- 您现在的位置：买卖IC网 > PDF目录16630 > MC33912BACR2 (Freescale Semiconductor)IC SYSTEM BASIS CHIP 32LQFP PDF资料下载
参数资料
| 型号： | MC33912BACR2 |
| 厂商： | Freescale Semiconductor |
| 文件页数： | 31/95页 |
| 文件大小： | 0K |
| 描述： | IC SYSTEM BASIS CHIP 32LQFP |
| 标准包装： | 2,000 |
| 应用： | 系统基础芯片 |
| 电流 - 电源： | 4.5mA |
| 电源电压： | 5.5 V ~ 27 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 32-LQFP |
| 供应商设备封装： | 32-LQFP（7x7） |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页当前第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页
MC33912G5AC / MC34912G5AC
FUNCTIONAL DEVICE OPERATIONS
OPERATIONAL MODES
RST Wake-up
While in Stop mode, the 33912 can wake-up when the RST
pin is held low long enough to pass the internal glitch filter.
Then, the 33912 will change to Normal Request or Normal
modes depending on the WDCONF pin configuration. The
RST wake-up does not generate an interrupt and is not
reported via SPI.
From Stop mode, the following wake-up events can be
configured:
? Wake-up from Lx inputs without cyclic sense
? Cyclic sense wake-up inputs
WINDOW CLOSED
NO WATCHDOG CLEAR
ALLOWED
WD TIMING X 50%
WINDOW OPEN
FOR WATCHDOG
CLEAR
WD TIMING X 50%
? Force wake-up
? CS wake-up
? LIN wake-up
? RST wake-up
From Sleep mode, the following wake-up events can be
configured:
? Wake-up from Lx inputs without cyclic sense
? Cyclic sense wake-up inputs
? Force wake-up
? LIN wake-up
WINDOW WATCHDOG
The 33912 includes a configurable window watchdog which
is active in Normal mode. The watchdog can be configured by
an external resistor connected to the WDCONF pin. The
resistor is used to achieve higher precision in the timebase
used for the watchdog.
SPI clears are performed by writing through the SPI in the
MOD bits of the Mode Control Register (MCR).
During the first half of the SPI timeout, watchdog clears are
not allowed, but after the first half of the SPI timeout window,
the clear operation opens. If a clear operation is performed
outside the window, the 33912 will reset the MCU, in the
same way as when the watchdog overflows.
WD PERIOD (t PWD )
WD TIMING SELECTED BY RESISTOR
ON WDCONF PIN
Figure 15. Window Watchdog Operation
To disable the watchdog function in Normal mode the user
must connect the WDCONF pin to ground. This measure
effectively disables Normal Request mode. The WDOFF bit
in the Watchdog Status Register (WDSR) will be set. This
condition is only detected during Reset mode.
If neither a resistor nor a connection to ground is detected,
the watchdog falls back to the internal lower precision
timebase of 150 ms (typ.) and signals the faulty condition
through the Watchdog Status Register (WDSR).
The watchdog timebase can be further divided by a prescaler
which can be configured by the Timing Control Register
(TIMCR). During Normal Request mode, the window
watchdog is not active but there is a 150 ms (typ.) timeout for
leaving the Normal Request mode. In case of a timeout, the
33912 will enter into Reset mode, resetting the
microcontroller before entering again into Normal Request
mode.
FAULTS DETECTION MANAGEMENT
The 33912 has the capability to detect faults like an over or
under-voltage on VS1, TxD in permanent Dominant State,
Over-temperature on HS, LIN. It is able to take corrective
actions accordingly. Most of faults are monitoring through
SPI and the Interrupt pin. The microcontroller can also take
actions.
The following table summarizes all fault sources the device is
able to detect with associated conditions. The status for a
device recovery and the SPI or pins monitoring are also
described.
33912
Analog Integrated Circuit Device Data ?
Freescale Semiconductor
31
相关PDF资料 |
PDF描述 |
|---|---|
| EMC08DREN-S734 | CONN EDGECARD 16POS .100 EYELET |
| MC33912BAC | IC SYSTEM BASIS CHIP 32LQFP |
| EEC26DREI-S734 | CONN EDGECARD 52POS .100 EYELET |
| H3DKH-1406M | IDC CABLE - HKR14H/AE14M/HPK14H |
| EMC08DREH-S734 | CONN EDGECARD 16POS .100 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC33912G5AC | 功能描述:LIN 收发器 SBC LIN 2.5G RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
| MC33912G5ACR2 | 功能描述:LIN 收发器 SBC LIN 2.5G RoHS:否 制造商:NXP Semiconductors 工作电源电压: 电源电流: 最大工作温度: 封装 / 箱体:SO-8 |
| MC33916 | 制造商:PRIVATE LABEL 功能描述:DC Brushless Fan, 70x70x25mm, 12VDC Ball |
| MC33919 | 制造商:PRIVATE LABEL 功能描述:FAN |
| MC33926PNB | 功能描述:马达/运动/点火控制器和驱动器 THROTTLE CTRL H-BRIDGE RoHS:否 制造商:STMicroelectronics 产品:Stepper Motor Controllers / Drivers 类型:2 Phase Stepper Motor Driver 工作电源电压:8 V to 45 V 电源电流:0.5 mA 工作温度:- 25 C to + 125 C 安装风格:SMD/SMT 封装 / 箱体:HTSSOP-28 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。