- 您现在的位置：买卖IC网 > PDF目录1841 > MAX1997ETJ+T (Maxim Integrated Products)IC PWR SUPPLY TFT LCD 32TQFN PDF资料下载
参数资料
| 型号： | MAX1997ETJ+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 18/31页 |
| 文件大小： | 0K |
| 描述： | IC PWR SUPPLY TFT LCD 32TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 应用： | 控制器，TFT LCD |
| 输入电压： | 2.7 V ~ 5.5 V |
| 输出数： | 5 |
| 输出电压： | 2.7 V ~ 13 V |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-WFQFN 裸露焊盘 |
| 供应商设备封装： | 32-TQFN-EP（5x5） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页当前第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页
Quintuple/Triple-Output TFT LCD Power Supplies
with Fault Protection and VCOM Buffer
V IN
IN
INPUT
CAP
V REF
2
GATE
EXTERNAL
PFET
INDUCTOR
INPUT
CAP
10 μ A
GATE
ENABLE
Figure 6. External P-Channel MOSFET Input Switch Control
Linear-Regulator Controller REG 2
(MAX1997 Only)
The linear-regulator controller REG 2 is an analog gain
block with an open-drain N-channel output. It drives an
external PNP pass transistor with a 2.2k ? base-to-emitter
resistor (Figure 1). Its guaranteed base drive sink current
is at least 5mA. The regulator is designed to deliver
30mA with an output capacitor of 2.2μF.
REG 2 is enabled when SHDN is high, the gate to the
input P-channel MOSFET is low, ONDC is high, and
V CT > V ON2 . (See the Power-Up Sequencing and
Inrush Current Control section.) Each time it is enabled,
the regulator goes through a soft-start routine that
ramps up its reference input. REG 2 is typically used to
provide the TFT LCD gamma reference voltage.
VCOM Buffer (MAX1997 Only)
The MAX1997 includes a VCOM buffer, which is an oper-
ational transconductance amplifier that provides a current
output for driving the backplane of a TFT LCD panel. The
unity-gain bandwidth of this current-output buffer is:
GBW = g m /C OUT
where g m is the amplifier ’ s transconductance, which is
the ratio of the output current to the input voltage. The
VCOM buffer requires only a 0.47μF ceramic output
capacitor for stability. The bandwidth is inversely pro-
portional to the output capacitance. Thus, large capaci-
tive loads reduce the bandwidth of the buffer output.
In order to improve the transient response time, the ampli-
fier has nonlinear transconductance. The amplifier senses
the output current and increases the transconductance
as the output current increases. The effect is to provide
additional output current when the load demands it.
Undervoltage Lockout (UVLO)
To ensure that the input voltage is high enough for reli-
able operation, the MAX1997/MAX1998 include an
undervoltage lockout (UVLO) circuit. The UVLO thresh-
old at the IN pin is 2.7V (typ) rising and 2.35V (typ)
falling. The 350mV (typ) hysteresis prevents supply tran-
sients from causing a restart. Once the input voltage
exceeds the UVLO rising threshold, the controller
enables the reference block. Once the reference is
above 1.05V, an internal 10μA current source pulls the
GATE pin low and turns on an external P-channel
MOSFET switch (P1, Figure 1) that connects the input
supply to the regulator. When the input voltage falls below
the UVLO falling threshold, the controller turns off the ref-
erence and all the regulator outputs, and pulls GATE high
with an internal 100 ? switch to turn off P1 (Figure 6).
Reference Voltage (REF)
The reference output is nominally 1.25V, and can
source up to 75μA. (See the Typical Operating
Characteristics. ) Bypass REF with a 0.22μF ceramic
capacitor connected between REF and GND.
Oscillator Frequency Control (FREQ)
The internal oscillator frequency is adjustable using the
three-level FREQ input. Connect FREQ to ground for
375kHz operation, connect FREQ to V IN for 1.5MHz
operation, and leave FREQ unconnected for 750kHz
operation. When FREQ is left unconnected, bypass
FREQ to ground with a 1000pF to 0.1μF capacitor to
prevent switching noise from coupling into the pin ’ s
high input impedance. Note that the soft-start period
scales with the oscillator frequency. (See the Soft-Start
section.) The fault timer period does not scale with the
oscillator frequency.
18
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX256ASA+T | IC DRVR H-BRIDGE 8-SOIC |
| MAX3273ETG+T | IC LASR DRVR 2.7GBPS 3.6V 24TQFN |
| MAX3296CTI+T | IC LASR DRVR 2.5GBPS 5.5V 28TQFN |
| MAX3353EEUE+T | IC CHARGE PUMP USB OTG 16TSSOP |
| MAX3355EEUD+T | IC CHARGE PUMP USB OTG 14TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX1997EVKIT | 制造商:Maxim Integrated Products 功能描述:QUINTUPLE/TRIPLE OUTPUT TFT LCD POWER SUPPLIE - Bulk |
| MAX19983A | 功能描述:上下转换器 RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128 |
| MAX19985AETX+ | 功能描述:上下转换器 High-Gain 700MHz to 1GHz Downconv RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128 |
| MAX19985AETX+T | 功能描述:上下转换器 High-Gain 700MHz to 1GHz Downconv RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128 |
| MAX19985ETX+ | 功能描述:上下转换器 Dual, SiGe, .7-1GHz Downconversion Mixer RoHS:否 制造商:Texas Instruments 产品:Down Converters 射频:52 MHz to 78 MHz 中频:300 MHz LO频率: 功率增益: P1dB: 工作电源电压:1.8 V, 3.3 V 工作电源电流:120 mA 最大功率耗散:1 W 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PQFP-128 |
发布紧急采购，3分钟左右您将得到回复。