- 您现在的位置：买卖IC网 > PDF目录80446 > MC68L11D0FNE2 (FREESCALE SEMICONDUCTOR INC) 8-BIT, 2 MHz, MICROCONTROLLER, PQCC44 PDF资料下载
参数资料
| 型号： | MC68L11D0FNE2 |
| 厂商： | FREESCALE SEMICONDUCTOR INC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, 2 MHz, MICROCONTROLLER, PQCC44 |
| 封装： | PLASTIC, LCC-44 |
| 文件页数： | 63/138页 |
| 文件大小： | 1047K |
| 代理商： | MC68L11D0FNE2 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页当前第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页第112页第113页第114页第115页第116页第117页第118页第119页第120页第121页第122页第123页第124页第125页第126页第127页第128页第129页第130页第131页第132页第133页第134页第135页第136页第137页第138页
Operating Modes and Memory
MC68HC711D3 Data Sheet, Rev. 2.1
30
Freescale Semiconductor
RAM2–RAM0 (INIT bits 7–4) specify the starting address for the 192 bytes of static RAM. REG3–REG0
(INIT bits 3–0) specify the starting address for the control and status register block. In each case, the four
RAM or REG bits become the four upper bits of the 16-bit address of the RAM or register. Since the INIT
register is set to $00 by reset, the internal registers begin at $0000 and RAM begins at $0040.
Throughout this document, control and status register addresses are displayed with the high-order digit
shown as a bold 0. This convention indicates that the register block may be relocated to any 4-K memory
page, but that its default location is $0000.
RAM and the control and status registers can be relocated independently. If the control and status
registers are relocated in such a way as to conflict with PROM, then the register block takes priority, and
the EPROM or OTPROM at those locations becomes inaccessible. No harmful conflicts result. Lower
priority resources simply become inaccessible. Similarly, if an internal resource conflicts with an external
device, no harmful conflict results, since data from the external device is not applied to the internal data
bus. Thus, it cannot interfere with the internal read.
NOTE
There are unused register locations in the 64-byte control and status
register block. Reads of these unused registers return data from the
undriven internal data bus, not from another source that happens to be
located at the same address.
2.3.3 Configuration Control Register
The configuration control register (CONFIG) controls the presence of OTPROM or EPROM in the memory
map and enables the computer operating properly (COP) watchdog system.
This register is writable only once in expanded and single-chip modes (SMOD = 0). In these mode, the
COP watchdog timer is enabled out of reset. In all modes, except normal expanded, EPROM is enabled
and located at $F000–$FFFF. In normal expanded mode, EPROM is enabled and located at
$7000–$7FFF. Should the user wish to be in expanded mode, but with EPROM mapped at
$F000–$FFFF, he must reset in single-chip mode, and write a 1 to the MDA bit in the HPRIO register.
Bits 7–3 and 0 — Not implemented
Always read 0.
NOCOP — Computer Operating Properly System Disable Bit
This bit is cleared out of reset in normal modes (single chip and expanded), enabling the COP system.
It is writable only once after reset in these modes (SMOD = 0). In the special modes (test and
bootstrap) (SMOD = 1), this bit comes out of reset set, and is writable any time.
1 = COP system is disabled.
0 = COP system is enabled, reset forced on timeout.
Address: $003F
Bit 7
654321
Bit 0
Read:
00000
NOCOP
ROMON
0
Write:
Reset:
00000
U
0
U = Unaffected
Figure 2-4. Configuration Control Register (CONFIG)
相关PDF资料 |
PDF描述 |
|---|---|
| MC908GR60AVFAR2 | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP48 |
| MC908GZ48VFAE | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP48 |
| MC908GZ60CFJE | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP32 |
| MC9S08RE16FGE | 8-BIT, FLASH, 8 MHz, MICROCONTROLLER, PQFP44 |
| MC9S12C96CPBR2 | 16-BIT, FLASH, 25 MHz, MICROCONTROLLER, PQFP52 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MC68L11E0FN2 | 制造商:Rochester Electronics LLC 功能描述:8-BIT MCU,512RAM,A/D,LVDC - Bulk |
| MC68L11E0FNE2 | 功能描述:IC MCU 8BIT LV 512RAM 52-PLCC RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:HC11 标准包装:1 系列:87C 核心处理器:MCS 51 芯体尺寸:8-位 速度:16MHz 连通性:SIO 外围设备:- 输入/输出数:32 程序存储器容量:8KB（8K x 8） 程序存储器类型:OTP EEPROM 大小:- RAM 容量:256 x 8 电压 - 电源 (Vcc/Vdd):4 V ~ 6 V 数据转换器:- 振荡器型:外部 工作温度:0°C ~ 70°C 封装/外壳:44-DIP 包装:管件 其它名称:864285 |
| MC68L11E1CFNE2 | 功能描述:8位微控制器 -MCU 8B MCU RAM EE A/D LVDC RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| MC68L11E1FNE2 | 功能描述:8位微控制器 -MCU 8B MCU RAM EE A/D LVD RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
| MC68L11F1CFNE3 | 功能描述:8位微控制器 -MCU 8B MCU 1KRAM 512BYTES RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。