- 您现在的位置：买卖IC网 > Datasheet目录477 > MICRF507YML TR (Micrel Inc)TXRX FSK LOW PWR W/AMP 32MLF Datasheet资料下载
参数资料
| 型号： | MICRF507YML TR |
| 厂商： | Micrel Inc |
| 文件页数： | 25/47页 |
| 文件大小： | 0K |
| 描述： | TXRX FSK LOW PWR W/AMP 32MLF |
| 特色产品： | MICRF507 Low-Power FSK Transceiver |
| 标准包装： | 1 |
| 系列： | RadioWire® |
| 频率： | 470MHz ~ 510MHz |
| 数据传输率 - 最大： | 200kbps |
| 调制或协议： | FSK |
| 应用： | AMR，ISM，SRD |
| 功率 - 输出： | 10dBm |
| 灵敏度： | -113dBm |
| 电源电压： | 2 V ~ 2.5 V |
| 电流 - 接收： | 12mA |
| 电流 - 传输： | 21.5mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 32-VFQFN 裸露焊盘，32-MLF? |
| 包装： | 标准包装 |
| 其它名称： | 576-3694-6 MICRF507YML TRDKR MICRF507YML TRDKR-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页
Micrel, Inc.
The front end’s input impedance, with no matching
network, is close to 50 ? as shown in Figure 15. This gives
an input reflection coefficient of about -13dB. Although the
receiver does not require a matching network to optimize
MICRF507
The pre-filter and switched-capacitor filters in cascade
must pass the full IF bandwidth of the received signal. In a
zero-IF receiver such as the MICRF507 this bandwidth is
as follows:
the gain, a matching network is recommended for
harmonic suppression during transmission and for
improved selectivity in reception.
f BW = f OFFSET + f DEV +
r b
2
Sallen-Key Filters
Each IF channel includes a pre-amplifier and a pre-filter.
The preamplifier has a gain of 22dB. The IF amplifier also
removes DC offset. Gain varies by less than 0.5dB over a
2.0V to 2.5V variation in power supply.
The pre-filter is implemented as a three-pole Sallen-Key
low-pass filter. It protects the switched-capacitor filter that
follows it from strong adjacent channel signals and also
serves as an anti-aliasing filter. It is programmable to four
different cut-off frequencies as shown in Table 14.
where
f BW : Needed receiver bandwidth; f CUT above should
not be smaller than f BW [Hz]
f OFFSET : Total frequency offset between receiver and
transmitter [Hz]
f DEV : Single-sided frequency deviation [Hz]
r b : The bit rate in bits/sec
RSSI
PF_FC1
0
0
1
1
PF_FC0
0
1
0
1
Cutoff (3dB filter corner)
100kHz
150kHz
230kHz
340kHz
Table 14. Pre-Filter Bit Field
Switched Capacitor Filter
The main IF channel filter is a switched-capacitor
f CUT =
implementation of a six-pole elliptic low pass filter. This
meets selectivity and dynamic range requirements with
minimum total capacitance. The cut-off frequency of the
switched-capacitor filter is adjustable by changing the
clock frequency.
A 6-bit frequency divider, programmed by the ScClk[5:0]
field, is clocked by the crystal oscillator. Its output, which is
20 times the filter’s cutoff frequency, is then divided by 4 to
generate the correct non-overlapping clock phases needed
by the filter. The cut-off frequency of the filter is given by:
f XCO
40 ? ScClk
f CUT : Filter cutoff frequency
f XCO : Crystal oscillator frequency
ScClk: Switched capacitor filter clock, bits ScClk[4:0]
(bit 0 has a mandatory value of ‘0’).
For instance, for a crystal frequency of 16MHz and if the 6
bit divider divides the input frequency by 4, the cut-off
frequency of the SC filter is 16MHz/(40 x 4) = 100kHz. A
first-order RC low-pass filter removes clock frequency
components from the signal at the switched-capacitor filter
output.
Figure 16. RSSI Voltage
Figure 17. RSSI Network
Figure 16 shows a typical plot of the RSSI voltage as a
function of input power. The RSSI termination network is
shown in Figure 17. The RSSI has a dynamic range of
about 50dB from about -110dBm to -60dBm input power.
When an RF signal is received, the RSSI output increases
and can serve as a signal presence indicator. It could be
used to wake up external circuitry that conserves battery
life while in a sleep mode. Note that RSSI only functions in
Receive mode.
October 2, 2013
25
Revision 2.2
相关PDF资料 |
PDF描述 |
|---|---|
| MICRF600DEV1 | KIT DEV RADIOWIRE 902-928MHZ |
| MK01-C | SENSOR REED SPST-NO SMD |
| MK01-H | SENSOR REED SPDT-CHANGE SMD |
| MK02/0-1A66-500W | SENSOR REED SPST-NO |
| MK02/6-0 | SENSOR REED PCB 24MM T/H |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MICRF600 | 功能描述:TXRX ISM 902-928MHZ 11.5X14.1MM RoHS:否 类别:RF/IF 和 RFID >> RF 收发器 系列:RadioWire® 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:30 系列:- 频率:4.9GHz ~ 5.9GHz 数据传输率 - 最大:54Mbps 调制或协议:* 应用:* 功率 - 输出:-3dBm 灵敏度:- 电源电压:2.7 V ~ 3.6 V 电流 - 接收:* 电流 - 传输:* 数据接口:PCB，表面贴装 存储容量:- 天线连接器:PCB，表面贴装 工作温度:-25°C ~ 85°C 封装/外壳:68-TQFN 裸露焊盘 包装:管件 |
| MICRF600 TR | 制造商:Micrel 功能描述:Micrel MICRF600 TR RF Transceivers |
| MICRF600_06 | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:902-928MHz ISM Band Transceiver Module |
| MICRF600DEV1 | 功能描述:KIT DEV RADIOWIRE 902-928MHZ RoHS:是 类别:RF/IF 和 RFID >> RF 评估和开发套件，板 系列:RadioWire® 标准包装:1 系列:- 类型:GPS 接收器 频率:1575MHz 适用于相关产品:- 已供物品:模块 其它名称:SER3796 |
| MICRF600TR | 制造商:MICREL 制造商全称:Micrel Semiconductor 功能描述:902-928MHz ISM Band Transceiver Module |
发布紧急采购，3分钟左右您将得到回复。