- 您现在的位置：买卖IC网 > PDF目录15302 > LTC3856EUH#PBF (Linear Technology)IC REG CTRLR BUCK PWM CM 32WFQFN PDF资料下载
参数资料
| 型号： | LTC3856EUH#PBF |
| 厂商： | Linear Technology |
| 文件页数： | 16/40页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM CM 32WFQFN |
| 标准包装： | 73 |
| 系列： | PolyPhase® |
| PWM 型： | 电流模式 |
| 输出数： | 1 |
| 频率 - 最大： | 850kHz |
| 占空比： | 94% |
| 电源电压： | 4.5 V ~ 38 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 包装： | 管件 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
LTC3856
APPLICATIONS INFORMATION
R SENSE =
I ( MAX ) +
V ESL ( STEP ) t ON ? t OFF
LowValueResistorsCurrentSensing
A typical sensing circuit using a discrete resistor is shown
in Figure 2a. R SENSE is chosen based on the required
output current. The current comparator has a maximum
threshold, V SENSE(MAX) , determined by the I LIM setting.
The input common mode range of the current compara-
tor is 0V to 5V. The current comparator threshold sets the
peak of the inductor current, yielding a maximum average
output current, I MAX , equal to the peak value less half the
peak-to-peak ripple current, ? I L . To calculate the sense
resistor value, use the equation:
V SENSE(MAX )
? I L
2
Because of possible PCB noise in the current sensing loop,
the AC current sensing ripple of ? V SENSE = ? I L ? R SENSE
also needs to be checked in the design to get a good
signal-to-noise ratio. In general, for a reasonably good
PCB layout, a 10mV ? V SENSE voltage is recommended as
a conservative number to start with, either for R SENSE or
DCR sensing applications. For previous generation current
mode controllers, the maximum sense voltage was high
enough (e.g., 75mV for the LTC1628/LTC3728 family)
that the voltage drop across the parasitic inductance of
the sense resistor represented a relatively small error. For
today’s highest current density solutions, however, the
value of the sense resistor can be less than 1mΩ and the
peak sense voltage can be as low as 20mV. In addition,
inductor ripple currents greater than 50% with operation
V ESL(STEP)
V SENSE
20mV/DIV
up to 1MHz are becoming more common. Under these
conditions the voltage drop across the sense resistor’s
parasitic inductance is no longer negligible. A typical sens-
ing circuit using a discrete resistor is shown in Figure 2a.
In previous generations of controllers, a small RC filter
placed near the IC was commonly used to reduce the ef-
fects of capacitive and inductive noise coupled in the sense
traces on the PCB. A typical filter consists of two series
10Ω resistors connected to a parallel 1000pF capacitor,
resulting in a time constant of 20ns. This same RC filter,
with minor modifications, can be used to extract the resis-
tive component of the current sense signal in the presence
of parasitic inductance. For example, Figure 3 illustrates
the voltage waveform across a 2mΩ sense resistor with
a 2010 footprint for the 1.2V/15A converter operating at
100% load. The waveform is the superposition of a purely
resistive component and a purely inductive component.
It was measured using two scope probes and waveform
math to obtain a differential measurement. Based on
additional measurements of the inductor ripple current
and the on-time and off-time of the top switch, the value
of the parasitic inductance was determined to be 0.5nH
using the equation:
ESL = (1)
? I L t ON + t OFF
If the RC time constant is chosen to be close to the
parasitic inductance divided by the sense resistor (L/R),
the resulting waveform looks resistive again, as shown
in Figure 4. For applications using low maximum sense
voltages, check the sense resistor manufacturer’s data
V SENSE
20mV/DIV
500ns/DIV
3856 F03
500ns/DIV
3856 F04
Figure 3. Voltage Waveform Measured
Directly Across the Sense Resistor
Figure 4. Voltage Waveform Measured After
the Sense Resistor Filter. C F = 1000pF, R F = 100Ω
3856f
相关PDF资料 |
PDF描述 |
|---|---|
| EYM25DRSS | CONN EDGECARD 50POS DIP .156 SLD |
| VE-254-EW-F2 | CONVERTER MOD DC/DC 48V 100W |
| EGM25DRSS | CONN EDGECARD 50POS DIP .156 SLD |
| LTC3866EFE#TRPBF | IC REG CTRLR BUCK PWM CM 24TSSOP |
| EEM43DREF | CONN EDGECARD 86POS .156 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC3856IFE#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TFSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3856IFE#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:4,500 系列:PowerWise® PWM 型:控制器 输出数:1 频率 - 最大:1MHz 占空比:95% 电源电压:2.8 V ~ 5.5 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:6-WDFN 裸露焊盘 包装:带卷 (TR) 配用:LM1771EVAL-ND - BOARD EVALUATION LM1771 其它名称:LM1771SSDX |
| LTC3856IUH#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 32WFQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3856IUH#TRPBF | 功能描述:IC REG CTRLR BUCK PWM CM 38-QFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| LTC3857EGN-1#PBF | 功能描述:IC REG CTRLR BUCK PWM CM 28-SSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:PolyPhase® 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
发布紧急采购，3分钟左右您将得到回复。