参数资料
型号: MCP2140A-I/SS
厂商: Microchip Technology
文件页数: 17/66页
文件大小: 0K
描述: IC IRDA CONTROLLR DTE/DCE 20SSOP
标准包装: 67
控制器类型: IRDA 标准协议栈控制器
接口: UART
电源电压: 3 V ~ 5.5 V
电流 - 电源: 2.2mA
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 20-SSOP(0.209",5.30mm 宽)
供应商设备封装: 20-SSOP
包装: 管件
产品目录页面: 685 (CN2011-ZH PDF)
配用: MCP2140DM-TMPSNS-ND - BOARD DEMO FOR MCP2140
MCP2140A
DS22050B-page 24
2007-2011 Microchip Technology Inc.
2.14
Migrating from the MCP2140 to the
MCP2140A
This section shows you in the major differences
between the MCP2140 and the MCP2140A. Your appli-
cation may have other sensitivities and a complete
system validation should be done.
Table 2-7 shows the differences and enhancements of
the MCP2140A in comparison to the MCP2140.
TABLE 2-7:
DIFFERENCE BETWEEN
MCP2140 AND MCP2140A
2.15
The PIC IrDA Standard Stack
Library and the MCP2140A
The MCP2140A is compatible with the PIC IrDA Stan-
dard Stack Library routines for 16-bit PIC microcon-
trollers. The application must use the Client Library
routines for the IrCOMM 9-wire cooked protocol (for pri-
mary device operation).
2.16
References
The IrDA standards organization information can be
found at:
http://www.irda.org
Some common manufacturers of optical transceivers
are shown in Table 2-8.
TABLE 2-8:
COMMON OPTICAL
TRANSCEIVER
MANUFACTURERS
Feature
MCP2140
MCP2140A
Voltage Range
3.0V - 5.5V 2.0V - 5.5V
Frequency of Operation
(MHz)
7.3728
3.6864
UART operation
Half Duplex Full Duplex
UART Receiver Buffer
Size (bytes) (max.)
29
60 (2)
UART Transmit Buffer
Size (bytes) (max.)
29
60
IR Receiver Frame
Payload Size (bytes)
(max.)
64 (3)
IR Transmit Frame
Payload Size (bytes)
(max.)
64 (3)
Max IDD (uA)
at min. VDD.
PHACT = H
2200
407
PHACT = L
60
23
Integrated Optical
Transceivers RXD
Wave Shaping Circuit
Required
Not
Required
(1)
Optical Transceiver RXPD
bit signal polarity
High to Low
or
Low to High
High to Low
only
Note 1: The external wave shaping circuit is not
required. For applications replacing the
MCP2140, components of the circuit can
be replaced to effectively remove the
waveshaping circuit. See Section 2.13
2: The MCP2140A will drive the CTS signal
active after the UART receive buffer has
59 bytes. The Receive buffer supports the
reception of a 60th byte for systems that
have 0 delay between UART data bytes.
3: Includes 4 bytes overhead for 9-wire
“cooked” protocol. This means that there
are a maximum of 60 data bytes per
frame.
Company
Company Web Site Address
Sharp
www.sharpsma.com
Infineon
www.infineon.com
Agilent
www.agilent.com
Vishay
www.vishay.com
Rohm
www.rohm.com
相关PDF资料
PDF描述
MCP2515-I/ST IC CAN CONTROLLER W/SPI 20TSSOP
PIC16LF1902-E/SP MCU 3.5KB FLASH 128B RAM 28SPDIP
PIC16LF1825T-I/ML MCU PIC 14KB FLASH 16-QFN
PIC16F720-E/P MCU PIC 3.5KB FLASH 128B 20PDIP
MCP2515T-I/ML IC CAN CTLR W/SPI 2.0B 20-QFN
相关代理商/技术参数
参数描述
MCP2140AT-I/P 制造商:MICROCHIP 制造商全称:Microchip Technology 功能描述:IrDA㈢ Standard Protocol Stack Controller With Fixed 9600 Baud Communication Rate
MCP2140AT-I/SO 功能描述:网络控制器与处理器 IC Enhanced MCP2140 Win Mobile 5.0 compatble RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流(最大值):595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray
MCP2140AT-I/SS 功能描述:网络控制器与处理器 IC Enhanced MCP2140 Win Mobile 5.0 compatble RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流(最大值):595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray
MCP2140DM-TMPSNS 功能描述:温度传感器开发工具 MCP2140 IrDA Wire- less Temp Demo RoHS:否 制造商:Texas Instruments 产品类型:Temperature Sensors and Control ICs 工具用于评估:MSP430G2553 接口类型:USB 工作电源电压: 工作电源电流:
MCP2140-I/P 功能描述:网络控制器与处理器 IC 9600bd fixd spd IrDA RoHS:否 制造商:Micrel 产品:Controller Area Network (CAN) 收发器数量: 数据速率: 电源电流(最大值):595 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:PBGA-400 封装:Tray