sink current in this mode. When sinking current
while in forced continuous operation, the controller will
cause current to flow back into the input filter capacitor.
If large enough, this element will prevent the input supply
from boosting to unacceptably high levels; see C OUT
selection in the Applications Information Section.
Frequency Synchronization
The phase-locked loop allows the internal oscillator to be
synchronized to an external source using the PLLIN pin.
The output of the phase detector at the PLLFLTR pin is also
the DC frequency control input of the oscillator, which
operates over a 250kHz to 600kHz range corresponding to
a voltage input from 0V to 2.4V. When locked, the PLL
3730fa
10
相关PDF资料 |
PDF描述 |
|---|---|
| EEM40DTAT-S189 | CONN EDGECARD 80POS R/A .156 SLD |
| AMC18DRTS | CONN EDGECARD 36POS .100 DIP SLD |
| RSM12DRKI-S13 | CONN EDGECARD 24POS .156 EXTEND |
| RBC65DREH-S13 | CONN EDGECARD 130PS .100 EXTEND |
| LT1182CS | IC SW REG CCFL/LCD CONTRST16SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3731CG | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3731CG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3731CG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3731CG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3731CUH | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。