参数资料
| 型号： | MAX8756ETI+T |
| 厂商： | Maxim Integrated Products |
| 文件页数： | 20/30页 |
| 文件大小： | 0K |
| 描述： | IC CNTRL DUAL PS 28-TQFN |
| 产品培训模块： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 标准包装： | 2,500 |
| 应用： | 控制器，笔记本电脑电源系统 |
| 输入电压： | 4 V ~ 26 V |
| 输出数： | 2 |
| 输出电压： | 1.5V，1.8V，1 V ~ 2.3 V |
| 工作温度： | 0°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-WFQFN 裸露焊盘 |
| 供应商设备封装： | 28-TQFN-EP（4x4） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页当前第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页
Interleaved High-Efficiency, Dual Power-Supply
Controllers for Notebook Computers
V GS ( TH ) > V IN ? RSS ?
The internal pulldown transistor that drives DL_ low is
robust, with a 0.6 Ω (typ) on-resistance. This helps pre-
vent DL_ from being pulled up due to capacitive cou-
pling from the drain to the gate of the low-side MOSFETs
when the inductor node (LX_) quickly switches from
ground to V IN . Applications with high input voltages and
long inductive driver traces may require additional gate-
to-source capacitance to ensure fast-rising LX_ edges
do not pull up the low-side MOSFETs gate, causing
shoot-through currents. The capacitive coupling
between LX_ and DL_ created by the MOSFET’s gate-to-
drain capacitance (C RSS ), gate-to-source capacitance
(C ISS - C RSS ), and additional board parasitics should not
exceed the following minimum threshold:
? C ?
? C ISS ?
Variation of the threshold voltage may cause problems
in marginal designs. Alternatively, adding a resistor
less than 10 Ω in series with BST_ may remedy the
problem by increasing the turn-on time of the high-side
MOSFET without degrading the turn-off time (Figure 6).
C BYP
V DD
MAX8716
Power-Good Output (PGOOD_)
PGOOD_ is the open-drain output of a comparator that
continuously monitors each SMPS output voltage for
overvoltage and undervoltage conditions. PGOOD_ is
actively held low in shutdown (ON_ = GND), soft-start,
and soft-shutdown. Once the analog soft-start termi-
nates, PGOOD_ becomes high impedance as long as
the output is above 90% of the nominal regulation volt-
age set by FB_. PGOOD_ goes low once the output
drops 10% below its nominal regulation point, an output
overvoltage fault occurs, or ON_ is pulled low. For a
logic-level PGOOD_ output voltage, connect an exter-
nal pullup resistor between PGOOD_ and +5V or +3.3V.
A 100k Ω pullup resistor works well in most applications.
Fault Protection
Output Overvoltage Protection
(MAX8716/MAX8717/MAX8756 Only)
If the output voltage of either SMPS rises above 115%
of its nominal regulation voltage, the corresponding
controller sets its overvoltage fault latch, pulls PGOOD_
low, and forces DL_ high for the corresponding SMPS
controller. The other controller is not affected. If the
condition that caused the overvoltage persists (such as
a shorted high-side MOSFET), the battery fuse will
blow. Cycle V CC below 1V or toggle ON_ to clear the
overvoltage fault latch and restart the SMPS controller.
MAX8717
MAX8756
D BST
FAULT
MAX8757
BST
(R BST )*
POWER-GOOD
0.9 x
1.15 x
PROTECTION
0.7 x
C BST
INPUT (V IN )
INT REF_
INT REF_
INT REF_
INTERNAL FB
DH
N H
LX
L
POR
V DD
DL
N L
TIMER
PGND
(C NL )*
FAULT
LATCH
FAULT
POWER-
GOOD
(R BST )* OPTIONAL—THE RESISTOR LOWERS EMI BY DECREASING
THE SWITCHING-NODE RISE TIME.
(C NL )* OPTIONAL—THE CAPACITOR REDUCES LX TO DL CAPACITIVE
COUPLING THAT CAN CAUSE SHOOT-THROUGH CURRENTS.
Figure 6. Optional Gate-Driver Circuitry
Figure 7. Power-Good and Fault Protection
20
______________________________________________________________________________________
相关PDF资料 |
PDF描述 |
|---|---|
| MAX8758ETG+T | IC REG STEP UP 24-TQFN |
| MAX8759ETI+T | IC CNTRL CCFL BACKLIGHT 28TQFN |
| MAX8760ETL+T | IC CNTRLR QUICK PWM 40-TQFN |
| MAX8761ETG+T | IC REG LINEAR LCD 24-TQFN |
| MAX8764ETP+T | IC CNTRL STP DWN HS 20-TQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MAX8757ETG+ | 制造商:Maxim Integrated Products 功能描述:INTERLEAVED HI-EFF AND DUAL PS CNTRLR 24TQFN EP - Rail/Tube |
| MAX8757ETI+ | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX8758ETG+ | 功能描述:LCD 驱动器 Step-Up Regulator RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
| MAX8758ETG+T | 功能描述:LCD 驱动器 Step-Up Regulator RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
| MAX8758ETJ | 功能描述:LCD 驱动器 Step-Up Regulator RoHS:否 制造商:Maxim Integrated 数位数量:4.5 片段数量:30 最大时钟频率:19 KHz 工作电源电压:3 V to 3.6 V 最大工作温度:+ 85 C 最小工作温度:- 20 C 封装 / 箱体:PDIP-40 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。