- 您现在的位置：买卖IC网 > PDF目录45360 > MPC8343CVRADDX (FREESCALE SEMICONDUCTOR INC) 32-BIT, 266 MHz, MICROPROCESSOR, PBGA620 PDF资料下载
参数资料
| 型号： | MPC8343CVRADDX |
| 厂商： | FREESCALE SEMICONDUCTOR INC |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 32-BIT, 266 MHz, MICROPROCESSOR, PBGA620 |
| 封装： | 29 X 29 MM, 2.46 MM HEIGHT, 1 MM PITCH, LEAD FREE, PLASTIC, BGA-620 |
| 文件页数： | 9/92页 |
| 文件大小： | 987K |
| 代理商： | MPC8343CVRADDX |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页
MPC8343E PowerQUICC II Pro Integrated Host Processor Hardware Specifications, Rev. 6
Freescale Semiconductor
17
DDR SDRAM
MDQS preamble start
tDDKHMP
-0.25
× t
MCK – 0.9
-0.25
× t
MCK +0.3
ns
7
MDQS epilogue end
tDDKLME
-0.9
0.3
ns
7
Notes:
1.
The symbols used for timing specifications follow the pattern of t(first two letters of functional block)(signal)(state)
(reference)(state) for inputs and t(first two letters of functional block)(reference)(state)(signal)(state) for outputs. Output hold time can
be read as DDR timing (DD) from the rising or falling edge of the reference clock (KH or KL) until the output went
invalid (AX or DX). For example, tDDKHAS symbolizes DDR timing (DD) for the time tMCK memory clock reference
(K) goes from the high (H) state until outputs (A) are setup (S) or output valid time. Also, tDDKLDX symbolizes DDR
timing (DD) for the time tMCK memory clock reference (K) goes low (L) until data outputs (D) are invalid (X) or data
output hold time.
2.
All MCK/MCK referenced measurements are made from the crossing of the two signals ±0.1 V.
3.
In the source synchronous mode, MCK/MCK can be shifted in 1/4 applied cycle increments through the Clock
Control Register. For the skew measurements referenced for tAOSKEW it is assumed that the clock adjustment is set
to align the address/command valid with the rising edge of MCK.
4.
ADDR/CMD includes all DDR SDRAM output signals except MCK/MCK, MCS, and MDQ/MECC/MDM/MDQS.
For the ADDR/CMD setup and hold specifications, it is assumed that the Clock Control register is set to adjust the
memory clocks by 1/2 applied cycle.
5.
Note that tDDKHMH follows the symbol conventions described in note 1. For example, tDDKHMH describes the DDR
timing (DD) from the rising edge of the MCK(n) clock (KH) until the MDQS signal is valid (MH). tDDKHMH can be
modified through control of the DQSS override bits in the TIMING_CFG_2 register. In source synchronous mode,
this will typically be set to the same delay as the clock adjust in the CLK_CNTL register. The timing parameters listed
in the table assume that these 2 parameters have been set to the same adjustment value. See the
MPC8349E
Integrated Host Processor Preliminary Reference Manual Rev.0 for a description and understanding of the
timing modifications enabled by use of these bits.
6.
Determined by maximum possible skew between a data strobe (MDQS) and any corresponding bit of data
(MDQ), ECC (MECC), or data mask (MDM). The data strobe should be centered inside of the data eye at the pins
of the MPC8343E.
7.
All outputs are referenced to the rising edge of MCK(n) at the pins of the MPC8343E. Note that tDDKHMP follows
the symbol conventions described in note 1.
Table 11. DDR SDRAM Output AC Timing Specifications for Source Synchronous Mode (continued)
At recommended operating conditions with GVDD of 2.5 V ± 5%.
Parameter
Symbol 1
Min
Max
Unit
Notes
相关PDF资料 |
PDF描述 |
|---|---|
| MPC8343ZQAGDX | 32-BIT, 400 MHz, MICROPROCESSOR, PBGA620 |
| MPC8343EZQAGDX | 32-BIT, 400 MHz, MICROPROCESSOR, PBGA620 |
| MPC8343ECVRADDX | 32-BIT, 266 MHz, MICROPROCESSOR, PBGA620 |
| MPC8343CVRAGDX | 32-BIT, 400 MHz, MICROPROCESSOR, PBGA620 |
| MPC8343CZQAGDX | 32-BIT, 400 MHz, MICROPROCESSOR, PBGA620 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| MPC8343CVRAGD | 功能描述:IC MPU PWRQUICC II PRO 620-PBGA RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:MPC83xx 标准包装:1 系列:MPC85xx 处理器类型:32-位 MPC85xx PowerQUICC III 特点:- 速度:1.2GHz 电压:1.1V 安装类型:表面贴装 封装/外壳:783-BBGA，FCBGA 供应商设备封装:783-FCPBGA（29x29） 包装:托盘 |
| MPC8343CVRAGDB | 功能描述:微处理器 - MPU 8347 PBGA NO-PB W/O ENCR RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324 |
| MPC8343CZQADD | 功能描述:IC MPU PWRQUICC II PRO 620-PBGA RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:MPC83xx 标准包装:1 系列:MPC85xx 处理器类型:32-位 MPC85xx PowerQUICC III 特点:- 速度:1.2GHz 电压:1.1V 安装类型:表面贴装 封装/外壳:783-BBGA，FCBGA 供应商设备封装:783-FCPBGA（29x29） 包装:托盘 |
| MPC8343CZQADDB | 功能描述:微处理器 - MPU 8347 PBGA W/O ENC W/ PB RoHS:否 制造商:Atmel 处理器系列:SAMA5D31 核心:ARM Cortex A5 数据总线宽度:32 bit 最大时钟频率:536 MHz 程序存储器大小:32 KB 数据 RAM 大小:128 KB 接口类型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作电源电压:1.8 V to 3.3 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:FBGA-324 |
| MPC8343CZQAGD | 功能描述:IC MPU PWRQUICC II PRO 620-PBGA RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微处理器 系列:MPC83xx 标准包装:1 系列:MPC85xx 处理器类型:32-位 MPC85xx PowerQUICC III 特点:- 速度:1.2GHz 电压:1.1V 安装类型:表面贴装 封装/外壳:783-BBGA，FCBGA 供应商设备封装:783-FCPBGA（29x29） 包装:托盘 |
发布紧急采购，3分钟左右您将得到回复。