- 您现在的位置：买卖IC网 > PDF目录1834 > LTC4110EUHF#TRPBF (Linear Technology)IC BATTERY BACKUP MANAGER 38-QFN PDF资料下载
参数资料
| 型号： | LTC4110EUHF#TRPBF |
| 厂商： | Linear Technology |
| 文件页数： | 16/52页 |
| 文件大小： | 0K |
| 描述： | IC BATTERY BACKUP MANAGER 38-QFN |
| 标准包装： | 2,500 |
| 功能： | 备份管理 |
| 电池化学： | 铅酸，锂离子，锂聚合物，镍镉，镍氢，超级电容器 |
| 电源电压： | 4.5 V ~ 19 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 38-WFQFN 裸露焊盘 |
| 供应商设备封装： | 38-QFN（5x7） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页当前第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页
LTC4110
OPERATION
When the battery voltage exceeds the bulk charge threshold
(V BC ), the charger begins the bulk charge portion of the
charge cycle. As the battery accepts charge, the voltage
increases. Constant-current charge continues until the
battery approaches the constant voltage. At this time, the
charge current will begin to drop, signaling the beginning
of the constant-voltage portion of the charge cycle.
The charger will maintain the constant voltage across the bat-
tery until either C/x is reached or 100% of the programmed
bulk charge time has elapsed during bulk charge. When
the current drops to approximately 20% of the full-scale
charge current, an internal C/x comparator will initiate the
start of the top-off stage. The top-off stage charges for
25% of the total programmed bulk charge time. When the
time elapses, charge is terminated and CHGb (GPIO1 pin)
is forced to a high impedance state and CHG_STATE_0 and
CHG_STATE_1 register bits will be set low. Should the total
bulk charge time elapse before C/x is reached, charge is
terminated and a CHG_FLT fault is indicated until cleared
by the RESET_TO_ZERO or POR_RESET SMBus write
commands, SHDN pin toggle or the battery removed and
replaced. Fault conditions are not cleared when the supply
input is removed if the battery has suf?cient voltage.
An optional external thermistor network is sampled at
regular intervals to monitor battery temperature and to
detect battery presence. If the thermistor temperature is
hot (see the SafetySignal Decoder section), the charge
timer is paused, charge current is halted, CHG_FLTb (GPIO3
pin) is forced low and the CHG_FLT bit will be set high.
CHGb (GPIO1 pin) , CHG_STATE_0 and CHG_STATE_1
register bits will not be affected. When the thermistor
value returns to an acceptable value, charging resumes,
CHG_FLTb (GPIO3 pin) returns to high impedance and the
CHG_FLT bit will be reset low. An open thermistor indicates
absence of a battery. To defeat the temperature monitoring
function, replace the thermistor with a resistor to indicate
ideal battery temperature. When a thermistor is not used,
the resistor circuit must be routed through the battery
connector if battery presence detection is required.
After a charge cycle has ended without fault, the charge
cycle is automatically restarted if the average battery cell
time charging can be forced to stop by pulling the SHDN
pin high or setting the CHARGE_INHIBIT bit high through
the SMBus.
SMART BATTERY CHARGE MODE
This section explains operation for smart batteries with a
SMBus interface. Smart Li-Ion is selected by connecting
the TYPE pin to the V DD pin and smart Nickel (NiMH/NiCd)
is selected by connecting the TYPE pin to the V REF pin.
The LTC4110 only implements a subset of smart battery
charger commands; the actual charging algorithm is
determined by LTC4110 through external resistors even
if the battery is “smart.”
The LTC4110 operates as a high ef?ciency, synchronous,
PWM ?yback battery charger with constant current and
constant ?oat voltage regions of operation. The constant-
charge current is programmed by the combination of a
resistor (R CHG ) from the I CHG pin to ground, a battery
current sense resistor (R SNS(BAT) ) and CSP/CSN pin
resistors. For Li-Ion the constant voltage (?oat voltage)
is programmed to one of four values (4.2V, 8.4V, 12.6V,
16.8V) depending on the number of series cells using the
SELC pin and can be adjusted ±0.3V/cell with the V CHG
pin. For nickel batteries the constant-voltage function is
not used, however, a non-zero value is still required to be
written to the ChargingVoltage() register. The internal auto
recharge function is inhibited for smart batteries.
If the battery voltage exceeds 107.5% (V BOV ) of the
programmed ?oat voltage during any stage of charge,
the charger pauses until the voltage drops below the
hysteresis (V BOVH ). The timer is not stopped and no fault
is indicated. This function is disabled when nickel based
smart batteries are used.
There are four states associated with smart battery charge
mode, namely:
? SMBus Wake-Up Charge State
? SMBus Preconditioning Charge State
? SMBus Bulk Charge State
? SMBus OFF State
These states are explained in the following four sections.
voltage falls below the auto recharge threshold. At any
4110fb
16
相关PDF资料 |
PDF描述 |
|---|---|
| LTC4150IMS#TRPBF | IC COUNTER/GAUGE GAS/BATT 10MSOP |
| LTC4155IUFD#TRPBF | IC I2C POWER MANAGER DUAL 28QFN |
| LTC4160EUDC-1#TRPBF | IC SWITCH POWER MANAGER 20-QFN |
| LTC4410ES6#TRPBF | IC POWER MANAGER USB TSOT23-6 |
| LTC4411ES5#TRMPBF | IC IDEAL DIODE LOW LOSS TSOT23-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| LTC4120IUD#PBF | 制造商:Linear Technology 功能描述:BATTERY CHARGER, 400MA, QFN-16, Battery Type:Li-Ion, Li-Polymer, Input Voltage:4 |
| LTC4150 | 制造商:LINER 制造商全称:Linear Technology 功能描述:High Voltage, High-Side Current Sense |
| LTC4150_1 | 制造商:LINER 制造商全称:Linear Technology 功能描述:Coulomb Counter/ Battery Gas Gauge |
| LTC4150CMS | 功能描述:IC COUNTER/GAUGE GAS/BATT 10MSOP RoHS:否 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 标准包装:61 系列:- 功能:电源管理 电池化学:锂离子（Li-Ion）、锂聚合物（Li-Pol） 电源电压:4.35 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:22-WFDFN 裸露焊盘 供应商设备封装:22-DFN（6x3）裸露焊盘 包装:管件 |
| LTC4150CMS#PBF | 功能描述:IC COUNTER/GAUGE GAS/BATT 10MSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 电池管理 系列:- 其它有关文件:STC3100 View All Specifications 特色产品:STC3100 - Battery Monitor IC 标准包装:4,000 系列:- 功能:燃料，电量检测计/监控器 电池化学:锂离子（Li-Ion） 电源电压:2.7 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 供应商设备封装:8-MiniSO 包装:带卷 (TR) 其它名称:497-10526-2 |
发布紧急采购，3分钟左右您将得到回复。