参数资料
| 型号： | LTC3730CG#TR |
| 厂商： | Linear Technology |
| 文件页数： | 18/28页 |
| 文件大小： | 0K |
| 描述： | IC CTRLR BUCK POLYPHASE 36-SSOP |
| 标准包装： | 2,000 |
| 应用： | 控制器，Intel 移动式 VID |
| 输入电压： | 4 V ~ 36 V |
| 输出数： | 1 |
| 输出电压： | 0.6 V ~ 1.75 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 36-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 36-SSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
LTC3730
APPLICATIO S I FOR ATIO
Fault Conditions: Overcurrent Latchoff
The RUN/SS pins also provide the ability to latch off the
controllers when an overcurrent condition is detected. The
RUN/SScapacitorisusedinitiallytoturnonandlimitthe
inrush current of all three output stages. After the control-
lers have been started and been given adequate time to
charge up the output capacitor and provide full load
current, the RUN/SS capacitor is used for a short-circuit
timer. If the output voltage falls to less than 70% of its
nominal value, the RUN/SS capacitor begins discharging
on the assumption that the output is in an overcurrent
condition. If the condition lasts for a long enough period,
as determined by the size of the RUN/SS capacitor, the
discharge current, and the circuit trip point, the controller
will be shut down until the RUN/SS pin voltage is recycled.
If the overload occurs during start-up, the time can be
approximated by:
t LO1 >> (C SS ? 0.6V)/(1.5 μ A) = 4 ? 10 5 (C SS )
If the overload occurs after start-up, the voltage on the
RUN/SS capacitor will continue charging and will provide
additional time before latching off:
t LO2 >> (C SS ? 3V)/(1.5 μ A) = 2 ? 10 6 (C SS )
This built-in overcurrent latchoff can be overridden by
providing a pull-up resistor to the RUN/SS pin from V CC
protecting the power supply system from failure. A deci-
sion can be made after the design is complete whether to
rely solely on foldback current limiting or to enable the
latchoff feature by removing the pull-up resistor.
The value of the soft-start capacitor C SS may need to be
scaled with output current, output capacitance and load
current characteristics. The minimum soft-start capaci-
tance is given by:
C SS > (C OUT )(V OUT ) (10 –4 ) (R SENSE )
The minimum recommended soft-start capacitor of
C SS = 0.1 μ F will be sufficient for most applications.
Current Foldback
In certain applications, it may be desirable to defeat the
internal current foldback function. A negative impedance
is experienced when powering a switching regulator.
That is, the input current is higher at a lower V IN and
decreases as V IN is increased. Current foldback is de-
signed to accommodate a normal, resistive load having
increasing current draw with increasing voltage. The EAIN
pin should be artificially held 70% above its nominal
operating level of 0.6V, or 0.42V in order to prevent the IC
from “folding back” the peak current level. A suggested
circuit is shown in Figure 8.
as shown in Figure 7. When V CC is 5V, a 200k resistance
will prevent the discharge of the RUN/SS capacitor
during an overcurrent condition but also shortens the
soft-start period, so a larger RUN/SS capacitor value may
V CC
Q1
V CC
LTC3730
be required.
3.3V OR 5V
RUN/SS PIN
5V
V CC RUN/SS PIN
CALCULATE FOR
0.42V TO 0.55V
EAIN
3730 F08
D1
R SS
SHDN
C SS
SHDN
C SS
Figure 8. Foldback Current Elimination
3730 F07
Figure 7. RUN/SS Pin Interfacing
Why should you defeat overcurrent latchoff? During the
prototyping stage of a design, there may be a problem with
noise pick-up or poor layout causing the protection circuit
to latch off the controller. Defeating this feature allows
troubleshooting of the circuit and PC layout. The internal
foldback current limiting still remains active, thereby
The emitter of Q1 will hold up the EAIN pin to a voltage in
the absence of V OUT that will prevent the internal sensing
circuitry from reducing the peak output current. Remov-
ing the function in this manner eliminates the external
MOSFET’s protective feature under short-circuit condi-
tions. This technique will also prevent the short-circuit
latchoff function from turning off the part during a short-
circuit event and the peak output current will only be
limited to N ? 75mV/R SENSE .
3730fa
18
相关PDF资料 |
PDF描述 |
|---|---|
| EEM40DTAT-S189 | CONN EDGECARD 80POS R/A .156 SLD |
| AMC18DRTS | CONN EDGECARD 36POS .100 DIP SLD |
| RSM12DRKI-S13 | CONN EDGECARD 24POS .156 EXTEND |
| RBC65DREH-S13 | CONN EDGECARD 130PS .100 EXTEND |
| LT1182CS | IC SW REG CCFL/LCD CONTRST16SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3731CG | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3731CG#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3731CG#TR | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3731CG#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 36-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3731CUH | 功能描述:IC REG CTRLR BUCK PWM CM 32-QFN RoHS:否 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
发布紧急采购，3分钟左右您将得到回复。