- 您现在的位置：买卖IC网 > PDF目录20858 > LTC3783IFE#PBF (Linear Technology)IC LED DRVR PWM CONTROL 16-TSSOP PDF资料下载
参数资料
| 型号： | LTC3783IFE#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 7/24页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR PWM CONTROL 16-TSSOP |
| 标准包装： | 95 |
| 恒定电流： | 是 |
| 恒定电压： | 是 |
| 拓扑： | 回扫，PWM，SEPIC，降压（降压），升压（升压） |
| 输出数： | 1 |
| 内部驱动器： | 无 |
| 类型 - 主要： | 车载，通用 |
| 频率： | 20kHz ~ 1MHz |
| 电源电压： | 3 V ~ 36 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm）裸露焊盘 |
| 供应商设备封装： | 16-TSSOP-EP |
| 包装： | 管件 |
| 工作温度： | -40°C ~ 125°C |
LTC3783
PIN FUNCTIONS
FBN (Pin 1): Error Amplifier Inverting Input/Negative Cur-
rent Sense Pin. In voltage mode (V FBP ≤ V VREF ), this pin
senses feedback voltage from either the external resistor
divider across V OUT for output voltage regulation, or the
grounded sense resistor under the load for output current
regulation. In constant current/constant voltage mode
(V FBP > 2.5V), connect this pin to the negative side of the
current-regulating resistor. Nominal voltage for this pin in
regulation is either V FBP or (V FBP – 100mV) for V ILIM = 1.23V,
depending on operational mode (voltage or constant cur-
rent/constant voltage) set by the voltage at V FBP .
FBP (Pin 2): Error Amplifier Noninverting Input/Positive
Current Sense Pin. This pin voltage determines the control
loop’s feedback mode (voltage or constant current/constant
voltage), the threshold of which is approximately 2V. In
voltage mode (V FBP ≤ V REF ), this pin represents the desired
voltage which the regulated loop will cause FBN to follow.
In constant current/constant voltage mode (V FBP > 2.5V),
connect this pin to the positive side of the load current-
sensing resistor. The acceptable input ranges for this pin
are 0V to 1.23V (voltage mode) and 2.5V to 36V (constant
current/constant voltage mode).
I LIM (Pin 3): Current Limit Pin. Sets current sense resis-
tor offset voltage (V FBP – V FBN ) in constant current mode
regulation (i.e., when V FBP > 2.5V). Offset voltage is 100mV
when V ILIM = 1.23V and decreases proportionally with V ILIM .
Nominal voltage range for this pin is 0.1V to 1.23V.
V REF (P IN 4): Reference Voltage Pin. Provides a buffered
version of the internal bandgap voltage, which can be
connected to FBP either directly or with attenuation.
Nominal voltage for this pin is 1.23V. This pin should
never be bypassed by a capacitor to GND. Instead, a 10k
resistor to GND should be used to lower pin impedance
in noisy systems.
FREQ (Pin 5): A resistor from the FREQ pin to ground
programs the operating frequency of the chip. The nominal
voltage at the FREQ pin is 0.615V.
SYNC (Pin 6): This input allows for synchronizing the op-
erating frequency to an external clock and has an internal
100k pull-down resistor.
PWMIN (Pin 7): PWM Gate Driver Input. Internal 100k
pull-up resistor. While PWMIN is low, PWMOUT is low,
GATE stops switching and the external I TH network is
disconnected, saving the I TH state.
PWMOUT (Pin 8): PWM Gate Driver Output. Used for con-
stant current dimming (LED load) or for output disconnect
(step-up power supply).
GATE (Pin 9): Main Gate Driver Output for the Boost
Converter.
INTV CC (Pin 10): Internal 7V Regulator Output. The main
and PWM gate drivers and control circuits are powered
from this voltage. Decouple this pin locally to the IC ground
with a minimum of 4.7μF low ESR ceramic capacitor.
V IN (Pin 11): Main Supply Pin. Must be closely decoupled
to ground.
SENSE (Pin 12): Current Sense Input for the Control Loop.
Connect this pin to the drain of the main power MOSFET
for V DS sensing and highest efficiency for V SENSE ≤ 36V.
Alternatively, the SENSE pin may be connected to a resistor
in the source of the main power MOSFET. Internal leading-
edge blanking is provided for both sensing methods.
SS (Pin 13): Soft-Start Pin. Provides a 50μA pull-up current,
enabled and reset by RUN, which charges an optional external
capacitor. This voltage ramp translates into a corresponding
current limit ramp through the main MOSFET.
OV/FB (Pin 14): Overvoltage Pin/Voltage Feedback Pin.
In voltage mode (V FBP ≤ V REF ), this input, connected to
V OUT through a resistor network, sets the output voltage
at which GATE switching is disabled in order to prevent
an overvoltage situation. Nominal threshold voltage for
the OV pin is 1.32V (V REF + 7%) with 20mV hysteresis. In
current/voltage mode (V FBP > 2.5V), this pin senses V OUT
through a resistor divider and brings the loop into voltage
regulation such that pin voltage approaches V REF = 1.23V,
provided the loop is not regulating the load current (e.g.,
[V FBP – V FBN ] < 100mV for I LIM = 1.23V).
3783fb
7
相关PDF资料 |
PDF描述 |
|---|---|
| P51-300-G-S-I36-20MA-000-000 | SENSOR 300PSI 1/4-18NPT 4-20MA |
| P51-3000-S-F-I12-4.5V-000-000 | SENSOR 3000PSI 1/4-18NPT .5-4.5V |
| BAS16W-7 | DIODE SWITCH 75V 200MW SC70-3 |
| REC7.5-4815DRW/H2/A/M | CONV DC/DC 7.5W 36-72VIN +/-15V |
| P51-2000-S-S-MD-4.5V-000-000 | SENSOR 2000PSI 1/4-18NPT 4.5V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3785EUF#PBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| LTC3785EUF#TRPBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3785EUF-1#PBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3785EUF-1#TRPBF | 功能描述:IC REG CTRLR BST PWM VM 24-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3785EUFPBF | 制造商:Linear Technology 功能描述:10V Synch Buck-Boost Controller LTC3785 |
发布紧急采购，3分钟左右您将得到回复。